Product ID:AIR BRUSH PROPELLANT MISCELLANEOUS ATIM0001, 17-2
MSDS Date:01/26/1993
FSC:6830
NIIN:00N044883
MSDS Number: BSDJF

PAASCHE AIRBRUSH CO

7440 W LAWRENCE AVE
HARWOOD HTS, IL 60656
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 314-468-5551

Cage: 45301

PAASCHE AIRBRUSH CO

HARWOOD HTS, IL 60656 US

Telephone: 314-468-5551

Cage: 45301

1199.2 @ 20C

CAS: 75-37-6

RTECS: KI1410000

Fraction By Weight: 95%

OSHA PEL N/K

ACGIH TLV: 1000 PPM (MFR)

1055.0 @ 20C

CAS: 78-78-4

RTECS: EK4430000

Fraction By Weight: 10%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: N/K

8.0% BY WEIGHT.69 GM/L TOTAL

RTECS: 9999999VO

SPECIFIED CNDTNS. SEE YOUR SAFETY EQUIP SUPPLIER.

RTECS: 9999999ZZ

REDUCE EXPOSURE.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE:CAN CAUSE SEV IRRIT, REDNESS,
TEARING, BLURRED VISION, SKIN: PRLNGD/RPTD CNTCT CAN CAUSE MODERATE
IRRIT, DEFATTING, DERMATITIS. INHAL:EXCESS INHAL OF VAPS CAN CAUSE
NASAL & RESP IRRIT, DIZZ, WEAKN ESS, FATIGUE, NAUSEA, HEADACHE,
POSSIBLE UNCONSCIOUSNESS, & EVEN ASPHY. POSS CARDIAC ARRHYTHMIAS AT
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:HIGH CONCS. OVEREXP TO THIS MATL (OR
ITS COMPONENTS) HAS APPARENTLY BEEN FOUND TO CAUSE THE FOLLOWING
EFTS IN HUMANS: RESP TRACT IRRIT, CNS DEPRESS IN HIGH CONCS. HAS
THE POTENTIAL TO SENSIT HEART MUSCLE, CHRONIC EXPOSURE MAY EFT
LIVER. INTENTIONAL MISUSE BY DELIB INHAL THE PROD MAY BE HARMFUL OR
FATAL.
Medical Cond Aggravated by Exposure:NONE KNOWN.

First Aid:SKIN:THORO WASH EXPOSED AREA W/SOAP & WATER. REMOVE CONTAM
CLTHG. LAUNDER CONTAM CLTHG BEFORE REUSE. GET MED ATTN IF IRRIT
PERSISTS. EYE:FLUSH W/LRG AMTS OF WATER, LIFTING UPPER & LOWER LIDS
OCCASNLY. GET MED ATTN. INHAL:REMOVE INDIVIDUAL TO FRESH AIR. IF
BRTHG IS DFCLT. ADMIN OXYGEN. GIVE ARTF RESP IF BRTHG HAS STOPPED.
KEEP PERSON WARM, QUIET. GET MED ATTN. INGEST: GET MD IMMED .

Flash Point Method:PMCC
Flash Point:-75F,-59C
Lower Limits:1.3%
Upper Limits:16.9%
Extinguishing Media:EXTINGUISHING MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:ALL 5 GAL PAILS & LARGER SHOULD BE
GROUNDED &/OR BONDED DURING MATL TRANSFERRAL. FOR AEROSOL PROD -
EXPOSURE TO TEMPS OVER OF MAY CAUSE CNTNR TO (SUPP DATA)

Spill Release Procedures:ELIMINATE SOURCES OF IGNIT. VENT AREA. PERSONS
NOT PROPERLY EQUIPPED SHOULD BE EXCLUDED FROM AREA. STOP SPILL
SOURCE - PVNT SPREADING. AVOID INHALING OF VAPS. AVOID SKIN CNTCT
W/LIQ. TAKE UP ON ABSORB ENT MATL & PLACE INTO CNTNR FOR DISP.
(SUPP DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:IT IS RECOMMENDED THAT THIS MATL BE
STORED IN A COOL, DRY, VENTILATED AREA. KEEP AWAY FROM HEAT
SOURCES, OPEN FLAME, SPARKS.
Other Precautions:DO NOT STORE ABOVE 120F. DO NOT STORE IN DIRECT
SUNLIGHT. DO NOT TRANSFER TO UNMARKED CNTNRS. KEEP FROM REACH OF
CHILDREN. DO NOT PUNCTURE, INCINERATE, OR PLACE AEROSOL PROD CNTNRS
IN COMPACTORS. CNTN RS OF THIS MATL MAY BE HAZ (SUP

Respiratory Protection:IF WORKPLACE EXPOSURE LIMITS OF PROD/ANY
COMPONENT IS EXCEEDED, A NIOSH/MSHA APPRVD AIR SUPPLIED RESP IS
ADVISED IN ABSENCE OF PROPER ENVIRON CONTROL. OSHA REGS ALSO PERMIT
OTHER NIOSH/MSHA APPRVD RES P (NEGATIVE PRESSURE TYPE) UNDER (ING
4)
Ventilation:PROVIDE SUFFICIENT MECH VENT (GENERAL AND/OR LOCAL EXHAUST)
VENT TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:PVC/NITRILE, NEOPRENE.
Eye Protection:CHEMICAL SPLASH GOGGLES.
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREAS ONLY. REMOVE AND LAUNDER CLOTHING.
Supplemental Safety and Health
EXPLO HAZ: BURST, RELEASING HIGHLY FLAMMABLE GAS. SPILL PROC: USE
PLASTIC SCOOPS FOR FLAMMABLE MATERIALS. OTHER PREC: WHEN EMPTIED,
SINCE CNTNRS RETAIN PROD RESIDUES (VAP, LIQ &/OR SOLID). ALL HAZ
PRE CS GIVEN MUST BE OBSERVED. DO NOT FLAMECUT, BRAZE, OR USE
WELDING TORCH.

HCC:F2
Boiling Pt:B.P. Text:>-13F,>-25C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:0.86
Evaporation Rate & Reference:FASTER THAN BUTYL ACETATE
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR LIQUID, SLIGHT SOLVENT ODOR.
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS, ALKALI, ALKALINE EARTH METALS, AMINES, VERY STRONG
ACID, CAUSTIC, OR OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT, SPARKS, WELDING ARCS, OPEN FLAME,
AND STATIC ELECTRICITY.
Hazardous Decomposition Products:HYDROFLUORIC ACID AND POSSIBLY
CARBONYL FLUORIDE, CARBON MONOXIDE AND CARBON DIOXIDE.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH ALL LOCAL, STATE
AN FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.