Product ID:PLASTIC STEEL 5-MINUTE PUTTY (SF) RESIN, 10240
MSDS Date:04/07/1995
FSC:8030
NIIN:00N039846
MSDS Number: CHSZL

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 508-777-1100

Cage: 0RZG3

Telephone: 978-777-1100

Cage: 0RZG3

BISPHENOL A-EPICHLOROHYDRIN COPOLYMER; (BISPHENOL A

CAS: 25068-38-6

RTECS: SL6475000

Fraction By Weight: 15-35%

OSHA PEL N/K

ACGIH TLV: 3.5 MG/M3 (MFR)

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:NONE SPECIFIED BY MANUFACTURER.
CHRONIC:MAY CAUSE SKIN SENSITIZATION (ITCHING, SWELLING, RASH).
COMPONENT IN PRODUCT HAS SHOWN ACTIVITY BY IN VITRO MICROBIAL
MUTAGENIC SCREENING TESTS AND PRODUC ED CHROMOSOMAL ABBERATIONS IN
CULTURED RAT LIVER CELLS. BISPHENOL A DIGLYCIDYL ETHER RESIN:SKIN
SENSITIZER, IRRITANT.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:ALLERGIES, ECZEMA & OTHER SKIN
DISORDERS.

First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR.
SUPPORT BREATHING (GIVE O*2/ARTF RESP) . EYES:FLUSH W/CLEAN WATER
FOR AT LEAST 15 MINUTES WHILE GENTLY HOLDING EYELIDS OPEN. GET MED
ICAL ATTENTION. SKIN:WASH THOROUGHLY W/SOAP & WARM WATER. CONSULT
MD IF IRRITATION DEVELOPS.

Flash Point Method:PMCC
Flash Point:>400F,>204C
Extinguishing Media:CO*2, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:TOXIC SMOKE & VAPORS MAY FORM DURING
COMBUSTION.

Spill Release Procedures:PREVENT SKIN CONTACT. SCRAPE UP & DISCARD IN
SUITABLE CONTAINERS, USING INERT ABSORBENT MATERIAL SUCH AS
VERMICULITE IF NEEDED. WASH SPILL AREA W/INDUSTRIAL CLEANING AGENT;
IF SOLVENT IS USED, TAKE CA RE AGAINST OVEREXPOSURE & FIRE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE WELL CLOSED IN A COOL, DRY
PLACE. AFTER MIXING W/HARDENER, OBSERVE PRECAUTIONS RECOMMENDED FOR
HARDENER. AFTER PROPER CURING PRODUCT IS NOT HAZ.
Other Precautions:WHEN SANDING OR MACHINING CURED MATERIAL, TAKE PROPER
PRECAUTIONS AGAINST INHALATION OF DUSTS GENERATED. A TLV OF 3.5
MG/M3 SHOULD BE OBSERVED.

Respiratory Protection:NONE REQUIRED AT NORMAL HANDLING TEMPERATURES.
USE NIOSH APPROVED ORGANIC VAPOR CARTRIDGES AS NEEDED.
Ventilation:LOCAL EXHAUST IS RECOMMENDED FOR CONFINED AREAS. GENERAL
MECHANICAL VENTILATION IS ADEQUATE FOR NORMAL USE.
Protective Gloves:CHEMICAL RESISTANT-RUBBER GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . OTHER PROT GEAR AS REQUIRED TO PVNT SKIN
CONT.
Work Hygienic Practices:CONTAM CLTHG & PROT GEAR SHOULD BE REMOVED &
CLEANED BEFORE RE-USE. LEATHER ARTICLES SUCH AS SHOES & BELTS (SUPP
DATA)
Supplemental Safety and Health
PH:7 (5% BY WT IN WATER). HYGIENE PRACT:CANNOT BE DECONTAMINATED &
SHOULD BE DISCARDED. WASH THOROUGHLY AFTER USING, ESPECIALLY BEFORE
EATING OR SMOKING.

Vapor Pres:NIL @ 78F
Vapor Density:>1
Spec Gravity:2.8
pH:SUPDAT
Evaporation Rate & Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:NIL
Appearance and Odor:DARK GRAY PASTE W/LITTLE ODOR.

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, BASES (ESP, SECONDARY & PRIMARY ALIPHATIC AMINES) &
OXIDIZERS.
Stability Condition to Avoid:OPEN FLAME & EXTREME HEAT.
Hazardous Decomposition Products:OXIDES OF CARBON; ALDEHYDES, ACIDS &
OTHER UNKNOWN ORGANIC COMPOUNDS FROM INCOMPLETE COMBUSTION.
Conditions to Avoid Polymerization:HEAT IS RELEASED WHEN THIS RESIN IS
MIXED W/EPOXY HARDENER. USE CAUTION WHEN MIXING A POUND OR MORE.

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS . THE RESIN CONTAINS NO RCRA- OR CERCLA-LISTED
HAZARDOUS WASTES. DISPOSE OF I/A/W APPLICABLE STATE & LOCAL
REGULATION.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.