BJDRP - PC-12 007M PART A (PA2008)
- MSDS: BJDRP
- Manufacturer: DEXTER ELECTRONIC MTLS DIV THE DEXTER CORP
- Product Name: PC-12 007M PART A (PA2008)
- National Stock Number: 8040-00-085-4319
Product Identification
Product ID:PC-12 007M PART A (PA2008)
MSDS Date:08/14/1991
FSC:8040
NIIN:00-085-4319
Kit Part:Y
MSDS Number: BJDRP
Responsible Party
OLEAN, NY 14760-1297
US
Emergency Phone: 716-372-6309
Info Phone: 716-372-6300
Preparer: JAMES P. HORNBURG
Cage: 04347
Contractor
Telephone: 716-372-6300/6309
Cage: 04347
Ingredients
N-BUTYL GLYCIDYL ETHER (BGE)
CAS: 2426-08-6
RTECS: TX4200000
Fraction By Weight: 60-100%
OSHA PEL 50 PPM
ACGIH TLV: 25 PPM; 9293
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:NONE SPECIFIED BY MANUFACTURER.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:NO ACUTE SYMPTOMS EXPECTED. A SENSITIZER. SKIN:
PROLONGED OR REPEATED EXPOSURE MAY CAUSE SKIN RASH.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:FLUSH SKIN AND EYE CONTACT WITH PLENTY OF WATER. THEN WASH
SKIN THOROUGHLY WITH SOAP AND WATER. REMOVE CONTAMINATED CLOTHING.
WASH BEFORE REUSE.
Fire Fighting
Flash Point Method:TCC
Flash Point:155
Extinguishing Media:USE CARBON DIOXIDE OR DRY CHEMICAL FOR SMALL
FIRES;FOAM (ALCOHOL POLYMER OR ORDINARY) FOR LARGE FIRES.
Fire Fighting Procedures:AVOID BREATHING SMOKE. USE NIOSH/MSHA APPROVED
SCBA AND FULL PROTECTIVE EQUIPMENT.
Unusual Fire/Explosion Hazard:NONE
Accidental Release
Spill Release Procedures:COVER WITH ABSORBENT MATERIAL, THEN SHOVEL
INTO WASTE CONTAINER. IF SPILL AREA IS TO BE SOLVENT-RINSED TO
REMOVE STICKINESS, BE AWARE OF SOLVENT VAPOR HAZARD.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN DRY AREA; AVOID SKIN CONTACT.
Other Precautions:NONE
Exposure Controls
Respiratory Protection:MSHA APPROVED CANNISTER MASK, AIR HOSE MASKS.
Ventilation:LOCAL EXHAUST - PROVIDE ADEQUATE VENTILALTION TO KEEP VAPOR
CONC. BELOW LEL AND TLV. MECHANICAL - GENERAL DILUTION.
Protective Gloves:RUBBER OR PLASTIC.
Eye Protection:SAFETY GLASSES OR GOGGLES
Other Protective Equipment:WEAR COVERALLS OR APRON TO AVOID CLOTHING
AND SKIN CONTAMINATION.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
Spec Gravity:1.08
Evaporation Rate & Reference:>1 (BU AC=1)
Solubility in Water:0
Appearance and Odor:AMBER, MEDIUM VISCOSITY LIQUID, VERY SLIGHT
CHARACTERISTIC ODOR.
Percent Volatiles by Volume:8
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTAMINATION WITH ALKALIES, ACIDS, AMINES AND WATER.
Stability Condition to Avoid:NONE
Hazardous Decomposition Products:CARBON MONOXIDES, ALDEHYDES, ACIDS AND
OTHER ORGANIC COMPOUNDS.
Conditions to Avoid Polymerization:EXOTHERMIC CURE MAY OCCUR WHEN LARGE
QUANTITIES ARE MIXED WITH CURING
Disposal
Waste Disposal Methods:CONTROLLED INCINERATION OR PUT INTO METAL WASTE
CONTAINER FOR LANDFILL BURIAL. NEW YORK STATE DOES NOT PERMIT
LANDFILL BURIAL OF LIQUID. SOLIDIFY BY MIXING WITH EPOXY HARDENER
BEFORE LANDFILL BURIAL. THIS IS NOT A HAZARDOUS WASTE UNDER THE
RCRA.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.