BBJSK - MVP TYPE 33 ADHESIVE

  • MSDS: BBJSK
  • Manufacturer: DEVCON CORP
  • Product Name: MVP TYPE 33 ADHESIVE
  • National Stock Number: 8030-00F001690
Product Identification

Product ID:MVP TYPE 33 ADHESIVE
MSDS Date:07/01/1988
FSC:8030
NIIN:00F001690
MSDS Number: BBJSK

Responsible Party
DEVCON CORPORATION
30 ENDICOTT ST
DANVERS, MA 01923
US

Emergency Phone: 617-777-1100

Info Phone: 617-777-1100

Cage: 16059

Contractor
DEVCON CORP
DANVERS, MA 01923-3753 US

Telephone: 1-508-777-1100

Cage: 16059

Ingredients

METHYL METHACRYLATE, (MONOMER)

CAS: 80-62-6

RTECS: OZ5075000

Fraction By Weight: 30-60%

OSHA PEL 410 MG/CUM

ACGIH TLV: 100 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


METHACRYLIC ACID

CAS: 79-41-4

RTECS: OZ2975000

Fraction By Weight: 10-20%

ACGIH TLV: 20 PPM


3.94 LBS/GAL

RTECS: 9999999VO

Hazards

LD50 LC50 Mixture:ORAL LD50 (RAT): >8000 MG/KG
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE IRRITATION/POSSIBLE
IRREVERSIBLE CORNEAL DAMAGE. SKIN: SEVERE IRRITATION. INHALATION:
NOSE/THROAT IRRITATION. INGESTION: MOUTH/THROAT/GI TRACT
IRRITATION. CHRONIC: PROLONGED/REPEATED CONT ACT W/METHYL
METHACRYLATE/METHACRYLIC ACID CAUSES SKIN SENSITIZATION W/ALLERGIC
SYMPTOMS. (SEE SUPP)
Explanation of Carcinogenicity:NONE
Effects of Overexposure:IRRITATION, HEADACHE, NAUSEA, DIZZINESS,
ITCHING, SWELLING/RASHES.

First Aid

First Aid:EYES: FLUSH W/CLEAN WATER FOR 15 MINS. SKIN: WASH THOROUGHLY
W/SOAP & WATER. INHALATION: REMOVE TO FRESH AIR. ADMINISTER OXYGEN
IF BREATHING IS DIFFICULT. INGESTION: IF CONSCIOUS GIVE MILK/WATER
TO DI LUTE. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Fire Fighting

Flash Point Method:TCC
Flash Point:51F (SUPP)
Extinguishing Media:WATER, CO2, DRY CHEMICAL, FOAM
Fire Fighting Procedures:WEAR SCBA & PROTECTIVE GEAR. COOL CONTAINERS
EXPOSED TO HEAT W/WATER SPRAY. FIGHT FROM SAFE DISTANCE/PROTECTED
AREA IF LARGE QUANTITIES INVOLVED.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS CAN BURST VIOLENTLY
WHEN HEATED. VAPORS ARE HEAVIER THAN AIR & MAY TRAVEL TO AN
IGNITION SOURCE.

Accidental Release

Spill Release Procedures:VENTILATE AREA & REMOVE IGNITION SOURCES.
LARGE: DIKE W/INERT ABSORBENT/SAND. SCRAPE UP & TRANSFER TO
IMPERMEABLE CONTAINERS FOR DISPOSAL. WASH AREA W/STRONG DETERGENT &
WATER.

Handling

Handling and Storage Precautions:STORE WELL CLOSED IN A COOL/DRY PLACE.
Other Precautions:AVOID CONTACT W/SKIN & EYES. AVOID BREATHING VAPORS.

Exposure Controls

Respiratory Protection:NONE NEEDED IN NORMAL USE. WEAR NIOSH APPROVED
ORGANIC VAPOR RESPIRATOR WHERE VAPOR CONCENTRATION EXCEEDS TLV.
Ventilation:EXPLOSION PROOF LOCAL EXHAUST FOR CONFINED AREAS/WHERE
LARGE QUANTITIES OF COMPOUND IN USE. GENERAL MECHANICAL: NORMAL.
Protective Gloves:CHEMICAL RESISTANT RUBBER/POLYETHYLENE
Eye Protection:SAFETY GLASSES W/SIDE SHIELDS
Other Protective Equipment:CHEMICAL RESISTANT GEAR
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE. WASH HANDS THOROUGHLY AFTER USE/BEFORE EATING/SMOKING.
Supplemental Safety and Health
PH: (5% BY WEIGHT IN WATER): ACIDIC. HEALTH HAZARDS CONT'D: CHRONIC
OVEREXPOSURE TO METHACRYLIC ACID CAUSES LIVER/KIDNEY
DAMAGE/CORROSIVE TO SKIN/EYES/POTENTIAL SENSITIZER. BOILING
POINT/VAPOR PRESSUR E/VAPOR DENSITY/FLASH POINT: INFORMATION
PROVIDED IS FOR METHYL METHACRYLATE, INHIBITED.

Chemical Properties

Boiling Pt:B.P. Text:214F (SUPP)
Vapor Pres:29 (SUPP)
Vapor Density:3.56(SUPP)
Spec Gravity:1.35
pH:(SUPP)
Evaporation Rate & Reference:(BU AC=1): 3
Solubility in Water: 5%
Appearance and Odor:THICK OFF-WHITE LIQUID W/PUNGENT ACRYLIC ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, REDUCING AGENTS, STRONG ACIDS, AMINES, ACTIVE METALS,
COPPER,
Stability Condition to Avoid:IGNITION SOURCES, STORAGE UNDER INERT
GASES, DIRECT MIXING W/ACTIVATOR COMPONENT OF KIT.
Hazardous Decomposition Products:OXIDES OF CARBON, TRACES OF HYDDROGEN
CHLORIDE, STYRENE, ACRYLATES.
Conditions to Avoid Polymerization:DIRECT MIXING OF ACTIVATOR INTO BULK
LIQUID ADHESIVE, EXTREME HEAT.

Disposal

Waste Disposal Methods:DISPOSE OF IAW/FEDERAL, STATE & LOCAL
REGULATIONS. D002

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.