BBPQL - DABCO T-12

Product Identification

Product ID:DABCO T-12
MSDS Date:01/01/1987
FSC:6810
NIIN:00F004164
MSDS Number: BBPQL

Responsible Party
AIR PRODUCT & CHEMICALS/ALLENTOWN, PA 18105

Emergency Phone: (800) 523-9374

Cage: 00742

Contractor
AIR PRODUCTS AND CHEMICALS INC
ALLENTOWN, PA 18195-1501 US

Telephone: 800-345-3148/ 800-752-1597

Cage: 00742

Ingredients

DIBUTYL TIN DILAURATE (AS TIN)

CAS: 77-58-7

RTECS: WH7000000

Fraction By Weight: >95%

OSHA PEL S, 0.1 MG/M3

ACGIH TLV: S, 0.1 MG/M3; 8990

Hazards

Effects of Overexposure:CONTAINERS PRESENT EXPLOSION/FIRE HAZARD EVEN
WHEN EMPTIED.

First Aid

First Aid:IN CASE OF CONTACT, IMMEDIATELY FLUSH SKIN/EYES WITH LARGE
QUANTITIES FOR WATER. EYES: USE FINGERS TO SEPARATE EYELIDS TO
INSURE ADEQUATE IRRIGATION. CLEANSE SKIN THOROUGHLY WITH SOAP AND
WATER. SEEK MEDICAL ATTENTION.

Fire Fighting

Flash Point:>400F (COC)
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER SPRAY/FOG
Fire Fighting Procedures:WEAR PROTECTIVE CLOTHING/SELF-CONTAINED
BREATHING APPARATUS.
Unusual Fire/Explosion Hazard:IRRITATING FUMES MAY DEVELOP WHEN PRODUCT
IS HEATED.

Accidental Release

Spill Release Procedures:AVOID DERMAL CONTACT. SKIN PROTECTION. ABSORB
OR SCRAPE UP.

Handling

Handling and Storage Precautions:DANGER! CAUSES BURNS. AVOID CONTACT
WITH SKIN, EYES AND CLOTHING. WASH THOROUGHLY AFTER HANDLI. KEEP
CONTAINER CLOSED.
Other Precautions:LAUNDER CONTAMINATED CLOTHING BEFORE RE-USE.

Exposure Controls

Respiratory Protection:FULL FACE MASK POSITIVE PRESSURE-DEMAND TYPE IF
GREATER TLV.
Ventilation:GENERAL AND LOCAL RECOMMENDED
Protective Gloves:NEOPENE
Eye Protection:GOGGLES
Other Protective Equipment:EMERGENCY EYE WASH AND SHOWER; RUBBER APRON
AND BOOTS.
Supplemental Safety and Health
MSDS DATE: AUG 1985.

Chemical Properties

Boiling Pt:B.P. Text:>205F
Vapor Pres:0.2
Spec Gravity:1.05
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:OILY, YELLOW LIQUID WITH FATTY ACID ODOR
Percent Volatiles by Volume:LOW

Stability

Stability Indicator/Materials to Avoid:YES
OXIDIZERS
Stability Condition to Avoid:ELEVATED TEMPERATURES

Disposal

Waste Disposal Methods:DISPOSE IN APPROVED LANDFILL

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.