Product ID:PLA
MSDS Date:09/12/1986
FSC:8010
NIIN:00N009772
MSDS Number: BCTGG

Emergency Phone: 213-664-2121

Info Phone: 213-888-8888

Cage: SNCLA

Telephone: 213-664-2121

Cage: SNCLA

STODDARD SOLVENT

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: Fraction by Wt

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293

LD50 LC50 Mixture:
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SEE SIGNS AND SYMPTOMS OF
OVEREXPOSURE.
Effects of Overexposure:MAY CAUSE EYE,NOSE THROAT OR SKIN
IRRITATION,MAY CAUSE,HEADACHE,NAUSEA,DIZZINESS,LASSITUDE,OR LOSS OF
COORDINATION OR CONSCIOUSNESS.CHRONIC
Medical Cond Aggravated by Exposure:

First Aid:REMOVE TO FRESH AIR,GIVE ARTIFICAL RESPIRATION IF BREATHING
HAS STOPPED.FLUSH EXPOSED EYES W/ FRESH WATER FOR 15 MINUTES.CHANGE
CONTAMINATED CLOTHING.WASH SKIN W/ SOAP & WATER.DO NOT INDUCE
VOMITING.K EEP HEAD LOWER THAN WAIST.ASPIRATION OFVOMITUS MAY CAUSE
CHEMICAL PNEUMONITIS. CALL A PHYSICIAN.

Flash Point:105 F;40.56 C.
Lower Limits:
Upper Limits:
Extinguishing Media:FOAM CHEMICAL OR CO*2
Fire Fighting Procedures:AVOID CONFINED SPACE UNLESS WEARING FULL
BUNKER GEAR,POS PRESS NIOSH SCBA RECOM. H*2O UNSUITABLE.HELP TO
COOL UNRUPTERED CONTR.BURN MAT MAY SPREAD/FLOAT ON H*2O
Unusual Fire/Explosion Hazard:VAPORS ARE HEAV.THAN AIR & MAY ACCUMULATE
IN LOW AREA OF POOR VENT TRAVEL ALONG GROUND TO IGNIT SITES.CLOSED
CONTR CAN BUILD UP PRESSURE WHEN EXPOSED TO HEAT

Spill Release Procedures:REMOVE SOURCES OF HEAT OR IGNITION.WEAR
APPROPRIATE CLOTHING & GEAR CLEAN UP SPILLS IMEDIATELY W/
ASBORBANTS SUCH AS CLAY,SAND OR OTHER SUITABLE MATERIALS.
Neutralizing Agent:

Handling and Storage Precautions:KEEP COOL,DRY & AWAY FROM HEAT,SPARK
OR FLAME(ALL IGNITION SOURCES).STORE IN WELL VENT PLACE.KEEP CONTR
CLOSED WHEN NOT IN USE.
Other Precautions:AVOID EXCESSIVE PERSONAL EXPOSURE.GROUND ALL TRANSER
CONTAINER & EQUIPMENT.DO NOT WELD.DRILL,CUT,GRIND ANY FULL,PARTIAL
OR EMPTY CONTR.CRESIDUE W ADEQUATE VENTILATION

Respiratory Protection:AVOID EXCESSIVE VAPOR INHALATIO.IF TLV IS
EXCEED,USE A NIOSH-APPROVED RESPIRATOR OR SCBA.USE A MECH FILTER TO
REMOVE SOLID ARRBORNE PARTICLES DURING SPRAY APPLICATION.
Ventilation:GEN MECH VENT MAY BE SUFFICIENT TO KEEP EXPOSURE BELOW
TLV.EXPLOSION-PROOF VENT IS RECOM.FOR ALL FLAMMABLE MATERIAL.
Protective Gloves:NEOPRENE GLOVES,AS NEEDED.
Eye Protection:SAFETY GLASSE GOGGLES/FACESHLD AS NEEDED
Other Protective Equipment:EYE WASH & SAFETY SHOWER AS NEEDED.
Work Hygienic Practices:OBSEV GOOD WORK HYGIENIC PRACTICES
Supplemental Safety and Health
WT PER GALLON 7.4-7.7 LB

Boiling Pt:B.P. Text:300-394
Melt/Freeze Pt:M.P/F.P Text:
Decomp Temp:Decomp Text:
Vapor Pres:
Vapor Density:
Spec Gravity:
pH:
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:
Appearance and Odor:
Percent Volatiles by Volume:58-60
Corrosion Rate:

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS,STRON ACIDS & BASES,SELECTE AMINES
Stability Condition to Avoid:HEAT, SPARKS OR FLAME
Hazardous Decomposition Products:CARBON MONOXIDE,CARBON
DIOXIDE,UNIDENTIFIED ORGANIC COMPOUNDS

Waste Disposal Methods:PLACE IN NON-LEAKING CONTAINERS & DISPOSE OF IN
ACCORDANCE W/ APPLICABLE LOCAL,COUNTY,STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.