Product ID:Y20-E THINNER-VINYL RETARDER FOR ROLLING OR BRUSHING
MSDS Date:12/03/1993
FSC:8010
NIIN:00N071763
MSDS Number: CBPKG

PRO-LINE PAINT CO

2646 MAIN ST
SAN DIEGO, CA 92113-3697
US

Emergency Phone: 800-535-5053

Info Phone: 619-231-2313

Preparer: E SOETERIK

Cage: 9D157

PRO-LINE PAINT CO

SAN DIEGO, CA 92113-3697 US

Telephone: 619-231-2313; 619-232-8968

Cage: 9D157

2-HEPTANONE; (METHYL N-AMYL KETONE)

CAS: 110-43-0

RTECS: MJ5075000

Fraction By Weight: 100%

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM

817 G/L

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INHALATION: EXCESSIVE
INHALATION OF VAPORS CAN CAUSE NASAL AND RESPIRATORY IRRITATION,
DIZZINESS, NARCOTIC EFFECTS. SKIN/EYES: BURNING SENSATION FROM
VAPOR OR LIQUID. DERMATITIS, SENSITIZATION. HIGH CONCENTRATIONS
CAN BE IRRITATING AND SHOULD BE AVOIDED. SKIN ABSORPTION: CAUSES
DEFATTING AND (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: RESULTANT IRRITATION. INGESTION:
TOXIC IF SWALLOWED. CAN CAUSE BURNING SENSATION, VOMITING,
DIARRHEA, DROWSINESS. ASPIRATION OF VOMIT INTO LUNGS CAN CAUSE
PNEUMONIA. CHRONIC: NONE SPECIFIED BY MANUFACTURER.
Medical Cond Aggravated by Exposure:ASTHMA AND SKIN ALLERGIES.

First Aid:EYES: FLUSH IMMED W/FRESH WATER BY EYE WASH APPARATUS/BY HAND
FOR AT LEAST 15 MIN. SEEK MED ATTN. SKIN: WASH IMMED W/WATER. THEN
WASH W/SOAP & WATER, RINSE IMMED. SEEK MED ATTN. INHAL: MOVE PERS
TO FR ESH AIR; ARTF RESP IF NEC. SEEK MED ATTN. INGEST: SEEK MED
ATTN. NOTES TO MD: IN ACUTE CASES SEEK MED ATTN IMMED. FOR WORKERS
WHO MAY BE EXPOSED REGULARLY, PROVIDE DETAILED PERIODIC
EXAMINATIONS.

Flash Point Method:TCC
Flash Point:102F,39C
Lower Limits:1.11%
Upper Limits:7.9%
Extinguishing Media:USE CARBON DIOXIDE, FOAM, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH APPRVD SCBA & FULL PROT EQUIP .
BLANKET FLAME W/ONE OF THE ABOVE. VAPS OF COMBUST MAY BE IRRIT TO
RESP TRACT. MAY CAUSE BRTHG DIFFICULTIES.
Unusual Fire/Explosion Hazard:KEEP MATERIAL AWAY FROM HEAT, SPARKS, AND
OPEN FLAMES.

Spill Release Procedures:REMOVE ALL TYPES OF IGNITION SOURCES. PROVIDE
SUFFICIENT VENTILATION. PROTECT CLEAN-UP PERSONS WITH NIOSH
APPROVED 8540 3M CORP RESPIRATOR AND GOGGLES.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:PROT AGAINST PHYSICAL DMG TO CONTRS &
SPILLAGE. STORE IN COOL WELL-VENTD AREA W/SPRINKLER SYS. KEEP AWAY
FROM HEAT. POST NO SMOKING SIGNS.
Other Precautions:CAUTION: WHEN PROD IS RECEIVED IN A 55 GALLON DRUM,
DO NOT CUT INTO EMPTY DRUM W/ACETYLENE TORCH/ALLOW ANY OPEN FLAMES
NEAR DRUM UNLESS DRUM IS CLEAN & PURGED. RPTS HAVE SHOWN THAT ASSOC
RPTD & PRLNG OCCUP OVEREXP TO SOLV CAN (SUP DAT)

Respiratory Protection:USE NIOSH APPRVD DUST/MIST RESP (HIGH EFFICIENCY
CARTRIDGES ADVISED) IF SPRAYING/SANDING. USE ORG VAP CARTRIDGE RESP
IF TLV FOR SOLV COMPONENTS MAY BE EXCEEDED, E.G., 8540 3M CORP RESP
(NIOSH APPRVD). WHEN USING IN CONFINED AREAS, (SUP DAT)
Ventilation:USE LOCAL EXHAUST WHEN APPLYING THIS PAINT IN CONFINED
AREAS. KEEP VAPORS BELOW TLV.
Protective Gloves:SOLVENT RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
USE PROT CLTHG & CHANGE CONTAM CLTHG IMMED.
Work Hygienic Practices:TRAIN EMPLOYEES ON ALL SPECIAL HANDLING
PROCEDURES IN THIS SECTION BEFORE THEY WORK WITH THIS PRODUCT.
Supplemental Safety and Health
HAZ DECOMP PROD: CARBON MONOXIDE/ISOBUTYLENE. OTHER PREC: CAUSE PERM
BRAIN & NERV SYS DMG. INTENTIONAL MISUSE BY DELIBERATELY
CONCENTRATING & INHALING CONTENTS MAY BE HAMFUL/FATAL. USE ONLY
W/ADEQ VEN T. RESP PROT: WEAR NIOSH APPRVD AIR-FEDHOOD.

Boiling Pt:B.P. Text:300F,149C
Vapor Pres:2.14 @ 20C
Vapor Density:3.94
Spec Gravity:0.817
Evaporation Rate & Reference:0.4 (BUTYL ACETATE=1)
Solubility in Water:SLIGHT
Appearance and Odor:CLEAR, WITH FRUITY ODOR

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT, SPARKS, AND OPEN FLAMES. DO NOT
ALLOW VAPORS TO ACCUMULATE.
Hazardous Decomposition Products:FLAMMABLE FUMES MAY ACCUM IN CONFINED
AREA & SPARKS/OPEN FLAME MAY IGNITE IT. MAY LIBERATE CARBON
DIOXIDE, (SUP DAT)
Conditions to Avoid Polymerization:EXTREME HEAT, SPARKS AND OPEN FLAME.

Waste Disposal Methods:USE METAL CONTAINER MARKED "DO NOT REUSE". PUT
THE MATERIAL IN THIS CONTAINER. USE VERMICULITE OR OTHER INERT
ABSORBENT. KEEP AWAY FROM SEWER. DISPOSE OF ALL WASTES IN
ACCORDANCE WITH FEDERAL, STATE A ND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.