Product ID:M8-038 GREY AQUA PRIME
MSDS Date:01/01/1987
FSC:8010
NIIN:00F003985
MSDS Number: BBPGD

Emergency Phone: (312) 376-7132

Cage: DO165

Telephone: 312-376-7132

Cage: 5V430

GLYCOL ETHERS (VAPOR PRESSURE = .88)

Fraction By Weight: 15%

ACGIH TLV: 25 PPM

Effects of Overexposure:HEADACHE, DIZZINESS, NAUSEA, LOSS OF
CONSCIOUSNESS. EYE IRRITATION.

First Aid:EYE: FLUSH W/WATER FOR 15 MINUTES. INHALATION: REMOVE VICTIM
TO FRESH AIR. INGESTION: INDUCE VOMITING. GIVE 1 OR 2 GLASSES OF
WATER. SKIN: FLUSH W/WATER WHILE REMOVING CONTAMINATED
CLOTHING/SHOES. FOL LOW BY WASHING W/SOAP & WATER. GET MED ATT.

Flash Point:168F SETA
Lower Limits:1.1%
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WATER MAY BE USED TO KEEP EXPOSED CONTAINERS
COOL. USE SCBA.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.

Spill Release Procedures:WARNING-COMBUSTIBLE. ELIMINATE ALL IGNITION
SOURCES. WEARING THE PROTECTIVE CLOTHINGUTLINED IN SECTION VIII,
SOAK UP W/AN ABSORBANT/PLACE IN NON-LEAKING CONINERS. SEAL TIGHTLY
FOR PROPER DISPOSAL.

Handling and Storage Precautions:TREAT AS ANY HAZARDOUS COMBUSTIBLE
MATERIAL, STORE IN A COOL, DRY PLACE IN BUILDINGS FOR THE SRAGE OF
COMBUSTIBLE LIQUIDS.

Respiratory Protection:NIOSH APPROVED ORGANIC VAPOR RESP WHERE
VENTILATION IS INADEQUATE.
Ventilation:PROVIDE ADEQUATE VENTILATION TO KEEP BELOW TLV.
Protective Gloves:RUBBER
Eye Protection:SAFETY GOGGLES
Other Protective Equipment:HAVE EYE BATH AVAILABLE
Supplemental Safety and Health
MSDS DATED: 18 NOV 1985. WGT PER GALLON: 10.57 PDS. FOR USE IN 2 PART
EPOXY, AQUA PRIMER UO-063.

Boiling Pt:B.P. Text:340F
Vapor Density:>AIR
Evaporation Rate & Reference:(N-BU AC = 1) 0.09
Appearance and Odor:GREY LIQUID
Percent Volatiles by Volume:25.5

Stability Indicator/Materials to Avoid:YES
INCOMPATABLE W/STRONG OXIDIZING AGENTS/STRONG ALKALIES_
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES AND
INCOMPATABILITIES ABOVE.
Hazardous Decomposition Products:CO/UNIDENTIFIED ORGANIC COMPS MAY
FORMED DURING COMBUSTION.
Conditions to Avoid Polymerization:_
_

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL, STATE AND FEDERAL REGULATION. CONTACT AN APPROVED DISPOSAL
FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.