BHBZV - ALKYD RESIN, VARNISH
- MSDS: BHBZV
- Manufacturer: FARWEST PAINT MANUFACTURING CO
- Product Name: ALKYD RESIN, VARNISH
- National Stock Number: 8010-00-180-6343
Product Identification
Product ID:ALKYD RESIN, VARNISH
MSDS Date:07/31/1987
FSC:8010
NIIN:00-180-6343
MSDS Number: BHBZV
Responsible Party
TUKWILA, WA 98168
US
Emergency Phone: (206) 941-1619
Info Phone: (206) 244-8844
Cage: 2F266
Contractor
Telephone: 206-244-8844
Cage: 6F266
Ingredients
RESIN/VEHICLE (VAPOR PRESSURE 2.0 MMHG @ 68F)
Fraction By Weight: 48-53%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
MINERAL SPIRITS (VAPOR PRESSURE 2.0 MMHG @ 68F)
Fraction By Weight: 45-50%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
2-BUTOXYETHANOL
CAS: 111-76-2
RTECS: KJ8575000
Fraction By Weight: 2-7%
OSHA PEL S, 50 PPM
ACGIH TLV: S, 25 PPM; 9293
METAL SOAP DRIES (VAPOR PRESSURE 2.0 MMHG @ 68F)
Fraction By Weight: <1%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
SURFACTANTS
Fraction By Weight: <25%
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Effects of Overexposure:EYES:SEVERE IRRITATION,REDNESS,TEARING,BLURRED
VISION. SKIN:PROLONGED/REPEATED CONTACT CAN CAUSE MODERATE
IRRITATION,DEFATTING,DERMATITIS. BREATHING:EXCESSIVE INHALATION OF
VAPORS CAN CAUSE NASAL & RE SPIRATORY
IRRITATION,DIZZINESS,WEAKNESS,FATIGUE,NAUSEA,HEADACHE,POSSIBLE
UNCONSCIOUSNESS EVEN ASPHYXIATION.
Medical Cond Aggravated by Exposure:SWALLOWING CAN CAUSE
GASTROINTESTINAL IRRITATION NAUSEA,VOMITING AND DIARRHEA,
ASPIRATION OF MATERIAL INTO THE LUNGS CAN CAUSE CHEMICAL
PNEUMONITIS WHICH CAN BE FATAL.
First Aid
First Aid:SKIN:THOROUGHLY WASH EXPOSED AREA W/SOAP & WATER. REMOVE
CONTAMINATED CLOTHING,LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.EYES:FLUSH W/LARGE AMOUNTS OF WATER,LIFTING EYELIDS OFTEN,GET
MEDICAL ATTENTIO N. SWALLOWING:DONOT INDUCE VOMITING,KEEP PERSON
WARM,QUIET & GET MEDICAL ATTN. INHALATION:IF AFFECTED,REMOVE PERSON
TO FRESH AIR. DIFFICULT BREATHING,GIVE OXYGEN.BREATHING
STOPPED,ARTIFICAL RESP.
Fire Fighting
Flash Point Method:TCC
Flash Point:108F/42.2C
Lower Limits:1.0
Extinguishing Media:FOAM,CO2,DRY CHEMICAL.
Fire Fighting Procedures:SELF-CONTAINED BREATHING APPARATUS WITH A FULL
FACEPIECE OPERATED IN PRESSURE DEMAND OR OTHER POSITIVE PRESSURE
MODE.
Unusual Fire/Explosion Hazard:NEVER USE NEAR OR AROUND WELDERS OR
CUTTING TORCHES,DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST
RESIDUE) CAN IGNITE EXPLOSIVELY.
Accidental Release
Spill Release Procedures:SMALL SPILL:ABSORB LIQUID ON PAPER,
VERMICULITE, FLOOR ABSORBENT. LGE SPILL:ELIMINATE ALL IGNITION
SOURCES.PERSONS NOT WEARING PROTECTIVE EQUIPMENT ARE EXCLUDED FROM
AREA UNTIL CLEANUP COMPLETED.PREVE NT RUN. IF RUNOFF NOTIFY PROPER
AUTHORITIES.
Handling
Handling and Storage Precautions:RESPIRATORY PROTECTION: IF TLV
EXCEEDED A NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR IS
ADVISED.ENGR/ADMINISTRATIVE CONTROLS SHOULD BE IMPLEMENTED.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTIED, SINCE EMPTY CONTAINERS RETAIN PRODUCT RESIDUES (VAPOR,
LIQUID, AND/OR SOLID)ALL HAZARD PRECAUTIONS GIVEN IN DATA SHEET
MUST BE OBSERVED.
Exposure Controls
Respiratory Protection:IF TLV OF PRODUCT OR ANY COMPONENT IS EXCEEDED,
A NIOSH/MSHA JOINTLY APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN
ABSENCE OF PROPER ENVIRONMENTAL CONTROL OSHA REG ALSO PERMIT OTHER
NIOSH/MSHA RESPIR ATORS UNDER SPECIFIED CONDITIONS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:RESISTANT GLOVES SUCH AS NITRILE RUBBER.
Eye Protection:CHEMICAL SPLASH GOGGLES RECOMMENDED.
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:KEEP WORK AREA CLEAN AND FREE FROM LEAKS AND
SPILLS. WASH HANDS THOROUGHLY W/SOAP & WATER BEFORE HANDLING FOOD &
DRINK.
Supplemental Safety and Health
ENGINEERING OR ADMINISTRATIVE CONTROLS SHOULD BE IMPLEMENTED TO REDUCE
EXPOSURE.
Chemical Properties
Boiling Pt:B.P. Text:300F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:TRANSLUCENT GREEN THIN LIQUID WITH A MILD SWEET
AROMATIC ODOR.
Percent Volatiles by Volume:56.72
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:KEEP AWAY FROM OPEN FLAMES,SPARKS AND
HEAT. DO NOT WELD NEAR OR AROUND PRODUCT.
Conditions to Avoid Polymerization:KEEP AWAY FROM OPEN FLAMES, SPARKS,
AND HEAT. DO NOT WELD NEAR OR AROUND PRODUCT.
Disposal
Waste Disposal Methods:DESTROY BY LIQUID INCINERATION, CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN A LANDFILL IN ACCORDANCE WITH
LOCAL,STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.