Product ID:ENAMEL ALKYD SG GREEN 24148, ID745412
MSDS Date:01/02/1987
FSC:8010
NIIN:00-527-2628
MSDS Number: BFCVT

PRATT & LAMBERT, INC.

16116 E 13TH ST
WICHITA, KS 67201
US

Emergency Phone: 316-733-1361

Info Phone: 316-733-1361

Preparer: W.A. ELLISON

Cage: FO127

PRATT AND LAMBERT INC

22 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

MINERAL SPIRITS

CAS: 64742-88-7

OSHA PEL 500 PPM 2950 MG/CU.M

ACGIH TLV: 100 PPM 525 MG/CU.M.

XYLENES (O-,M-,P- ISOMERS) (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

SILICA, CRYSTALLINE - CRISTOBALITE

CAS: 14464-46-1

RTECS: VV7325000

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.05 MG/M3 RDUST9293

SILICA, CRYSTALLINE - FUSED

CAS: 60676-86-0

RTECS: VV7328000

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293

TALC (CONTAINING NO ASBESTOS)

CAS: 14807-96-6

RTECS: WW2710000

OSHA PEL 2 MG/M3 RDUST

ACGIH TLV: 2 MG/M3 RDUST; 9192

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

VOC. ORGANIC CMPD 3.5 LB/GAL LESS WATER & NPRS* 420 G/L

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:REPEATED EXPOSURE TO CRYSTALLINE
SILICA MAY CAUSE PNEUMOCONIOSIS, A PROGRESSIVE DISABLING LUNG
DISEASE. OVEREXP TO XYLENE MAY CAUSE INJURY TO LIVER, KIDNEYS &
BLOOD. PROLONGED/REPEATED OVEREXPOSURE TO SOLVENTS W/PERMANENT
BRAIN & NERVOUSSYSTEM DAMAGE. DELIBERATE MISUSE OF CONTENTS MAY BE
HARMFUL OF FATAL.
Effects of Overexposure:INGST: GASTROINTESTINAL IRRIT,NAUSEA,VOMITING &
DIARRHEA. ASPIRATION OF MATL IN TO LUNGS CAN CAUSE CHEM.
PNEUMONITIS WHICH CAN BE FATAL. INHAL:MAY CAUSE IRRIT. TO
NOSE,THROAT & ACUTE NERVOUS SYSTEM DE PRESSION. EYE:
IRRITATIONSKIN: MAY CAUSE DEFATTING & IRRITATION OF THE SKIN.
Medical Cond Aggravated by Exposure:PREXISTING RESP. CONDITIONS MAY BE
AGGRAVATED BY EXPOSURE TO CRYSTALLINE SILICA.

First Aid:INGST: CALL A PHYSICIAN IMMED.
INHAL: REMOVE TO FRESH AIR IMMEDIATELY,GIVE
ARTIFICIAL RESPIRATION IF NEEDED. KEEP WARM/QUIET, GET MEDICAL
ATTENTION I MMEDIATELYEYE: FLUSH W/LRG AMTS OF WTR FOR 15 MINS. GET
MEDICAL ATTENTION. SKIN: WASH AFFECTED AREA W/SOAP &
WATER, GET MEDICAL ATTENTION.

Flash Point:80F/26.67C
Extinguishing Media:NFPA CLASS B FIRE EXTINGUISHER DESIGNED TO
EXTINGUISH FLAMMABLE LIQUID FIRES. POLYMER FOAM PREFERRED FOR LARGE
FIRES.
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS. WATER
MAY BE INNEFECTIVE, BUT MAY BE USED TO PREVENT PRESSURE BUILD-UP.
IF WATER IS USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, ELECTRICAL EQUIPMENT, SPARKS AND FLAME. CLOSED
CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:ELIMINATE ALL SOURCES OF IGNITION. DIKE &
CONTAIN SPILL W/INERT MATL. TRANSFER LIQ TO COVER METAL
CONTAINER. USE NON SPARKING TOOLS. PREVENT CONTAMINATION OF
SEWER,STREAMS, & GROUNDWATER W/SPILLED MATL OR USED ABSORBENT.

Handling and Storage Precautions:DO NOT STORE ABOVE 120 DEGREES F.
STORE LARGE QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
CLOSE CONTAINER AFTER EACH USE.
Other Precautions:DO NOT TAKE INTERNALLY. DO NOT BREATH SANDING DUST.
DO NOT WASH & REUSE CONTNRS FOR ANY PURPOSE. DO NOT WELD, BRAZE OR
CUT ON EMPTY CONTAINER. NEVER USE PRESS. TO EMPTY. CONTAINER SHOULD
BE GROUNDED & BONDED TO THE RECEIVING CONTAINER.

Respiratory Protection:SPRAYING, USE NIOSH APPROVED MECHANICAL
RESPIRATOR. RESTRICTED AREAS USE NIOSH APPROVED CHEMICAL
CARTRIDGE/MECHANICAL FILTER. CONFINED AREA USE NIOSH APPROVED
AIR-SUPPLIED RESPIRATOR.
Ventilation:GENERAL DILUTION & LOCAL EXHAUST VENTILATION.
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:WEAR SAFETY SPECTACLES WITH SIDE SHIELDS
Other Protective Equipment:NOT LIKELY TO BE NEEDED
Supplemental Safety and Health
NK

Boiling Pt:B.P. Text:193-395F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:53

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:EXCESSIVE HEAT AND SOURCES OF IGNITION
Hazardous Decomposition Products:BURNING, INCLUDING WHEN HEATED BY
WELDING OR CUTTING, WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON
DIOXIDE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT, SPARKS, AND
FLAME

Waste Disposal Methods:INCINERATE ONLY IN EPA FACILITY. DO NOT
INCINERATECLOSED CONTAINERS. DISPOSE ONLY IN ACCORDANCE
WITHFEDERAL,STATE, & LOCAL REGULATIONS. CONTAMINATED ABSORBENT MAY
BE DISPOSED IN A HAZARDOUS WASTE LANDFILL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.