Product ID:ALKYD SEMI GLOSS ENAMEL
MSDS Date:11/01/1988
FSC:8010
NIIN:00-527-2630
MSDS Number: BHDMQ

Emergency Phone: 404-589-4400

Info Phone: 404-622-1326

Cage: OO269

Telephone: 404 622 1326

Cage: OO269

VM&P NAPHTHA (LIGROINE)

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: 35-40%

OSHA PEL 300 PPM/400 STEL

ACGIH TLV: 300 PPM; 9192

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Effects of Overexposure:EYE:SEVERE IRRITATION,REDNESS,TEARING,BLURRED
VISION. SKIN: MOD. IRRITATION,DEFATTING,DERMATITIS.
INHAL:NASAL/RESPIRATORY
IRRITATION,DIZZINESS,WEAKNESS,FATIGUE,NAUSEA,HEADACHE,POSSIBLE
UNCONSCIOUSNESS , & ASPHYXIATION.
INGST:GASTROINTESTINALIRRITATION,NAUSEA,VOMITING,& DIARRHEA.
Medical Cond Aggravated by Exposure:ASPIRATION OF MATL INTO THE LUNGS
CAN CAUSE CHEMI-CAL PNEUMONHITIS WHICH CAN BE FATAL.

First Aid:EYE:FLUSH W/LG AMOUNTS OF WTR LIFTING UPPER/LOWER LIDS
OCCASIONALLY.GET MED.ATTNSKIN: WASH W/SOAP & WATER. REMOVE
CONTAMINATED CLOTHING. GET MEDICAL ATTN. IF IRRITATION PERSISTS.
INGST: DO NOT INDUC E VOMITING, KEEP PERSON WARM,QUIET ANDGET
MEDICAL ATTENTION. INHAL: REMOVE TO FRESH AIR. IF BREATHING IS
DIFFICULT, ADMINISTER OXYGEN. GIVE ARTIFICAL RESPIR. IF BREATHING
HAS STOPPED.GET MED.ATTN.

Flash Point Method:TCC
Flash Point:105F/40.56C
Lower Limits:1.0
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR S.C.B.A. WITH FULL FACEPIECE OPERATED IN
PRESSURE DEMAND OR OTHER POSITIVE PRESSURE MODE WHEN FIGHTING
FIRES. WATER SPRAY MAY BE INEFFECTIVE.
Unusual Fire/Explosion Hazard:CONTAINERS MAY EXPLODE WHEN EXPOSED TO
EXTREME HEAT. VAPORS MAY BE MOVED BY VENTILATION & IGNITED BY
IGNITION SOURCES AT LOCATIONS DISTANT FROM MATERIALS POINT.

Spill Release Procedures:ELIMINATE ALL SOURCES OF IGNITION. STOP SPILL
AT SOURCES, DIKE AREA OF SPILL TO PREVENT SPREADING, PUMP LIQUID
TO SALVAGE TANK. ABSORB WITH FLOOR ABSORBENT,VERMICULITE, &
TRANSFER TO HOOD.

Handling and Storage Precautions:AVOID STORING IN HIGH TEMPERATURE OR
NEAR OPEN FLAME. STORE DRUM OUT OF SUN AND AWAY FROM HEAT.
Other Precautions:DO NOT WELD OR FLAME CUT AN EMPTY DRUM.DRUMS OF THIS
MATERIAL SHOULD BE GROUNDEDAND BONDED WHEN POURING. KEEP CLOSURE
TIGHT AND CONTAINER UPRIGHT TO PREVENT LEAKAGE. CONTAINERS OF
THIS MATL MAY BE HAZARDOUS WHEN EMPTIED.

Respiratory Protection:APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN
THE ABSENCE OF PROPER ENVIRONMENTAL CONTROL.
Ventilation:GENERAL OR LOCAL EXHAUST
Protective Gloves:NITRILE RUBBER, NEOPRENE
Eye Protection:CHEMICAL GOGGLES,SAFETY GLASSES
Other Protective Equipment:IMPERVIOUS CLOTHING AND BOOTS
Work Hygienic Practices:WASH HANDS BEFORE EATING,WASHROOM, SMOKE IN
SMOKING AREA ONLY. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
NK

Boiling Pt:B.P. Text:300F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:48

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH TEMPERATURES, OPEN FLAME, AND SPARKS.
Hazardous Decomposition Products:CARBON DIOXIDE/MONOXIDE AND VARIOUS
HYDROCARBONS

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
AND LOCAL REGULATIONS. IF RUN OFF OCCURS NOTIFY PROPERAUTHORITIES
AS REQUIRED THAT A SPILL HAS OCCURED.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.