Product ID:ENAMEL, INTERIOR/EXTERIOR,GLOSS,WHITE 17875
MSDS Date:03/11/1991
FSC:8010
NIIN:00-286-7745
MSDS Number: BJFDN

PRATT & LAMBERT INC., INDUSTRIAL COATINGS DIV.

WICHITA, KS 67201
US

Emergency Phone: 800-255-3924

Info Phone: 316-733-1361

Preparer: W. A. ELLISON

Cage: PRATT

PRATT AND LAMBERT INC

2153 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

MINERAL SPIRITS (SOLVENT) (VAPOR PRESSURE 2 MM HG @ 20C)

CAS: 64742-88-7

Fraction By Weight: 30%

OSHA PEL 100 PPM/ 525 MG/M3

ACGIH TLV: 100 PPM/ 525 MG/M3

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 25%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

3.25 LB/GL LESS WATER & NPRS*; 390 G/L LESS WATER;

RTECS: 9999999VO

6.48 LB/GAL SOLIDS; 778 G/L SOLIDS; CALCULATED

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST/INHALE/EYE/SKIN: IRRITATION
(GASTROINTESTINAL, NOSE, THROAT, EYE, SKIN). LUNG ASPIRATION MAY
CAUSE CHEMICAL PNEUMONITIS, WHICH CAN BE FATAL. CENTRAL NERVOUS
SYSTEM DEPRESSION. SKIN DEFATTING. O VEREXPOSURE: SOLVENTS ARE
ASSOCIATED WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE.
Effects of Overexposure:INGEST: NAUSEA/VOMITING. INHALE: HEADACHES,
DIZZINESS, NAUSEA, CONFUSION.

First Aid:INGEST: DO NOT INDUCE VOMITING. CALL POISON CONTROL,
EMERGENCY ROOM OR PHYSICIAN IMMEDIATELY. INHALE: REMOVE TO FRESH
AIR IMMEDIATELY. GIVE ARTIFICIAL RESPIRATION IF NEEDED. KEEP WARM &
QUIET. GET IMM EDIATE MEDICAL AID. EYE: FLUSH THOROUGHLY WITH LARGE
AMOUNT OF WATER FOR 15 MIN. GET MEDICAL AID. SKIN: REMOVE
CONTAMINATED CLOTHES. WASH AFFECTED AREA WITH SOAP & WATER.
PERSISTANT IRRIT GET MED AID.

Flash Point:>108F,>42C
Autoignition Temp:Autoignition Temp Text:572F
Lower Limits:1.0
Upper Limits:7.0
Extinguishing Media:USE NFPA CLASS B(CO2, ALL PURPOSE DRY CHEMICAL OR
ALCOHOL FOAM) FOR LIQUID FIRES. POLYMER FOAM PREFERRED FOR LARGE
FIRES
Fire Fighting Procedures:WATER MAY BE INEFFECTIVE, USE TO COOL
CONTAINERS (FOG NOZZLE PREFERABLE) TO PREVENT PRESSURE BUILD-UP &
AUTO- IGNITION OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT
Unusual Fire/Explosion Hazard:DURING EMERGENCY CONDITIONS, OVEREXPOSURE
TO DECOMPOSITION PRODUCTS MAY CAUSE A HEALTH HAZARD. SYMPTOMS MAY
NOT BE IMMEDIATELY APPARENT. GET MEDICAL ATTENTION.

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIMINATE ALL IGNITE
SOURCES. DIKE, CONTAIN & REMOVE WITH INERT MATERIAL (SAND, EARTH,
ETC). USE COVERED METAL CONTAINERS FOR RECOVERY AND DISPOSAL. USE
NON-SPARKING TOOLS. PREVE NT CONTAMINATION OF SEWERS, STREAMS &
GROUNDWATER.

Handling and Storage Precautions:DO NOT STORE ABOVE 100F. LARGE
QUANTITY STORAGE: COMPLY WITH OSHA 29CFR1910.106. DO NOT TAKE
INTERNALLY. DO NOT REUSE CONTAINERS FOR ANY PURPOSE.
Other Precautions:CONTAINERS SHOULD BE GROUNDED AND BONDED TO THE
RECEIVING CONTAINER. DO NOT WELD, BRAZE OR CUT ON EMPTY CONTAINER.
NEVER USE PRESSURE TO EMPTY. DRUM IS NOT A PRESSURE VESSEL. KEEP
CONTAINERS CLOSED WH EN NOT IN USE.

Respiratory Protection:RESTRICTED AREA: NIOSH APPR'D CHEMICAL CARTRIDGE
RESPIRATOR. SPRAYING: MECHANICAL PREFILTER MAY BE REQUIRED.
CONFINED AREAS: NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR.
EXCEEDED TLV AREA: NIOSH/MSHA APPROVED RESPIRATOR W/RIGHT FACTOR.
Ventilation:GENERAL DILUTION/LOCAL EXHAUST VENTILATION IN SUFFICIENT
VOLUME & PATTERN TO KEEP CONCENTRATIONS BELOW EXPOSURE LIMITS.
Protective Gloves:REPEAT/PROLONG USE: IMPERMEABLE GLOVES.
Eye Protection:SAFETY SPECTACLES.
Other Protective Equipment:NOT LIKELY TO BE NEEDED.
Supplemental Safety and Health

HCC:F4
Boiling Pt:B.P. Text:277 TO 388F
Melt/Freeze Pt:M.P/F.P Text:-50F,-46C
Decomp Temp:Decomp Text:1832F,1000C
Vapor Pres:2
Vapor Density:> THAN AIR
Spec Gravity:1.2
pH:4-7
Viscosity:70-80 KU
Evaporation Rate & Reference:SLOWER THAN DIETHYL ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:49

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESS HEAT (>100F) & IGNITION
SOURCES.
Hazardous Decomposition Products:BURNING,INCLUDING HEATED BY WELDING OR
CUTTING WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON DIOXIDE.

Waste Disposal Methods:FOLLOW FEDERAL, STATE AND LOCAL REGULATIONS &
LAWS. INCINERATE IN EPA PERMITTED FACILITY. DO NOT INCINERATE
CLOSED CONTAINERS. USE PRECAUTIONS FOR DISPOSAL OF HAZARDOUS
MATERIAL-D001. USE HAZARDOUS WA STE LANDFILL FOR USED ABSORBENT.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.