Product ID:I LUX SPECIAL THINNER, 216
MSDS Date:05/02/1990
FSC:8010
NIIN:00N026215
MSDS Number: CBBNX

INTERNATIONAL PAINT

2270 MORRIS AVE
UNION, NJ 07083-5704
US

Emergency Phone: 713-682-1711

Info Phone: 713-682-1711

Cage: 26351

INTERNATIONAL PAINT INC

HOUSTON, TX 77091 US

Telephone: 800-589-1267/800-854-6813

Cage: 26351

10.0 MM HG @ 20C

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 95-100%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM/150STEL

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: CAN CAUSE IRRITATION WITH
REDNESS, TEARING AND BLURRED VISION. SKIN: IRRITATING. MAY RESULT
IN DERMATITIS. INHALATION: IRRITATION OF RESPIRATORY TRACT.
HEADACHE, DIZZINESS AND UNCONSCIOUS NESS. INGESTION:
GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING AND DIARRHEA.
CHRONIC: OVEREXPOSURE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: TO, AND MISUSE OF, SOLVENTS HAS BEEN
LINKED TO PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE.
Medical Cond Aggravated by Exposure:SKIN AND RESPIRATORY CONDITIONS.

First Aid:EYES: FLUSH IMMEDIATELY WITH COPIOUS QUANTITIES OF WATER FOR
AT LEAST 15 MINUTES. GET MEDICAL ATTENTION IMMEDIATELY. SKIN:
REMOVE CONTAMINATED CLOTHING. WASH SKIN WITH PLENTY OF SOAP AND
WATER. LAUNDE R CLOTHES BEFORE REUSE. INHALATION: REMOVE TO FRESH
AIR. GIVE ARTIFICIAL RESPIRATION IF NEEDED. GET MEDICAL ATTENTION.
INGESTION: CALL MD IMMEDIATELY TO DETERMINE WHETHER OR NOT TO
INDUCE VOMITING.

Flash Point Method:SCC
Flash Point:80.0F,26.7C
Lower Limits:1.0%
Extinguishing Media:USE FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. SMOTHER FLAMES W/ONE OF THE ABOVE EXTING MEDIA. WATER MAY BE USED
TO COOL UNOPENED CONTRS, BUT (SUP DAT)
Unusual Fire/Explosion Hazard:CONTAINS FLAMMABLE SOLVENT. DO NOT USE IN
AREAS WHERE SPARK OR OPEN FLAME ARE PRESENT.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. AVOID
INHALATION OF VAPORS. VENTILATE AREA. CLEAN UP WITH ABSORBENT
MATERIALS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN BUILDINGS DESIGNED AND
PROTECTED FOR STORAGE OF LIQUIDS WITH NFPA CLASS.
Other Precautions:AVOID BREATHING DUST OR CHIPS FROM SANDING OR
BLASTING SURFACES COATED WITH THIS PRODUCT.

Respiratory Protection:IN OUTDOOR/OPEN AREAS, W/UNRESTRICTED VENT, USE
NIOSH/MSHA APPRVD FILTER RESP TO REMOVE SOLID AIRBORNE PARTICLES OF
OVERSPRAY DURING SPRAY APPLICATION. IN RESTRICTED VENT AREAS, USE
NIOSH/MSHA APPRVD RESP I/A/W 29 CFR 1910.134 TO (SUP DAT)
Ventilation:PROVIDE SUFFICIENT VENT, IN VOL & PATTERN, TO KEEP TLV &
LEL OF HAZ INGS BELOW LIM, & TO REMOVE DECOMP PROD (SUP DAT)
Protective Gloves:WEAR CHEMICAL-RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:WEAR APPROPRIATE IMPERVIOUS CLOTHING TO
PREVENT SKIN CONTACT. ANSI APPROVED EMERGENCY EYEWASH & DELUGE
SHOWER .
Work Hygienic Practices:REMOVE AND WASH SOILED CLOTHING BEFORE REUSE.
WASH HANDS BEFORE EATING OR SMOKING.
Supplemental Safety and Health
FIRE FIGHT PROC: MUST NOT BE USED AS EXTING MEDIA. TAKE CARE TO PVNT
SPREAD OF BURNING LIQ W/WATER. CLSD CONTRS MAY EXPLODE WHEN EXPOSED
TO EXTREME HEAT. RESP PROT: REMOVE A COMBINATION OF PARTICULATE S &
VAPS. VENT: DURING WELDING/FLAME CUTTING ON SURF COATED W/THIS
PROD.

Boiling Pt:B.P. Text:280F,138C
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS.
Stability Condition to Avoid:STORE AWAY FROM DIRECT HEAT, FLAME OR
SPARK.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
VARIOUS HYDROCARBON FRAGMENTS.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE W/LOCAL, STATE &
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.