Product ID:EPOXY THINNER, X-6272
MSDS Date:03/06/1989
FSC:8010
NIIN:00N021892
MSDS Number: BLMNX

FARWEST PAINT MFG CO

4522 S 133RD ST
TUKWILA, WA 98168
US

Emergency Phone: 206-941-1619

Info Phone: 206-244-8844

Cage: 6F266

FARWEST PAINT MANUFACTURING CO

TUKWILA, WA 98168 US

Telephone: 206-244-8844

Cage: 6F266

355-L/HI FLASH AROMATIC HYDROCARBON

Fraction By Weight: 50%

ACGIH TLV: 100 PPM (MFR)

ISOBUTYL ALCOHOL (SARA III)

CAS: 78-83-1

RTECS: NP9625000

Fraction By Weight: 50%

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

CONTROLS SHOULD BE IMPLEMENTED TO REDUCE

RTECS: 9999999ZZ

EARTH, FLOOR ABSORBENT, OR OTHER ABSORBENT MATL.

RTECS: 9999999ZZ

WATER. IF RUN-OFF OCCURS, NOTIFY PROPER AUTHORITIES

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE: CAN CAUSE SEVERE IRRIT, REDNESS,
TEARING, BLURRED VISION. SKIN: PRLNGD/RPTD CONT CAN CAUSE MODERATE
IRRIT, DEFAT, DERMAT. INHAL: EXCESS INHAL OF VAPS CAN CAUSE NASAL &
RESP IRRIT, DIZZ, WEAKNESS, FATIGUE, NAUS, HDCH, POSS UNCON &
EVENASPHY. INGEST: CAN CAUSE GI IRRIT, NAUS, VOMIT & DIARR. (SEE
EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: ASPIR OF MATL IN LUNGS CAN CAUSE CHEM
PNEUM WHICH CAN BE FATAL.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:SKIN:THORO WASH EXPSD AREA W/SOAP & WATER. REMOVE CONTAM
CLTHG.LAUNDER CONTAM CLTHG BEFORE RE-USE.EYES:FLUSH W/LRG AMTS OF
WATER, LIFTING UPPER & LOWER LIDS OCCASNLY, GET MD.INGEST:DO NOT
INDUCE VOMIT , KEEP PERSON WARM, QUIET, AND GET MD.ASPIR OF MATL IN
LUNGS DUE TO VOMIT CAN CAUSE CHEM PNEUM WHICH CAN BE
FATAL.INHAL:REMOVE INDIV TO FRESH AIR. IF BRTHG IS DFCLT, ADMIN
OXYGEN. IF (SUPP DATA)

Flash Point Method:TCC
Flash Point:85.0F,29.4C
Lower Limits:0.9%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NEVER USE NEAR OR AROUND WELDERS OR
CUTTING TORCHES. DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST
RESIDUE) CAN IGNITE EXPLOSIVELY.

Spill Release Procedures:SM SPILL: ABSORB LIQ ON PAPER, VERMICULITE,
FLOOR ABSORB/OTHER ABSORB MATL & TRANSFER TO HOOD. LRG SPILL: ELIM
ALL IGNIT SOURCES (FLARES, FLAMES, INCL PILOT LIGHTS, ELEC SPARKS).
PERSONS NOT WEARING P ROT EQUIP SHOULD BE EXCLUDED FROM AREA (SUPP
DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:CONTAINERS OF THIS MATL MAY BE HAZ
WHEN EMPTIED, SINCE EMPTIED CNTNRS RETAIN PROD RESIDUES (VAP, LIQ,
AND/OR SOLID) , ALL HAZ PREC MUST BE OBSERVED.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED, A
NIOSH/ MSHA APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE OF
PROPER ENVIRON CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH/MSHA
APPRVD RESP UNDER SPECIFIED CND TNS. ENGINEERING/ADMIN (SEE ING 3)
Ventilation:PROVIDE SUFF MECH (GENERAL AND/OR LOCAL EXHST) VENT TO
MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:NITRILE RUBBER.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:KEEP WORK AREA CLEAN & FREE FROM LEAKS &
SPILLS. ALWAYS WASH HANDS THORO W/SOAP & WATER BEFORE HNDLG FOOD &
DRINK.
Supplemental Safety and Health
FIRST AID PROC: BRTHG IS DIFFICULT. ADMINISTER OXYGEN. IF BRTHG STOPS,
GIVE ARTF RESP. KEEP PERSON, QUIET AND GET MD. SPILL PROC: OF SPILL
UNTIL CLEAN-UP HAS BEEN COMPLETED. STOP SPILL AT SOURCE, DIKE AREA
OF SPILL TO PVNT SPREADING, PUMP LIQ TO SALVAGE TANK. REMAINING LIQ
MAY BE TAKEN UP ON SAND, CLAY, (SEE ING 4)

HCC:F4
Boiling Pt:B.P. Text:226F,108C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:0.82
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:CLEAR, WATER WHITE LIQUID WITH SWEET ALCOHOL ODOR.
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM OPEN FLAMES, SPARKS AND
HEAT. DO NOT WELD NEAR OR AROUND PRODUCT.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DESTROY BY LIQUID INCINERATION. CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN A LANDFILL IN ACCORDANCE WITH LOCAL,
STATE AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.