Product ID:ENAMEL, ALKYD, GLOSS 742624
MSDS Date:03/23/1988
FSC:8010
NIIN:00-526-2856
MSDS Number: BFCNV

PRATT & LAMBERT, INC.-INDUSTRIAL COATINGS DIV.

16116 E 13TH ST
WICHITA, KS 67201
US

Preparer: W. A. ELLISON

Cage: FO127

PRATT AND LAMBERT INC

22 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

VM&P NAPHTHA (LIGROINE)

CAS: 8032-32-4

RTECS: OI6180000

OSHA PEL 300 PPM/400 STEL

ACGIH TLV: 300 PPM; 9192

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

MINERAL SPIRITS

CAS: 64475-85-0

RTECS: PY8240000

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:REPORTS HAVE ASSOCIATED PROLONGED AND
REPEATED OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN
AND NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING AND INHALING THE C ONTENTS MAY BE HARMFUL OR FATAL.
Effects of Overexposure:GASTROINTESTINAL IRRITATION, NAUSEA AND
VOMITING. ASPIRATION OF MATERIAL INTO LUNG CAN CAUSE CHEMICAL
PNEUMONITIS WHICH CAN BE FATAL. INHALE-MAY CAUSE NOSE OR THROAT
IRRITATION. EYE-MAY CAUSE EYE IRRI TATION. SKIN-MAY CAUSE DEFATTING
AND IRRITATION OF THE SKIN.

First Aid:SWALLOWED-DO NOT INDUCE VOMITING. CALL POISON CONTROL CENTER,
HOSPITAL EMERGENCY OR MD IMMED.INHALED-REMOVE TO FRESH AIR IMMED.IF
BREATHING HAS STOPPED, GIVE ARTIFICIAL RESPIRATION.KEEP WARM AND
QUIET ,GET MED ATTN IMMED.EYE-FLUSH WITH LARGE AMTS OF
WATER.CONTINUE FOR AT LEAST 15 MIN.GET MED ATTN.SKIN-REMOVE
CONTAMINATED CLOTHING. WASH AFFECTED AREA WITH SOAP & WATER.MED
ATTN IF IRRITATION PERSISTS

Flash Point:102F - 39C
Extinguishing Media:NFPA CLASS B FIRE EXTINGUISHER DESIGNED TO
EXTINGUISH FLAMMABLE LIQUID FIRES. POLYMER FOAM PREFERRED FOR LARGE
FIRES.
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS. WATER
MAY BE INEFFECTIVE, BUT MAY BE USED TO PREVENT PRESSURE BUILD-UP.
IF WATER IS USED, FOG NOZZLEA ARE PREFERABLE.
Unusual Fire/Explosion Hazard:DURING EMERGENCY CONDITIONS, OVEREXPOSURE
TO DECOMP PRODUCTS MAY CAUSE A HEALTH HAZARD.OBTAIN MED ATTN.KEEP
CONTAINERS CLOSED.ISOLATE FROM HEAT,ELECT EQUIP,ETC.

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIM ALL IGNITION
SOURCES. DIKE & CONTN SPILL WITH INERT MATL. TR LQDS TO COV MTL
CNTNR FOR RECOV OR DISP OR REM W/INERT ABSORB.USE NON-SPRKG TOOLS.
PLACE ABSORB MAT IN COV METAL CONTNR FOR DISP. PREVENT CONTAM OF
SEW, STRMS,ETC

Handling and Storage Precautions:DO NOT STORE ABOVE 95 DEGREES F. STORE
LARGE QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER EACH
USE. DO NOT WASH AND RE-USE CONTAINERS FOR ANY PURPOSE. DO NOT
WELD, BRAZE OR CUT ON EMPTY CONTAINER. NEVER USE PRESSURE TO EMPTY.

Respiratory Protection:RESPIR PROTECT NOT REQUIRED IF USED IN WELL
VENTIL AREA.RESTRICTED VENTIL AREA-A NIOSH APPROVED CHEM CART
RESPIR MAY BE REQUIRED.WHEN SPRAYING-A MECHANICAL PREFILTER MAY
ALSO BE REQUIRED.CONFINED AREA -A NIOSH/MSHA APPRVD AIR SUPPLIED
RESPIR
Ventilation:PROVIDE GENERAL DILUTION & LOCAL EXHAUST VENTILATION.REMOVE
DECOMP PROD GENERATED WHEN WELD,CUT OR BRAZING COATED PROD.
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:WEAR SAFETY SPECTACLES
Other Protective Equipment:NOT LIKELY TO BE NEEDED
Supplemental Safety and Health
SOLVENT IMPERMEABLE GLOVES ARE REQUIRED FOR REPEATED OR PROLONGED
CONTACT.

HCC:F4
Boiling Pt:B.P. Text:280F - 388F
Vapor Pres:2
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:59

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING, INCLUDING WHEN HEATED BY
WELDING OR CUTTING, WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON
DIOXIDE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT, SPARKS AND
FLAME.

Waste Disposal Methods:IAW FED, STATE & LOCAL LAWS. INCINERATE ONLY IN
EPA PERMITTED FACILITY. DO NOT INCINERATE CLOSED CONTAINERS.
OBSERVE PRECAUTIONS FOR DISPOSAL OF FLAMMABLE MATERIALS.
CONTAMINATED ABSORBANT MAY BE DISP OSED IN A HAZARDOUS WASTE
LANDFILL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.