Product ID:S-90 ADHESIVE
MSDS Date:07/01/1991
FSC:8040
NIIN:01-046-5053
MSDS Number: BXJWV

ARMSTRONG WORLD INDUSTRIES INC

313 W LIBERTY ST
LANCASTER, PA 17604
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 717-396-2328

Cage: 03938

ARMSTRONG WORLD INDUSTRIES, INC.

3209 LANCASTER, PA 17604 US

Telephone: 717-396-2328; 717-396-2935

Cage: 03938

LIGROINE; (VM&P NAPHTHA)

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: 25-34%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

ASPHALT; (PETROLEUM GRADE ASPHALT)

CAS: 8052-42-4

RTECS: CI9900000

Fraction By Weight: 64-73%

OSHA PEL N/K

ACGIH TLV: 5 MG/M3; FUME

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN & EYES: EXCESSIVE SKIN CONTACT
MAY CAUSE DRYING & CRACKING OF SKIN, DEFATTING OF TISSUE & RESULT
IN DERMATITIS. CONTACT WITH EYES WILL CAUSE IRRITATION. INHALATION:
IRRITATION OF RESPIRATORY TRAC T, COUGHING, HEADACHE, DIZZINESS,
DROWSINESS, NAUSEA, UNCOORDINATED MOVEMENTS.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:ANY CONDITION GENERALLY AGGRAVATED
BY SOLVENTS INCLUDING PREEXISTING UPPER RESPIRATORY & LUNG DISEASE
SUCH AS, BUT NOT LIMITED TO, BRONCHITIS, EMPHYSEMA & ASTHMA.

First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES & GET
IMMEDIATE MEDICAL ATTENTION. SKIN: WASH WITH SOAP & WATER. REFER TO
MD IF IRRITATION OR SYMPTOMS PERSIST. INHALATION: REMOVE TO FRESH
AIR IF EXPOSE D TO EXCESS CONCENTRATIONS OF VAPOR. SEEK MEDICAL
ATTENTION IF SYMPTOMS PERSIST. INGESTION: DO NOT INDUCE VOMITING.
CALL POISON CONTROL CENTER. GET IMMEDIATE MEDICAL ATTENTION.

Flash Point Method:SCC
Flash Point:56.0F,13.3C
Lower Limits:1.0%
Upper Limits:7.0%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
DUE TO PRESSURE BUILD UP; USE WATER TO COOL CONTAINERS TO PREVENT
THIS.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNIT. VENT AREA OF
SPILL/LEAK; IF USING MECH VENT, MAKE SURE IT IS EXPLO-PROOF OR DOES
NOT PRESENT IGNIT SOURCE. FOR EXPOS ABOVE TLV, WEAR NIOSH/MSHA
APPRVD RESP EQUIP. CONTAIN SPILL, PREVENTING IT FROM ENTERING
SEWER (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN AREA SUITABLE FOR FLAMMABLE
MIXTURES. RECOMMENDED STORAGE TEMPERATURE IS BELOW 90F.
Other Precautions:VAPORS ARE FLAMMABLE & ARE HEAVIER THAN AIR. PROHIBIT
SMOKING & ELIMINATE ALL OTHER SOURCES OF IGNITION, SUCH AS REGULAR
ELECTRICAL TOOLS & APPLIANCES, MAKING SURE THAT PILOTS ON GAS-FIRED
WATER HEATE RS ARE EXTINGUISHED.

Respiratory Protection:WITH ADEQUATE VENTILATION, RESPIRATORY EQUIPMENT
SHOULD NOT BE NEEDED. IF ADEQUATE VENTILATION IS NOT AFFORDED, WEAR
NIOSH/MSHA APPROVED RESPIRATORY EQUIPMENT APPROVED FOR ORGANIC
VAPORS.
Ventilation:USE NATRL CROSS-VENT, LOC (MECH) PICK-UP &/OR GEN AREA
(MECH) VENT TO PVNT ACCUM OF SOLV VAPS, KEEPING IN MIND (SUPDAT)
Protective Gloves:COTTON OR LOOP-PILE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC: LINES OF WATERWAYS. USE ABSORB TO ASSIST W/PICK-UP OF MATL.
VENT: THAT VENT PATTERN MUST REMOVE THE HVR/AIR SOLVENT VAPS FROM
THE LOWEST LEVELS OF THE WORK SPACES. VENT SHOULD BE SUFFICIEN T TO
KEEP SOLVENT VAP CONC BELOW THE TLV.

Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:10.45 @20C
Vapor Density:3
Spec Gravity:0.92 (H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK ASPHALT MASTIC WITH HYDROCARBON SOLVENT ODOR.
Percent Volatiles by Volume:27 WT

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE &
OTHER TOXIC VAPS & GASES THAT ARE COMMON TO THERMAL DEGRADATION OF
ORGANIC COMPOUNDS.

Waste Disposal Methods:INCINERATION OR OTHER METHOD APPROVED FOR
IGNITABLE WASTES IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.