Product ID:0151,EPOXY PATCH KIT PART A
MSDS Date:03/17/1987
FSC:8040
NIIN:01-066-6442
Kit Part:Y
MSDS Number: BGKCF

HYSOL DIV DEXTER CORP

15051 E DON JULIAN RD
INDUSTRY, CA 91749
US

Emergency Phone: 510-687-4201

Info Phone: 818-968-6511

Cage: 12405

DEXTER CORP DEXTER ELECTRONIC MATERIALS DIV

LA PUENTE, CA 91746 US

Telephone: 818-968-6511

Cage: 12405

N-BUTYL GLYCIDYL ETHER (BGE)

CAS: 2426-08-6

RTECS: TX4200000

Fraction By Weight: <10%

OSHA PEL 50 PPM

ACGIH TLV: 25 PPM; 9293

SILICA, AMORPHOUS, DUST

CAS: 112945-52-5

RTECS: VV7310000

Fraction By Weight: <5%

OSHA PEL 6 MG/M3

ACGIH TLV: 10 MG/M3; 8990

LD50 LC50 Mixture:N/K
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE SKIN IRRITATION & POSSIBLE
ALLERGIC REACTIONS. PROLONGED & REPEATED CONTACT MAY CAUSE
SENSITIZATION WHICH WILL RESULT IN ALLERGIC REACTIONS. RGE IS
MUTAGENIC IN VITRO. MUTAGENICITY TESTING I N MICE GAVE MIXED
RESULTS.
Explanation of Carcinogenicity:NOT APPLICABLE
Effects of Overexposure:SKIN RASH/IRRITATION

First Aid:EYE:IMME FLUSH W/LGE AMTS OF WTR FOR AT LEAST 15MIN.SKIN:WASH
THOROUGHLY W/SOAP & WTR,RUBBING ALCOHOL,/HAND CLEANER.DO NOT USE
SOLVENTS.IF TRRI PERSISTS,SEE PHYS. INGESTION:CALL MD IMMEDIATELY(F
P N). INHALATION:REMOVE FROM EXPOSURE. SUPPORT BREATHING (GIVE
O*2/ARTIFICAL RESPIRATION).

Flash Point:200F/93.3C
Lower Limits:0.4
Upper Limits:1.3
Extinguishing Media:DRY CHEMICAL/HALON FIRE EXINGUISHER,/WTR
SPRAY,FOAM/FOG
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:DENSE SMOKE & TOXIC GASSES MAY BE
LIBERATED

Spill Release Procedures:SCRAPE UP & TRANSFER TO METAL CONTAINER. WIPE
UP REMAINING RESIDUE W/SOLVENTS,OBSERVING SOLVENT FLAMMABILITY
CAUTIONS,/USE DETERGENT.
Neutralizing Agent:N/K

Handling and Storage Precautions:KEEP COOL IN ACCORDANCE WITH LABEL
INSTRUCTIONS.
Other Precautions:FOLLOW RECOMMENDED CURING SCHEDULE.

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:LOCAL EXHAUST & MECHANICAL VENTILATION ARE RECOMMENDED
Protective Gloves:PLASTIC/RUBBER
Eye Protection:SAFETY GLASSES OR GOGGLE
Other Protective Equipment:SAFETY SHOWER & EYE BATH.COVERALLS OR APRON
FOR SKIN PROT.
Supplemental Safety and Health
PCT VOLT-VOL: PH:N. COND TO AVD(POLYM): BOND. FAILURE TO OBSV CAUT MAY
RESULT IN EXCES HEAT BLD-UP W/RLEAS OF TOX GAS. KEY1:J1.

HCC:V7
Boiling Pt:B.P. Text:284F/140C
Melt/Freeze Pt:M.P/F.P Text:N/APPLICABL
Decomp Temp:Decomp Text:N/K
Vapor Pres:<2
Vapor Density:3.8
Spec Gravity:1.15
pH:N/K-FP
Evaporation Rate & Reference:>1.0(BUAC)
Solubility in Water:<1%
Appearance and Odor:TRANSLUCENT,THIXOTROPIC LIQ,W/SWEET ODOR
Percent Volatiles by Volume:N/K-FP
Corrosion Rate:

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG LEWIS/MINERAL ACIDS
Stability Condition to Avoid:N/K
Hazardous Decomposition Products:CO, NO*X, ALDEHYDES, ACIDS &
UNDETERMINED ORGANICS.
Conditions to Avoid Polymerization:AVOID MIX RSIN & CURNG AGENT IN
BATCH >1 LB TOTAL.DO NOT HEAT MXD ADHES ABV 150F/65.6C UNLSS CURNG
SURFCE TO BE(SUP DAT)

Waste Disposal Methods:DISPOSE OF AS HAZARDOUS WASTE ACCORDING TO DOT
HAZARD CLASS. IF NOT REGULATED BY DOT DISPOSE OF AS ORM-E DISPOSAL
METHOD CAN BE LAND BURIAL/CHEMICAL INCINERATION(MFR).DISPOSE OF IAW
LOCAL,STATE, & FED ERAL REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.