BCNBV - SYSTEM THREE EPOXY RESIN

  • MSDS: BCNBV
  • Manufacturer: SYSTEM THREE RESINS
  • Product Name: SYSTEM THREE EPOXY RESIN
  • National Stock Number: 8030-00N006564
Product Identification

Product ID:SYSTEM THREE EPOXY RESIN
MSDS Date:05/01/1987
FSC:8030
NIIN:00N006564
Kit Part:Y
MSDS Number: BCNBV

Responsible Party
SYSTEM THREE RESINS
1155 N W 48TH STREET
SEATTLE, WA 98107
US

Emergency Phone: 206-782-7976

Info Phone: 206-782-7976

Cage: OO286

Contractor
SYSTEM THREE RESINS
70436 SEATTLE, WA 98107 US

Telephone: 206-782-7976

Cage: OO286

Ingredients

EPICHLOROHYDRIN (ECH)

CAS: 106-89-8

Fraction By Weight: <50%

OSHA PEL S, 5 PPM

ACGIH TLV: S, 2 PPM; 9293

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS

Hazards

LD50 LC50 Mixture:LD50:(RATS) >8000 MG/KG
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:LIQUID IS VERY IRRITATING TO SKIN &
EYES. MAY PRODUCE SKIN SENSITIZATION & OTHER ALLERGIC RESPONSES.
Explanation of Carcinogenicity:EPICHLOROHYDRIN: GROUP 2A,IARC, VOL 7,
P.202, 1987; ANTIC TO BE CARCIN, NTP 6TH ANNUAL RPT ON CARCINOGENS,
1991..
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES:FLUSH W/WATER FOR AT LEAST 15 MINS WHILE HOLDING EYELIDS
OPERN. GEET MEDICAL ATTENTION. SKIN:WIPE EXCESS OFF. WASH W/SOAP &
WATER OR WATERLESS HAND CLEANER FOLLOWED BY SOAP & WATER. DO NOT
USE SO LVENTS. INHAL:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE
ARTIFICIAL RESPIRATION/OXYGEN). CALL MD . INGEST:CALL MD
IMMEDIATELY .

Fire Fighting

Flash Point:>400F,>204C
Extinguishing Media:WATER, FOAM OR CARBON DIOXIDE.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE.

Accidental Release

Spill Release Procedures:TAKE UP W/ABSORBENT MATERIAL & DISPOSE OF
PROPERLY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORAGE BELOW 80F MAY CAUSE HARMLESS
CRYSTALIZATION. HEATING TO NO MORE THAN 140F WILL MELT CRYSTALS.
STORE AWAY FROM OPEN FLAMES & HIGH TEMPERATURES.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Exposure Controls

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:USE W/ADEQUATE VENTILATION.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD
Other Protective Equipment:PROTECTIVE CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:0

Stability

Stability Indicator/Materials to Avoid:YES
AMINES UNDER UNCONTROLLED CONDITIONS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON DIOXIDE AND CARBON MONOXIDE.
Conditions to Avoid Polymerization:AMINES UNDER UNCONTROLLED
CONDITIONS.

Disposal

Waste Disposal Methods:APPROPRIATE DISPOSAL FACILITY IN COMPLIANCE
W/LOCAL REGULATIONS. DISPOSAL MUST BE IN ACCORDANCE W/FEDERAL,
STATE & LOCAL REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.