Product ID:A-106 ADHESIVE, PART B
MSDS Date:06/20/1990
FSC:8040
NIIN:01-157-6451
MSDS Number: CCZCR

ACCUMETRIC INC

350 RING ROAD
ELIZABETHTOWN, KY 42701
US

Emergency Phone: 502-769-3385

Info Phone: 502-769-3385

Cage: 58149

ACCUMETRIC INC

843 ELIZABETHTOWN, KY 42701 US

Telephone: 502-769-3385

Cage: 58149

METHYL HYDROGEN POLYSILOXANE; (METHYLHYDROGEN POLYSILOXANE)

CAS: 63148-57-2

Fraction By Weight: 100%

OSHA PEL N/K

ACGIH TLV: N/K

TRACES OF FORMALDEHYDE

RTECS: 9999999ZZ

149C. PROVIDE VENTILATION TO CONTROL VAPOR EXPOSURE

RTECS: 9999999ZZ

TEMPERATURES. REVIEW THE OSHA FORMALDEHYDE

RTECS: 9999999ZZ

FROM SKIN AS SOON AS PRACTICAL, ESPECIALLY

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: DIRECT CONTACT MAY CAUSE
TEMPORARY DISCOMFORT W/MILD REDNESS & DRYNESS SIMILAR TO WINDBURN.
SKIN: A SINGLE PRLNGD EXPOS (24 TO 48 HRS) CAUSES NO KNOWN ADVERSE
EFT. INHAL: NO IRRIT TO EYES & RESP PASSAGES. NO INJURY IS LIKELY
FROM RELATIVELY SHORT EXPOS OF LESS THAN 8 HRS. INGEST: SMALL
AMOUNTS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: TRANSFERRED TO MOUTH BY FINGERS
DURING USE, ETC, SHOULD NOT INJURE. SWALLOWING LARGE AMOUNTS MAY
CAUSE DIGESTIVE DISCOMFORT. NO KNOWN ADVERSE CHRONIC HEALTH EFFECTS
BUT UNNECESSARY EXPOSURE TO ANY CHEMICAL SHOULD BE AVOIDED.
THISPRODUCT, AS W/ANY CHEMICAL MAY ENHANCE ALLERGIC CONDITIONS IN
CERTAIN PEOPLE.
Medical Cond Aggravated by Exposure:MANUFACTURER DOES NOT KNOW OF ANY
MEDICAL CONDITIONS THAT MIGHT BE AGGRAVATED BY EXPOSURE TO THIS
PRODUCT.

First Aid:INGEST: CALL MD IMMEDIATELY . INHAL: REMOVE TO FRESH AIR.
SUPPORT BREATHING (GIVE OXYGEN/ARTIFICIAL RESPIRATION) . EYES:
FLUSH IMMEDIATELY WITH WATER FOR AT LEAST 15 MINUTES. SKIN: WIPE OF
F AND FLUSH WITH WATER.

Flash Point Method:CC
Flash Point:150F,66C
Extinguishing Media:WATER FOG, CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:VAP ARE HVR/AIR & CAN TRAVEL ALONG THE
GROUND TO REMOTE IGNIT SOURCES. STATIC ELEC MAY ACCUM & IGNITE
VAPS. PVNT POSS FIRE HAZ BY SUITABLE MEANS SUCH AS(SUPDAT)

Spill Release Procedures:USE ABSORB MATL TO COLLECT & CNTN FOR
SALVAGE/DISP. USE PROPER EYE PROT, ANSI APPRVD SAFETY GLASSES AS
MINIMUM. WASHING AT MEALTIME & END OF SHIFT IS ADEQ. NO RESP PROT
SHOULD BE NEEDED. PROD CONTAINS NO INGRED SUBJECT TO REPORTING
REGS. PROD(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP CONTAINER CLOSED AND AWAY FROM
WATER, HEAT, SPARKS AND OPEN FLAME.
Other Precautions:WHEN CNTNR IS OPEN, KEEP CLEAN & DRY. PROD EVOLVES
MINUTE QTYS OF HYDROGEN GAS. DO NOT REPACKAGE OR STORE IN UNVENTED
CNTNRS. ADEQUATELY VENT WORK AREA TO MAINTAIN VAPS WELL BELOW
ESTABLISHED FLAMMABI LITY LIMITS & EXPOSURE (ING 2)

Respiratory Protection:NO RESPIRATORY PROTECTION SHOULD BE NEEDED. USE
NIOSH APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:LOCAL EXHAUST: NONE SHOULD BE NEEDED. MECHANICAL (GENERAL):
RECOMMENDED.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:WASHING AT MEALTIME & END OF SHIFT IS ADEQUATE.
GOOD PRACTICE REQS THAT GROSS AMTS OF ANY CHEMICAL BE REMOVED (ING
5)
Supplemental Safety and Health
EXPLO HAZ: BONDING & GROUNDING, INERT GAS PURGE, VAP DILUTION & THE
LIKE. CNDTNS TO AVOID: HYDROGEN GAS WHICH CAN FORM EXPLO MIXS IN
AIR. SPILL PROC: IS AN OIL IN CONTEXT OF US CLEAN WATER ACT. SPILLS
TO US SURF WATERS OR TO WATERCOURSE/SEWER LEADING TO US SURF
WATERS THAT CAUSE VISIBLE SHEEN MUST BE REPORTED TO NRC.

Vapor Pres:<5 @ 77F
Spec Gravity:0.997
Solubility in Water:<0.1%, REACTS SLOWLY
Appearance and Odor:LIQUID, CRYSTAL CLEAR; VERY LITTLE ODOR.
Percent Volatiles by Volume:<5 WT

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIAL CAN CAUSE A REACTION.
Stability Condition to Avoid:WATER, ALCOHOLS, ACIDIC OR BASIC MATLS &
MANY METALS OR METALLIC CMPDS WHEN IN CONTACT W/PROD, LIBERATE FLAM
(SUPDAT)
Hazardous Decomposition Products:SILICON DIOXIDE, CARBON DIOXIDE AND
TRACES OF INCOMPLETELY BURNED CARBON PRODUCTS.

Waste Disposal Methods:REVIEW ALL LOCAL, STATE AND FEDERAL REGULATIONS
CONCERNING HEALTH AND POLLUTION TO DETERMINE APPROVED DISPOSAL
PROCEDURES.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.