BFDWJ - S-8385
- MSDS: BFDWJ
- Manufacturer: TLC MANUFACTURING INC
- Product Name: S-8385
- National Stock Number: 6850-00-550-5565
Product Identification
Product ID:S-8385
MSDS Date:01/01/1987
FSC:6850
NIIN:00-550-5565
MSDS Number: BFDWJ
Responsible Party
TEXARKANA, TX 75501-6649
US
Emergency Phone: NONE
Cage: LO570
Contractor
Cage: 1ED11
Ingredients
SODIUM HYDROXIDE (SARA III)
CAS: 1310-73-2
RTECS: WB4900000
Fraction By Weight: <53%
OSHA PEL 2 MG/M3
ACGIH TLV: C 2 MG/M3; 9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
TRISODIUM SALT OF N-HYDROXYETHYLENEDIAMINETRIACETIC ACID
CAS: 150-39-0
RTECS: MB9185000
Fraction By Weight: >13%.
SODIUM GLUCONATE
Fraction By Weight: >25%.
FOAMERS (AND OTHERS)
Fraction By Weight: <7%.
PHOSPHORUS AND SILICA
Fraction By Weight: <0.3%
Hazards
Effects of Overexposure:CAUSE SEVERE IRRITATION AND DAMAGE TO EYES AND
SKIN UPON CONTACT.
First Aid
First Aid:REMOVE TO FRESH AIR; GET MEDICAL ATTENTION;GIVE CPR OR OXYGEN
IF NEED. IF CONTACT,FLUSH W. H*2O FOR 15 MIN. SPEED OF REMOVAL IS
CRITICAL. REMOVE & ISOLATE CONTAMINATED CLOTHING. KEEP WARM &
QUIET.EFFE CTS MAY BE DELAYED; OBSERVE VICTIM.
Fire Fighting
Flash Point:NONE
Extinguishing Media:EXTINGUISH WITH AGENT SUITABLE FOR SURROUNDING FIRE
Accidental Release
Spill Release Procedures:NEUTRALIZE WITH 5% ACETIC ACID SOLUTION.ABSORB
AND STORE IN DISPOSAL TANK OR DISPOSAL CONTAINERS.
Handling
Handling and Storage Precautions:STORE IN COOL,DRY,WELL VENT,LOW FIRE
RISK AREA. PROTECT FROM PHYSICAL DAMAGE.AVOID ANY PHYSICAL CONTACT.
KEEP CONTAINERS TIGHTLY CLOSED.
Other Precautions:KEEP AWAY FROM ACIDS AND AMMONIA
Exposure Controls
Respiratory Protection:NONE
Ventilation:NO SPECIAL REQUIREMENTS W ADEQUATE VENT.
Protective Gloves:RUBBER/NEOPRENE
Eye Protection:SAFETY/CHEM GOGGLES
Other Protective Equipment:FULL PROTECTIVE CLOTHING,SAFETY SHOWER,EYE
WASH STATION
Supplemental Safety and Health
UNDATED MSDS/
Chemical Properties
HCC:B1
Appearance and Odor:A FREE FLOWING WHITE POWDER
Stability
Stability Indicator/Materials to Avoid:YES
STRG AC,AMMONIA,READILY OXIDIZABLE MTLS,ALUMINUM,SOFT MTLS.
Stability Condition to Avoid:STORE BELOW 100F
Hazardous Decomposition Products:IRRITATING GASES.
Disposal
Waste Disposal Methods:KEEP IN COVERED DRUMS,PENDING DISPOSAL. HANDLE &
DISPOSE IN FULL COMPLIANCE WITH ALL APPLICABLE
INTERNATIONAL,FEDERAL,STATE, & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.