Product ID:A O SILICONIZED ACRYLIC TUB & TILE CAULK
MSDS Date:04/10/1987
FSC:8030
NIIN:00N041357
MSDS Number: BSWDD

AMERICAN OLEAN TILE CO

5300 W 127TH ST
ALSIP, IL 60658
US

Emergency Phone: 312-785-2407

Info Phone: 312-785-2407

Preparer: EDWARD S RINKUS

Cage: 7P894

AMERICAN OLEAN TILE CO,(THE CAMBRIDGE TILE MFR CO)

LANSDALE, PA 19446 US

Telephone: 215-855-1111

Cage: 7P894

MODIFIED ACRYLIC POLYMER EMULSION PLASTICIZER

Fraction By Weight: 30-40%

DIPROPYLENE GLYCOL DIBENZOATE

CAS: 20109-39-1

Fraction By Weight: <10%

CO-C*11 HYDROCARBONS

CAS: 803-23-4

Fraction By Weight: <2%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)

METHANOL (SARA III).

CAS: 67-56-1

RTECS: PC1400000

Fraction By Weight: <0.5%

OSHA PEL 200 PPM; 250 STEL, S

ACGIH TLV: 200 PPM; 250 STEL, S

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

SILANE, 3-(2,3-EPOXYPROPOXY)PROPYLTRIMETHOXY-;

CAS: 2530-83-8

RTECS: VV4025000

Fraction By Weight: 0.5%

ACGIH TLV: 10 MG/M3 (MFR)

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: DIRECT CONTACT MAY CAUSE
IRRITATION. SKIN: PROLONGED CONTACT MAY CAUSE TRANSIENT REDDENING
OF SKIN. INHAL: NO EVIDENCE OF ADVERSE EFFECTS FROM AVAILABLE
INFORMATION. TOXICOLOGY STUDIES OF THE PO LYMER PORTION OF THIS
PRODUCT HAVE SHOWN IT TO BE OF VERY LOW ACUTE TOXICITY.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES: HOLDING LIDS APART, FLUSH WITH A GENTLE STREAM OF WATER
FOR AT LEAST 15 MINUTES. IF IRRIT PERSISTS, SEEK MED ATTN. SKIN:
WASH WITH SOAP & WATER FOR AT LEAST 15 MINS. INHAL: REMOVE TO FRESH
AIR. SUPPORT BREATHING (GIVE O*2/ARTF RESP). INGEST: INDUCE
VOMITING. GET PROMPT MED ATTN.

Flash Point:AQUEOUS SYSTEM
Lower Limits:AQUEOUS SYS
Upper Limits:AQUEOUS SYS
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL. FOR DRY
FILM AFTER WATER EVAPORATES.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT.
Unusual Fire/Explosion Hazard:PRODUCT WILL NOT BURN BUT MAY SPATTER IF
TEMPERATURE EXCEEDS BOILING POINT OF WATER.

Spill Release Procedures:SCRAPE UP & CONTAINERIZE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP FROM FREEZING.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:NONE REQUIRED. WEAR NIOSH/MSHA APPROVED
RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN.
Ventilation:GENERAL (MECHANICAL) ROOM VENTILATION IS SATISFACTORY.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MP:32F,0C (WATER).

Melt/Freeze Pt:M.P/F.P Text:SUPP DATA
Spec Gravity:1.6
pH:7.5
Appearance and Odor:WHITE, OPAQUE PLASTIC MASS W/LEMON SCENT.
Percent Volatiles by Volume:20 WT

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:DRIED SOLIDS CAN BURN GIVING OFF
OXIDES OF CARBON & NITROGEN.

Waste Disposal Methods:INCINERATE OR BURY IN SUITABLE LANDFILL WHERE
PERMITTED BY APPROPRIATE GOVERNMENT REGULATIONS. DISPOSAL MUST BE
I/A/W FEDERAL, STATE & LOCAL REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.