BDWDX - ENAMEL,DECK,GRAY,EXTERIOR

  • MSDS: BDWDX
  • Manufacturer: VAN WATERS AND ROGERS
  • Product Name: ENAMEL,DECK,GRAY,EXTERIOR
  • National Stock Number: 8010-00-297-2100
Product Identification

Product ID:ENAMEL,DECK,GRAY,EXTERIOR
MSDS Date:01/01/1985
FSC:8010
NIIN:00-297-2100
MSDS Number: BDWDX

Responsible Party
VAN WATERS AND ROGERS
2256 JUNCTION AVE
SAN JOSE, CA 95131
US

Emergency Phone: 408-435-8700/800-424-9300(CHEMTREC)

Info Phone: 408-435-8700

Cage: OAN91

Contractor
VAN WATERS AND ROGERS (408-435-8700)
5932 SAN MATEO, CA 90061-1001 US

Telephone: 415-573-8000

Cage: OAN91

Ingredients

PIGMENTS

Fraction By Weight: 39%


VEHICLE

Fraction By Weight: 30%


NAPHTHA (PETROLEUM SPIRITS OR BENZIN)

CAS: 8030-30-6

RTECS: SE7555000

Fraction By Weight: 31%

OSHA PEL 100 PPM

Hazards

Effects of Overexposure:EYE,THROAT,SKIN,LUNG
IRRITANT,DIZZINESS,HEADACHE,NAUSEA

First Aid

First Aid:WASH SKIN THOROUGHLY FLUSH EYES WITH WATER,REMOVE TO FRESH
AIR,REMOVE CONTAMINATED CLOTHING GIVE ARTIFICIAL RESPIRATION IF
NEEDED,CALL DOCTOR

Fire Fighting

Flash Point:104F,40.0C TCC
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:FOAM,DRY CHEMICAL,FOG,CARBON DIOXIDE
Fire Fighting Procedures:USE AIR SUPPLIED RESCUE EQUIPMENT FOR ENCLOSED
AREAS
Unusual Fire/Explosion Hazard:AVOID FIRE,HEAT,SPARKS,IGNITION
SOURCES,STORAGE IN DIRECT SUNLIGHT

Accidental Release

Spill Release Procedures:VENTILATE AREA MECHANICALLY,KEEP FROM
FLAME,FIRE,SPARKS,IGNITION SOURCES;DO NOT BREATHE VAPORS;CLEAN UP
WITH ABSORBENT MATERIAL.LARGE SPILLS MAY BE SCOOPED UP WITH
NONSPARKING TOOLS.

Handling

Handling and Storage Precautions:KEEP CONTAINERS CLOSED.STORE AND USE
AWAY FROM HIGH TEMPERATURE,SPARKS,OPEN FLAME.GROUND CONTAINERS WHEN
POURING AND LIMIT FREE-FALL TO FEW INCHES
Other Precautions:AVOID PROLONGED OR REPEATED BREATHING OF VAPOR OR
CONTACT WITH SKIN.RESIN ACCUMULATIONS MAY SPONTANEOUSLY
IGNITE:IMMERSE ACCUMULATIONS IMMEDIATELY IN WATER

Exposure Controls

Supplemental Safety and Health
154.4C-187.8C AND
PLASTICS
INSOLUBLE RUBBER OR PLASTIC

Chemical Properties

HCC:F4

Disposal

Waste Disposal Methods:PLACE IN CLOSED CONTAINERS.RAGS AND ABSORBENT
MATERIAL SHOULD BE IMMERSED IN WATER.USE SANITARY LANDFILLS IN
ACCORDANCE WITH LOCAL,STATE AND FEDERAL REGULATIONS.RUN OFF TO
WATERWAY CREATES FIRE HAZAR D-NOTIFY FIRE AND HEALTH AGENCIES

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.