Product ID:EPOXY PART A, MIL-C-22750E GLOSS, M0-082
MSDS Date:03/09/1992
FSC:8010
NIIN:01-313-8695
Kit Part:Y
MSDS Number: BNCMZ

CRAWFORD LABS, INC

4165 S EMERALD AVE
CHICAGO, IL 60609
US

Emergency Phone: 312-433-1307

Info Phone: 312-376-7132

Preparer: DAVID SCHMETTERER

Cage: 5V430

CRAWFORD LABORATORIES, INC

CHICAGO, IL 60609 US

Telephone: 312-376-7132

Cage: 5V430

METHYL ETHYL KETONE (SARA III) (VAPOR PRESSURE 71.2 MM HG)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: <5%

OSHA PEL 100 PPM

ACGIH TLV: 200 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

BISPHENOL A-EPICHLOROHYDRIN RESIN

CAS: 25085-99-8

Fraction By Weight: 35%

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 15 - 20%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

212 GPL

RTECS: 9999999VO

Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:OVEREXPOSURE: ACUTE TOXICITY RESULTING
IN HEADACHE, DIZZINESS, NAUSEA & LOSS OF CONSCIOUSNESS. SEVERE EYE
IRRITATION POSSIBLY RESULTING IN PERMANENT DAMAGE. IRRITATED MUCOUS
MEMBRANES. VOMITING DUE TO INGESTION. DEFATTING & DRYING OF
SKIN.SENSITIZATION AFTER REPEATED CONTACT. IT IS UNLIKELY THAT
NORMAL WORK *
Explanation of Carcinogenicity:NONE
Effects of Overexposure:* OPERATIONS WITH THIS RESIN COULD PRODUCE
ATMOSPHERIC CONCENTRATIONS APPROACHING OSHA LIMIT. HOWEVER YOU
SHOULD BE AWARE THAT IT HAS BEEN REPORTED TO CAUSE CANCER IN
LABRATORY ANIMALS.

First Aid:EYE: FLUSH W/LUKEWARM LOW PRESSURE WATER 15 MIN, OCCASIONALLY
LIFTING EYELIDS. GET MED AID. INHAL: REMOVE TO FRESH AIR. PROVIDE
OXYGEN IF BREATHING DIFFICULT. GIVE ARTIF RESP IF NOT BREATHING.
GET MED AID. KEEP WARM & COMFORTABLE. INGEST: CALL DR IMMED.
INDUCE VOMIT ON DR INSTRUCTIONS. IF VOMIT OCCURS, KEEP HEAD BELOW
HIPS TO PREVENT ASPIRATION OF LIQ INTO LUNGS. NEVER GIVE ANYTHING
BY MOUTH TO **

Flash Point Method:SCC
Flash Point:22.0F,-5.6C
Lower Limits:1.2
Extinguishing Media:FOAM, CO2, DRY CHEMICAL.
Fire Fighting Procedures:USE WATER TO KEEP EXPOSED CNTNR COOL & TO KEEP
FLAMMABLE STRUCTURES WET. DON'T ENTER FIRE AREA W/O PROPER
PROTECTION BECAUSE HZD DECOMP PROD MAY EXPLODE W/HEAT.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.

Spill Release Procedures:WARNING--FLAMMABLE, ELIMINATE ALL IGNITION
SOURCES. HANDLING EQUIPMENT MUST BE GROUNDED TO PREVENT, SPARKING.
SOAK UP WITH ABSORBENT AND PLACE IN NON-LEAKING CONTAINERS. SEAL
TIGHTLY FOR PROPER DISPOS AL.

Handling and Storage Precautions:HAZARDOUS-FLAMMABLE. KNOW DOT REGS
BEFORE TRANSPORT. WARNING: HOT ORGANIC CHEMICAL VAPORS/MISTS ARE
SUSCEPTIBLE TO SPONTANEOUS COMBUST IN MIX W/AIR.
Other Precautions:IGNIT MAY OCCUR AT TEMPS BELOW AUTOIGNIT. IGNIT TEMPS
DECREASE W/INCREASING VAPOR VOLUME & VAPOR/AIR CONTACT & PRESSURE
CHANGES. IGNIT MAY OCCUR AT TYPICAL ELEVATED TEMP PROCESS
CONDITIONS, ESP IN OPE RATING UNDER VACUUM IF SUBJECT TO ****

Respiratory Protection:IMPORTANT-MUST PROVIDE VENTILATION TO MAINTAIN
VAPOR CONCENTRATIONS BELOW TLV AS GIVEN BY OSHA. IN MORE CONFINED
AREAS A NIOSH-MSHA RESPIRATOR EQUIPPED WITH ORGANIC VAPOR CARTRIDGE
SHOULD BE WORN.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION. SEE RESPIRATORY
PROTECTION.
Protective Gloves:USE RUBBER GLOVES.
Eye Protection:WEAR SAFETY GOGGLES AND/OR FACE SHIELD.
Other Protective Equipment:HAVE EYE BATH AND SAFETY SHOWER AVAILABLE.
Work Hygienic Practices:N/K ***CLOTH/SHOES. FOLLOW BY WASHING W/SOAP &
WATER. DON'T REUSE CONTAM SHOES/CLOTH. IF IRRIT PERSISTS, GET MED
AID.
Supplemental Safety and Health
KEY1:F3.SUDDEN INGRESS OF AIR, OR OUTSIDE PROCESS EQUIP OPERATING UNDER
ELEVATED PRESSURE IF SUDDEN ESCAPE OF VAPORS OR MISTS TO THE
ATMOSPHERE OCCURS. ANY PROPOSED USE OF THIS PRODUCT IN ELEVATED TEM
PERATURE PROCESSES SHOULD BE THOROUGHLYEVALUATED TO ASSURE SAFE
OPERATING CONDITIONS ARE ESTABLISHED AND MAINTAINED.

HCC:F2
Boiling Pt:B.P. Text:174 TO 232F
Vapor Density:> AIR
Spec Gravity:1.09
Viscosity:108 KU
Evaporation Rate & Reference:2.24 X N-BUTYL ACETATE
Solubility in Water:SLIGHT
Appearance and Odor:CLEAR LIQUID, SOLVENT ODOR.
Percent Volatiles by Volume:24.7
Corrosion Rate:NOT CORR

Stability Indicator/Materials to Avoid:YES
MAY BE INCOMPATIBLE WITH OXIDIZING AGENTS AND STRONG ALKALIES.
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES AND
INCOMPATIBILITIES.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION FOR PRODUCTS
LIKE THIS MAY GENERATE HIGHLY POISONOUS CARBON MONOXIDE & OTHER
TOXIC GASES.

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL, STATE AND FEDERAL REGULATIONS. CONTACT AN APPROVED DISPOSAL
FACILITY. EPA HAZARDOUS WASTE # D001. IGNITABLE.
**UNCONSCIOUS PERSO N. SKIN: FLUSH W/WATER WHILE REMOVING CONTAM
***

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.