BFYCY - R-22
- MSDS: BFYCY
- Manufacturer: CHEMTRONICS INC
- Product Name: R-22
- National Stock Number: 6830-00-935-9896
Product Identification
Product ID:R-22
MSDS Date:08/01/1987
FSC:6830
NIIN:00-935-9896
MSDS Number: BFYCY
Responsible Party
KENNESAW, GA 30144
US
Emergency Phone: 404-424-4888
Info Phone: 404-424-4888
Preparer: HAL ALPER
Cage: 2M589
Contractor
Telephone: 770-424-4888/800-645-5244
Cage: 2M589
Ingredients
CHLORODIFLUOROMETHANE
CAS: 75-45-6
RTECS: PA6390000
Fraction By Weight: 100%
OSHA PEL 1000 PPM
ACGIH TLV: 1000PPM; 9192
Hazards
LD50 LC50 Mixture:2 HOUR LC50 RATS IS 300,000 PPM
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:PRODUCT IS NEITHER CORROSIVE NOR AN
IRRITANT. IT WILL DEFAT & DRY SKIN,POSSIBLY CAUSING DERMATITIS.
VAPOR IS HEAVIER THAN AIR AND CAN CAUSE SUFFOCATION BY REDUCING
OXYGEN AVAILABLE FOR BREATHING. HIG H EVAPORATION RATE MAY COOL
TISSUES SUFFICIENTLY TO CAUSE FROSTBITE.
Explanation of Carcinogenicity:PRODUCT IS NOT LISTED AS A CARCINOGEN BY
IARC, NTP OR OSHA.
Effects of Overexposure:BREATHING HIGH CONCENTRATIONS OF VAPOR MAY
CAUSE LIGHT-HEADEDNESS, GIDDINESS, SHORTNESS OF BREATH, AND MAY
LEAD TO NARCOSIS, CARDIAC IRREGULARITIES, UNCONSCIOUSNESS OR DEATH.
LIQUID CAN CAUSE DEFATTIN G OF TISSUE.
Medical Cond Aggravated by Exposure:SKIN DISEASE - PRODUCT IS A
DEFATTING AGENT AND CAN CAUSE DERMATITIS ON PROLONGED EXPOSURE.
PERSONS WITH PRE-EXISTING SKIN DISORDERS MAY BE MORE SUSCEPTIBLE TO
THE EFFECTS OF THIS AGENT.
First Aid
First Aid:EYE:FLUSH W/ WATER 15 MIN HOLD LIDS OPEN SEE A DOCTOR.
SKIN:WASH WITH SOAP & WATER. TREAT FOR FROST-BITE IF NEEDED.
INHALED:REMOVE TO FRESH AIR. RESTORE BREATHING, AS NEEDED. DO NOT
GIVE EPINEPHRINE OR SIMILAR DRUGS. INGESTED:DO NOT INDUCE
VOMITING. GET IMMEDIATE MEDICAL CARE. IF IRRITATION PERSISTS,OR
IS SEVERE,SEE A DOCTOR.
Fire Fighting
Flash Point:NON-FLAMMABLE
Lower Limits:NONE
Upper Limits:NONE
Extinguishing Media:PRODUCT IS NON FLAMMABLE. EXTINGUISH FIRE WITH
MEDIA APPROPRIATE FOR SOURCE OF FIRE.
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER
SPRAY TO COOL NEARBY CONTAINERS EXPOSED TO FIRE.
Unusual Fire/Explosion Hazard:CYLINDER MAY RUPTURE UNDER FIRE
CONDITIONS. FIRE OR EXCESSIVE HEAT MAY CAUSE PRODUCTION OF
HAZARDOUS DECOMPOSITION PRODUCTS.
Accidental Release
Spill Release Procedures:VENTILATE AREA. DO NOT FLUSH INTO SEWERS.
COLLECT ON ABSORBENT MATERIAL AND TRANSFER TO STEEL DRUMS FOR
RECOVERY OR DISPOSAL.
Neutralizing Agent:NONE
Handling
Handling and Storage Precautions:STORE IN A CLEAN, COOL (BELOW 125F),
DRY AND WELL-VENTILATED AREA OF LOW FIRE RISK. PROTECT CONTAINERS
FROM PHYSICAL DAMAGE AND KEEP CLOSED.
Other Precautions:TANK-CLEANING PERSONNEL SHOULD USE ONLY FORMAL TANK
ENTRY PROCEDURE BASED ON RECOGNIZED SAFETY PRINCIPLES. APPLY ALL
SAFETY PRECAUTIONS TO EMPTY CONTAINERS AS THEY MAY CONTAIN PRODUCT
RESIDUES/VAPORS.
Exposure Controls
Respiratory Protection:RESPIRATOR WILL NOT NORMALLY BE NECESSARY. USE
NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR OR SELF CONTAINED
BREATHING APPARATUS IF EXPOSURE IS ABOVE THE TLV/PEL. SEE 29 CFR
1910.134 FOR REGULATIONS PERTAINING TO RESPIRATOR USE.
Ventilation:PROVIDE LOCAL EXHAUST AT FILLING ZONES AND OTHER OPERATING
SPACES WHERE LEAKAGE IS PROBABLE. MECHANICAL FOR OTHER.
Protective Gloves:LINED BUTYL RUBBER, PVA OR NEOPRENE
Eye Protection:SAFETY GLASSES OR SPLASH GOGGLES
Other Protective Equipment:USE IMPERVIOUS CLOTHING IF THERE IS DANGER
OF REPEATED OR PROLONGED CONTACT WITH LIQUID.
Work Hygienic Practices:USE GOOD CHEMICAL HYGIENE PRACTICE. AVOID
CONTACT. REMOVE AND WASH CLOTHING PROMPTLY UPON CONTAMINATION.
Supplemental Safety and Health
Chemical Properties
HCC:G3
Boiling Pt:B.P. Text:-41.4F,-41C
Melt/Freeze Pt:M.P/F.P Text:-256F,-160C
Vapor Pres:138 PSIG
Vapor Density:2.98
Spec Gravity:1.194
Solubility in Water:0.30%
Appearance and Odor:CLEAR-COLORLESS GAS, SLIGHT ETHEREAL ODOR
Percent Volatiles by Volume:100
Stability
Stability Indicator/Materials to Avoid:YES
ALKALI OR ALKALINE EARTH METALS, AND POWDERED ALUMINUM,ZINC,BERYLLIUM,
ETC.
Stability Condition to Avoid:HIGH TEMPERATURES, SPARKS, AND OPEN FLAMES
Hazardous Decomposition Products:DECOMPOSED BY HIGH TEMPERATURES (OPEN
FLAMES, GLOWING METAL SURFACES, ETC.) FORMING HYDROCHLORIC AND
HYDROFLUORIC ACIDS.
Disposal
Waste Disposal Methods:DISPOSE I/A/W ALL FEDERAL, STATE AND LOCAL
REGULATIONS. MANUFACTURER SUGGESTS THAT RECLAIMATION BY
DISTILLATION OR DISPOSAL BY A PERMITTED FACILITY.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.