Product ID:V 74712 TTS711C MAPLE STAIN
MSDS Date:02/06/1990
FSC:8010
NIIN:00-281-2077
MSDS Number: BJKMQ

KALCOR COATINGS COMPANY

37721 STEVENS BLVD.
WILLOUGHBY, OH 44094
US

Emergency Phone: 216-381-5614

Info Phone: 216-946-4700

Preparer: AFL

Cage: DO396

KALCOR COATINGS COMPANY

WILLOUGHBY, OH 44094 US

Telephone: 800-424-9300 CHEMTREC

Cage: DO396

STODDARD SOLVENT

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 45%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293

VOC. 4.80 LB/GAL (576 G/L)

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:OVEREXPOSURE TO MATERIAL (OR
COMPONENTS) MAY CAUSE HEADACHE, UNCONCSIOUSNESS OR ASPHYXIATION.
CHRONIC: OVEREXPOSURE MAY CAUSE CNS DAMAGE IN LAB ANIMALS. HAS BEEN
SUGGESTED TO CAUSE CNS DAMAGE IN HUMAN S. ASPIRATION OF MATERIAL
INTO LUNGS (DURING SWALLOWING OR VOMITING) MAY CAUSE PNEUMONITIS
WHICH CAN BE FATAL.
Effects of Overexposure:INHALED:NASAL OR RESPIRATORY IRRIT, CENTRAL
NERV SYST DEPRESS, HEADACHE, DIZZ, FATIGUE, LOSS OF COORDINATION,
NAUSEA, UNCONCIOUSNESS OR EVEN ASPHYXIATION. SKIN:IRRIT, REDNESS,
BURNING, DEFATTING, DERM ATITIS, POSSIBLE SKIN ABSORBPT.
EYES:IRRIT, RED, TEARS, BLURRED VISION. INGEST:GASTROINT IRRIT,
NAUSEA, VOMIT, DIARRHEA
Medical Cond Aggravated by Exposure:PREEXISTING EYE, SKIN & RESPIRATORY
DISORDERS MAY BE AGGRAVATED BY EXPOSURE TO THIS PRODUCT.

First Aid:FUMES: REMOVE FROM EXPOSURE. RESTORE BREATHING. KEEP WARM &
QUIET. NOTIFY PHYSICIAN. EYES:FLUSH IMMEDIATELY W/COPIOUS
QUANTITIES OF RUNNING WATER FOR AT LEAST 15 MINS. TAKE TO PHYSICIAN
FOR DEFINITIVE MEDICAL TREATMENT. SKIN: REMOVE W/SOAP& WATER.
REMOVE & LAUNDER CONTAMINATED CLOTHING. IF SWALLOWED, DO NOT INDUCE
VOMITING. KEEP HEAD BELOW HIPS. GET IMMEDIATE MEDICAL ATTENTION.

Flash Point Method:TCC
Flash Point:100 F/38 C
Lower Limits:0.7
Upper Limits:6.0
Extinguishing Media:FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:USE FULL PROTECTIVE EQUIPMENT, INCLUDING SCBA
WITH FULL FACE SHIELD & POSITIVE PRESSURE MODE TO PROTECT
FIREFIGHTERS FROM ANY HAZARDOUS COMBUSTION PRODUCTS.
Unusual Fire/Explosion Hazard:MAY IGNITE BY HEAT, ETC. VAPORS HEAVIER
THAN AIR, MAY TRAVEL ALONG FLOOR TO IGNITE SOURCES AT LOCATIONS
DISTANT FROM HANDLING POINT. CLOSED CONTAIN MAY EXPODE.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION (FLAMES, HOT
SURFACES, ELECTRICAL, STATIC OR FRICTIONAL SPARKS). AVOID BREATHING
VAPORS. DIKE AREA TO PREVENT MATERIAL FROM ENTERING DRAINS OR
SEWERS. REMOVE WITH INERT ABSORBENT.

Handling and Storage Precautions:DON'T STORE ABOVE 120F. KEEP
CONTAINERS TIGHTLY CLOSED. STORE LARGE AMOUNTS IN BLDGS DESIGNED TO
COMPLY W/OSHA 1910.106. KEEP AWAY FROM OPEN FLAMES.
Other Precautions:LISTED PRECAUTIONS APPLY TO EMPTY CONTAINERS. DO NOT
TAKE INTERNALLY. CONTAINERS MUST BE BONDED OR GROUNDED DURING
POURING OR MIXING OPERATIONS. DO NOT CUT, BRAZE OR WELD CURED
COATING WITHOUT RESPIRA TOR OR APPROPRIATE VENTILATION.

Respiratory Protection:IN OUTDOOR/OPEN AREAS USE MECH RESPIRATOR TO
REMOVE SOLID AIRBORNE PARTICLES OF OVERSPRAY. RESTRICTED VENT:USE
CHEM & MECH FILTERS TO REMOVE COMBINATION OF PARICULATE & VAPORS.
CONFINED AREAS:USE AIR LINE TYPE RESPIRATOR OR HOOD.
Ventilation:GEN DILUTE/LOCAL EXHAUST VENT IN VOL/PATTERN TO KEEP TLV OF
HAZARD INGRED BELOW LIMITS. HEAVY VAPORS SHOULD BE REMOVED
Protective Gloves:PROLONGED/REPEATED USE-IMPERVIOUS GLOVES
Eye Protection:SAFETY EYEWEAR, DO NOT WEAR CONTACTS.
Other Protective Equipment:AVOID PROLONGED CONTACT WITH CONTAMINATED
CLOTHING. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE SMOKING OR EATING. OBSERVE
ACCEPTED GOOD HYGIENE PRACTICES.
Supplemental Safety and Health
IF THIS PRODUCT IS REPACKAGED OR OTHERWISE REDISTRIBUTED, THE RECIPIENT
MUST BE INFORMED OF THE SARA 313 INFORMATION (IF ANY) LISTED.

Boiling Pt:B.P. Text:300F,149C
Vapor Density:> THAN AIR
Spec Gravity:1.0 (H2O=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NEGLIGIBLE
Appearance and Odor:VISCOUS LIQUID-HYDROCARBON ODOR.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE ESTABLISHED.
Hazardous Decomposition Products:HEATING MAY CAUSE THIS MATERIAL TO
DECOMPOSE. TOXIC FUMES SUCH AS CO, CO2 OR VARIOUS HYDROCARBONS MAY
BE PRODUCED.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE &
FEDERAL REGULATIONS. DO NOT INCINERATE CLOSED CONTAINERS. BEFORE
ATTEMPTING CLEAN-UP, REFER TO HAZARD CAUTION INFORMATION IN OTHER
SECTIONS OF THIS SHEET.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.