BCCXR - TEFLON NON-STICK FINISH,BLACK, 958-203
- MSDS: BCCXR
- Manufacturer: E I DUPONT DE NEMOURS AND COMPANY INC
- Product Name: TEFLON NON-STICK FINISH,BLACK, 958-203
- National Stock Number: 8010-00K001461
Product Identification
Product ID:TEFLON NON-STICK FINISH,BLACK, 958-203
MSDS Date:01/01/1985
FSC:8010
NIIN:00K001461
MSDS Number: BCCXR
Responsible Party
WILMINGTON, DE 19899
US
Emergency Phone: 800-441-7515
Info Phone: 800-441-7515
Cage: DO229
Contractor
Telephone: 800-441-7515
Cage: DO229
Ingredients
ALIPHATIC ALCOHOLS
Fraction By Weight: 1.0%
ACGIH TLV: 100PPM(PER MFR)
ALIPHATIC KETONES
Fraction By Weight: 24.0%
ACGIH TLV: 100PPM(PER MFR)
ETHER(TYPE NOT SPECIFIED
Fraction By Weight: 5.0%
LACTAM
Fraction By Weight: 46.0%
AQUEOUS SOLUTION,HAZARD UNKNOWN,UNIDENTIFIED; % WT 24% BY
Fraction By Weight: 24.0%
Hazards
Effects of Overexposure:THERMAL DECOMPOSITION PRODUCTS MAY CAUSE
POLYMER FUME FEVER.INDCATRS:CHILLS,FEVER,& FLU-LIKE SYMPTMS
First Aid
First Aid:INHALATION:MOVE TO FRESH AIR TO IMPROVE BREATHING;SKIN:WASH
WITH SOAP & WATER.REMOVE CONTAMINATED CLOTHING;EYES:FLUSH WITH
WATER FOR AT LEAST 15 MIN.CALL A PHYSICIAN.
Fire Fighting
Flash Point:<73F (C.C.)
Lower Limits:0.90
Upper Limits:7.5
Extinguishing Media:CO*2, FOAM, DRY CHEM.
Fire Fighting Procedures:COOL CLOSED CONTNRS W/H*2O USING FOG NOZZLES.
Accidental Release
Spill Release Procedures:EVACUATE UNPROTECTED PERSONS. ELIM IGNITION
SOURCES. STOP LEAK. H*2O SPRAY COOL CONT/DIVERT SPILL FROM
FIRE/HEAT. PROVIDE VENTILATION. ABSORB W COMMERCIAL
ABSORBENT,SHOVEL INTO METAL DRUMS:LG SPILL:DI KE W COMMERCIAL
ABSORBENT,PUMP INTO COVERED DRUMS.
Handling
Handling and Storage Precautions:KEEP AWAY FROM HEAT,SPARKS, AND OPEN
FLAME.CLOSE CONTAINERS AFTER EACH USE.WEAR SYNTHETIC GLOVES;AVOID
PROLONGED SKIN CONTACT & BREATHING VAPORS.
Other Precautions:WASH THOROUGHLY AFTER HANDLING & BEFORE EATING OR
SMOKING;OBSERVE LABEL PRECAUTIONS;EXPLOSV REACTION MAY OCCUR ABOVE
796F W/FINELY DIVIDED AL/MG;REMOVE IGN SOURCE IF SOLVENTS ARE
PRESENT.
Exposure Controls
Respiratory Protection:USE A CARTRIDGE TYPE RESP IF AIR CONTAMINANTS
CONTROL IS NOT FEASBLE
Ventilation:LOCAL EXHAUST TO MAINTN BELOW TLV.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY/CHEM GOGGLES
Other Protective Equipment:USE APPROPRIATE INDUSTRIAL HYGIENE
PRACTICES.
Supplemental Safety and Health
MSDS FM MFR DATED: UNKNOWN;VAPOR PRESSURE/DENSITY NOTED OF PRINCIPAL
SOLVENT.
Chemical Properties
HCC:F3
Boiling Pt:B.P. Text:230F
Vapor Pres:16
Vapor Density:3.45
Spec Gravity:1.036
Evaporation Rate & Reference:<1(SLOWER THAN ETH
Solubility in Water:APPRECIABLE
Appearance and Odor:SEMI-VISCOUS PIGMENTED LIQD;MILD SOLVENT ODOR
Percent Volatiles by Volume:86
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZERS, CORROSIVES
Stability Condition to Avoid:KEEP AWAY FROM HEAT,SPARKS & OPEN FLAME
Hazardous Decomposition Products:CO,CO*2,SMOKE,HF,CF*4,
COF*2,PERFLUOROISOBUTYLENE.
Disposal
Waste Disposal Methods:KEEP IN COVERED DRUMS,PENDING DISPOSAL. HANDLE &
DISPOSE IN FULL COMPLIANCE WITH ALL APPLICABLE
INTERNATIONAL,FEDERAL,STATE, & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.