Product ID:HERITAGE GLOSS LATEX HOUSE PAINT, 5-8302
MSDS Date:09/18/1992
FSC:8010
NIIN:00N059145
MSDS Number: BXGMS

Emergency Phone: 404-455-7000

Info Phone: 404-455-7000

Cage: WATTL

Telephone: 404-455-7000

Cage: WATTL

NON-HAZARDOUS INGREDIENTS

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INHALATION:W/POOR VENTILATION,
VAPOR OR MIST MAY IRRITATE RESPIRATORY MUCOUS MEMBRANES, CAUSING
HEADACHE & NAUSEA. EYE CONTACT:PRIMARY IRRITANT. CHRONIC:NONE
RECOGNIZED.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE TO FRESH AIR. EYE:FLUSH IMMEDIATELY W/LARGE
AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. TAKE TO MD FOR MEDICAL
TREATMENT. SKIN:REMOVE W/SOAP & WATER. IF DRENCHED, REMOVE
CONTAMINATED. INGES T:IF VICTIM IS CONSCIOUS, GIVE 2 GLASSES OF
WATER TO DILUTE. DO NOT INDUCE VOMITING. CONSULT MD OR POISON
CONTROL CENTER.

Flash Point:NONE
Lower Limits:NONE
Extinguishing Media:WATER FOG (APPLICABLE ONLY FOR COOLING CLOSED
CONTAINERS).
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINER MAY EXPLODE WHEN EXPOSED
TO EXTREME HEAT.

Spill Release Procedures:VENTILATE AS DESCRIBED IN SPECIAL PROTECTION
INFO SECTION. AVOID UNNECESSARY SKIN CONTACT. COLLECT BY
ABSORPTION, SHOVEL &/OR WET MOPPING.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE >120F. CLOSE CONTAINER
AFTER EACH USE. DO NOT TAKE INTERNALLY.
Other Precautions:PIGMENTED PAINT & COATINGS (THOSE WHICH ARE OPAQUE,
COLORED/WHICH HAVE REDUCED GLOSS WHEN DRY) MAY CONTAIN MATLS SUCH
AS SILICA, TALC, CALCIUM CARBONATE, TITANIUM DIOXIDE, ETC, WHICH
ARE HAZ TO INHALE IN DRY POWDER FORM. THESE HAZS (SUPDAT)

Respiratory Protection:DURING SPRAY APPLICATION USE NIOSH/MSHA APPROVED
MECHANICAL FILTER RESPIRATOR TO REMOVE SOLID AIRBORNE PARTICLES OF
OVERSPRAY.
Ventilation:PROVIDE SUFFICIENT VENT, IN VOL & PATTERN, TO INSURE VAP
CONCS WELL BELOW ANY TLV & LEL LISTED.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:OBSERVE GOOD SANITARY PRACTICES.
Supplemental Safety and Health
OTHER PREC:ARE NOT BELIEVED TO BE PRESENT WHEN POWDERS ARE DISPERSED IN
LIQ COATINGS. HOWEVER, PRECS SHOULD BE CAREFULLY OBSERVED &
NIOSH/MSHA APPRVD RESPS SHOULD ALSO BE USED IF DRIED COATING IS
SAND ED/ABRADED IN SUCH A WAY AS TO PRDCE DUST.

Boiling Pt:B.P. Text:212F,100C
Vapor Density:LTR/AIR
Spec Gravity:1.1-1.26
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:63-69

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:WHEN HEATED TO DECOMPOSITION, AS IN A
FIRE OR IN WELDING, MAY PRODUCE TOXIC FUMES SUCH AS CARBON
MONOXIDE.

Waste Disposal Methods:DISPOSE I/A/W LOCAL, STATE & FEDERAL
REGULATIONS. DO NOT INCINERATE CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.