BDBSZ - 02-Y-24 CTLST,YELLOW,EPOXY POLYAMIDE PRIMER
- MSDS: BDBSZ
- Manufacturer: DEFT CHEMICAL COATINGS
- Product Name: 02-Y-24 CTLST,YELLOW,EPOXY POLYAMIDE PRIMER
- National Stock Number: 8010-00-142-9279
Product Identification
Product ID:02-Y-24 CTLST,YELLOW,EPOXY POLYAMIDE PRIMER
MSDS Date:01/01/1985
FSC:8010
NIIN:00-142-9279
Kit Part:Y
MSDS Number: BDBSZ
Responsible Party
IRVINE, CA 92714-6205
US
Emergency Phone: NONE
Cage: EO418
Contractor
Telephone: 949-474-0400
Cage: 33461
Ingredients
N-BUTYL ALCOHOL (SARA III)
CAS: 71-36-3
RTECS: EO1400000
Fraction By Weight: 20.0%
OSHA PEL 100 PPM
ACGIH TLV: S, C 50 PPM; 9293
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
Hazards
Effects of Overexposure:EYES:MODERATE IRRIT;SKIN:POSSIBLE IRRIT BY
SOLVENTS;INH:SOLVENT VAPORS CAN CAUSE IRRIT OR NARCOSIS
First Aid
First Aid:SKIN:WIPE OFF WITH A RAG THEN THOROUGH RINSING W/H*2O &
WASHING W/MILD SOAP AND WATER;EYES:FLUSH W/WATER FOR AT LEAST 10
MIN & CONSULT AN EYE PHYSICIAN;INH:REMOVE TO FRESH AIR.GIVE
CPR/OXYGEN IF NEEDE D.
Fire Fighting
Flash Point:20F(-6.6C)-TOC
Lower Limits:1.7
Extinguishing Media:CO*2,DRY CHEM,FOAM
Fire Fighting Procedures:DO NOT USE H*2O STREAM ON FIRE.H*2O SPRAY/FOG
IS MORE EFFCTV
Unusual Fire/Explosion Hazard:CAUTION AGAINST APPLICATION TO HOT
SURFACES & USE IN AREAS WHERE SOURCES OF IGNITION MAY BE PRESENT.
Accidental Release
Spill Release Procedures:EVACUATE UNPROTECTED PERSONS.ELIM IGN
SOURCES.USE SAFETY EQUIP.VENTLATE AREA.STOP LEAK W/O RISK.ABSORB SM
SPILL W/OIL ABSORBNG COMPD/RAGS;DIKE LG SPILL.PUMP LIQ TO SALVAGE
TANK.SHOVEL UP RESIDUE INTO COVRD DRUMS;PER MFR,FLUSH AREA W/LG
AMOH*2O.
Handling
Handling and Storage Precautions:STORE IN COOL,DRY WELL VENTILATED,LOW
FIRE RISK AREA.KEEP CONTNRS TIGHTLY CLOSED.KEEP AWAY FM HEAT,SPARK
OR OPEN FLAME.
Other Precautions:AVOID PROLONGED INHALATION OF VAP.PER MFR,WATER SPRAY
OR FOG CAN BE USED EFFECTIVELY ON FIRE AND TO COOL HEAT/FIRE
EXPOSED CONTNRS.
Exposure Controls
Respiratory Protection:GOOD VENTILATION IS NEEDED HOWEVER USE NIOSH
APPRVD SCBA FOR PAINTS.
Ventilation:USE ADEQUATE VENTILATION USING EXHAUST FAN.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY/CHEM GOGGLES.
Other Protective Equipment:AS REQD TO PREVENT PROLONGED OR REPEATED
CONTACT.
Supplemental Safety and Health
TWO PART KIT. THIS IS CATALYST. SEE P/N IND "A" FOR BASE; ALSO SEE
P/N IND "B" FOR OTHER HAZ INGREDIENTS; MIL SPEC REFEENCE:
MIL-P-23377D, TYPE 1. KEY1:J1.
Chemical Properties
HCC:F2
Boiling Pt:B.P. Text:175-331F
Vapor Density:>1.0
Spec Gravity:0.8484
Evaporation Rate & Reference:<1(SLWR THAN ETHR)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR THIN LIQUID,ODOR OF MEK
Percent Volatiles by Volume:82.3
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZING & CORROSIVE MATERIALS.
Stability Condition to Avoid:SOURCE OF IGN,SPARK,HEAT & OPEN FLAME
Disposal
Waste Disposal Methods:KEEP IN CLOSED CONTNRS PENDING DISPOSAL.MFR
SUGGESTED,DISPOSE IN TIGHTLY CLOSED CONTAINERS & FINALLY DISPOSE BY
SANITARY LANDFILL IAW APPLICABLE REGS;HANDLE & DISPOSE IN FULL
COMPLIANCE W/ALL FED,STAT E,& LOCAL REGULATIONS CONCERNING WASTE
DISPOSAL
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.