BCMTK - PLEXIGLAS,ACRYLIC MOLDING PELLETS
- MSDS: BCMTK
- Manufacturer: ROHM AND HAAS COMPANY
- Product Name: PLEXIGLAS,ACRYLIC MOLDING PELLETS
- National Stock Number: 6850-00N006437
Product Identification
Product ID:PLEXIGLAS,ACRYLIC MOLDING PELLETS
MSDS Date:01/01/1985
FSC:6850
NIIN:00N006437
MSDS Number: BCMTK
Responsible Party
Emergency Phone: 215-592-3000
Cage: FO048
Contractor
Telephone: 215-592-2521/215-592-3000
Cage: 77902
Ingredients
METHYL METHACRYLATE (SARA III)
CAS: 80-62-6
RTECS: OZ5075000
Fraction By Weight: TRAC
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM; 9192
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
ACRYLIC POLYMER
Fraction By Weight: 100%
Hazards
Effects of Overexposure:EYE: IRRITATION. VAPOR: IRRITATION, NAUSEA,
HEADACHE & DIZZINESS
First Aid
First Aid:EYE: FLUSH WITH WATER 15 MINUTES. INHALATION: REMOVE TO FRESH
AIR.
Fire Fighting
Flash Point:740F/393C
Extinguishing Media:CO*2,DRY CHEMICAL,WATER SPRAY
Fire Fighting Procedures:SELF-CONTAIN BREATH APP, FULL PROTECTIVE
EQUIPMENT
Unusual Fire/Explosion Hazard:PRODUCT IS COMBUSTIBLE THERMOPLASTIC
RESIN,BURNS VIGOROUSLY WITH INTENSE HEAT.
Accidental Release
Spill Release Procedures:FLOOR MAY BE SLIPPERY; USE CARE TO AVOID
FALLING.
Handling
Handling and Storage Precautions:STORE AT AMBIENT TEMPS.
Other Precautions:LOW LEVELS OF MONOMER VAPORS MAY BE GENERATED WHEN
THIS MATERIAL IS HEATED DURING PROCESSING.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESP DEVICE IN ACCORD WITH
EXPOSURE OF CONCERN.
Ventilation:LOCAL/MECHANICAL
Protective Gloves:COTTON/CANVAS
Eye Protection:SAFTY GLASSES W/SIDE SHIL
Other Protective Equipment:EYEWASH FACILITY
Supplemental Safety and Health
Chemical Properties
Spec Gravity:1.17
Solubility in Water:NEGLIGIBLE
Appearance and Odor:SOLID PELLETS;MILD ODOR
Percent Volatiles by Volume:0
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, BASES, OXIDIZING AGENTS
Stability Condition to Avoid:TEMP ABOVE 500F/260C
Hazardous Decomposition Products:ACRYLIC MONOMERS
Disposal
Waste Disposal Methods:COMPLY WITH LOCAL, STATE AND FEDERAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.