Product ID:ARON ALPHA CE 480 ADHESIVE
MSDS Date:04/12/1993
FSC:6520
NIIN:00F002905
MSDS Number: BBLYQ

Emergency Phone: 312-735-0601

Info Phone: 800-621-0381

Cage: 67532

Telephone: 800-621-0381

Cage: 67532

ETHYL-2-CYANOACRYLATE *93-1*

CAS: 7085-85-0

Fraction By Weight: >95%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN: EXPOSURE WILL CAUSE RAPID
POLYMERIZATION WITH HEAT WHICH CAN CAUSE BURNS. SKIN BONDING WILL
OCCUR. INHALATION: VAPOR CONCENTRATIONS CAN INDUCE NASAL MUCOUS,
HEADACHE & GIDDINESS. EYES: VAPORS CA N CAUSE IRRITATION & MILD
LACHRYMATION.
Explanation of Carcinogenicity:NONE

First Aid:SKIN: SOAK IN NAIL POLISH REMOVER OR ACETONE. EYES: FLUSH
W/WATER FOR 15 MINS. INHALATION: REMOVE TO FRESH AIR. OBTAIN
MEDICAL ATTENTION IN ALL CASES.

Flash Point Method:TCC
Flash Point:181F
Lower Limits:1.7%
Extinguishing Media:DRY CHEMICAL OR CO2
Fire Fighting Procedures:USE SCBA & PROTECTIVE CLOTHING
Unusual Fire/Explosion Hazard:ADHESIVE ABSORBED INTO MATERIALS MAY
UNDERGO POLYMERIZATION & CAUSE AN INCREASE IN TEMPERATURE THAT
COULD RESULT IN AUTOIGNITION.

Spill Release Procedures:ELIMINATE IGNITION SOURCES. ABSORB SPILL
W/SAND OR ABSORBENT MATERIAL & PLACE IN A CLOSED METAL CONTAINER
W/WATER FOR DISPOSAL. CLOTHS CONTAINING ADHESIVE MAY UNDERGO
AUTOIGNITION. IMMERSE CLOTHS USED FOR CLEAN UP IN WATER.

Other Precautions:AVOID CONTACT W/EYES, SKIN & CLOTHING. KEEP OUT OF
REACH OF CHILDREN. AVOID BREATHING OF VAPORS.

Respiratory Protection:NOT NECESSARY IF GOOD VENTILATION IS MAINTAINED.
Ventilation:MECHANICAL (GENERAL): RECOMMENDED
Protective Gloves:RECOMMENDED
Eye Protection:SAFETY GLASSES
Supplemental Safety and Health

Boiling Pt:B.P. Text:149F
Melt/Freeze Pt:M.P/F.P Text:-22F
Vapor Pres:0.17
Vapor Density:4.34
Spec Gravity:1.05
Evaporation Rate & Reference:(BU AC = 1): 0.15
Solubility in Water:INSOLUBLE
Appearance and Odor:CLEAR, COLORLESS LIQUID WITH PUNGENT ODOR.

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIAL
Stability Condition to Avoid:HIGH TEMPERATURE, HIGH HUMIDITY OR UV
RADIATION
Hazardous Decomposition Products:CO2, CO & OXIDES OF NITROGEN
Conditions to Avoid Polymerization:WATER, PEROXIDES & ACIDIC & BASIC
MATERIALS.

Waste Disposal Methods:INCINERATE ADHESIVE & ABSORBENT IN ACCORDANCE
W/FEDERAL, STATE & LOCAL REGULATIONS.

======================================================================
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.