BFHSS - SILICONE FLUID ST-22(10)
- MSDS: BFHSS
- Manufacturer: SIL TECH CORP
- Product Name: SILICONE FLUID ST-22(10)
- National Stock Number: 9150-00-607-0897
Product Identification
Product ID:SILICONE FLUID ST-22(10)
MSDS Date:01/01/1987
FSC:9150
NIIN:00-607-0897
MSDS Number: BFHSS
Responsible Party
Emergency Phone: 517-423-3113
Cage: LO684
Contractor
Telephone: 517-423-3113
Cage: 4Y322
Ingredients
POLYDIMETHYLSILOXANE TLV FOR OIL MIST
CAS: 9016-00-6
RTECS: TQ2690000
Fraction By Weight: >90%.
ACGIH TLV: 5 MG/CUM (MIST)
Hazards
Effects of Overexposure:EYES/SKIN:MAY IRRITATE; USE PERSONAL
PROTECTION; TOXICITY & IRRITATION CONSIDERED TO BE LOW.
First Aid
First Aid:SKIN:WASH WITH SOAP AND WATER. EYES: FLUSH WITH WATER.
INHALED: REMOVE TO FRESH AIR. REMOVE CONTAMINATED CLOTHING.
Fire Fighting
Flash Point:>253.4F/>123C PM
Extinguishing Media:WATER SPRAY, (FOG), CARBON DIOXIDE, DRY CHEMICAL
Fire Fighting Procedures:SELF-CNTD BREATHNG APP.,PROTECTIVE EQUIP. IN
CHEMICAL FIRES
Unusual Fire/Explosion Hazard:NONE
Accidental Release
Spill Release Procedures:USE PROPER PERSONAL PROTECTION. ABSORB &
COLLECT FOR PROPER DISPOSAL.
Handling
Handling and Storage Precautions:STORE IN COOL, DRY & WELL VENTILATED
AREA. KEEP CONTAINER TIGHTLY CLOSED, WHEN NOT IN USE.
Other Precautions:AVOID CONTACT W/SKIN & EYES. DO NOT USE CONTAMINATED
CLOTHES.
Exposure Controls
Respiratory Protection:USE NIOSH APPROVED RESPIRATOR FOR OIL MIST,IF
NEEDED.
Ventilation:MECH(GEN)OR LOCAL EXHAUST THAT PROVIDES ADEQUATE
VENTILATION
Protective Gloves:TYPE AS REQD
Eye Protection:SAFETY/CHEM GOGGLES
Other Protective Equipment:SAFETY SHOWER & EYE BATH
Supplemental Safety and Health
MSDS DATE:UNDATED
Chemical Properties
HCC:V6
Spec Gravity:0.935
Viscosity:10 CST @ 70F
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR,COLORLESS,ODORLESS LIQUID
Percent Volatiles by Volume:NIL
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:MFR SPECIFIES NONE
Hazardous Decomposition Products:MFR LISTS NONE; EXPECT OXIDES OF
CARBON & SILICONE
Conditions to Avoid Polymerization:WILL NOT POLYMERIZE
Disposal
Waste Disposal Methods:INCINERATE OR BURY IAW FEDERAL, STATE & LOCAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.