BHDHQ - ENAMEL INT EXT ALKYD WHITE 17875 ID 761701

  • MSDS: BHDHQ
  • Manufacturer: PRATT AND LAMBERT INC
  • Product Name: ENAMEL INT EXT ALKYD WHITE 17875 ID 761701
  • National Stock Number: 8010-00-286-7744
Product Identification

Product ID:ENAMEL INT EXT ALKYD WHITE 17875 ID 761701
MSDS Date:06/05/1989
FSC:8010
NIIN:00-286-7744
MSDS Number: BHDHQ

Responsible Party
PRATT & LAMBERT, INC.
16116 E 13TH ST
WICHITA, KS 67201
US

Preparer: W.A. ELLISON

Cage: FO127

Contractor
PRATT AND LAMBERT INC
22 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

Ingredients

MINERAL SPIRITS

CAS: 64475-85-0

RTECS: PY8240000

Fraction By Weight: 10%

OSHA PEL 500 PPM 2950 MG/CU.M

ACGIH TLV: 100 PPM 525 MG/CU.M.


TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 25%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


LEAD (SARA III)

CAS: 7439-92-1

RTECS: OF7525000

Fraction By Weight: <1%

OSHA PEL 0.05 MG/M3;1910.1025

ACGIH TLV: 0.15 MG/M3;DUST 9192

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB


VOC. ORGANIC CMPD 3.61 LB/GL LESS WATER & NPRS* 433 G/L

RTECS: 9999999VO

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHRONIC OVEREXPOSURE TO LEAD MAY
RESULT IN SEVERE DAMAGE TO BLOOD FORMING, NERVOUS, URINARY, AND
REPOR SYSTEMS. COMMON SYMPTOMS INCL LOOS OF APPETITE, METALLIC
TASTE IN MOUTH, ANXIETY, CONSITPATION, N AUSEA, WEAKNESS, INSOMNIA,
HEADACHE, MUSCLE AND JOINT PAIN FINE TREMORS, NUMBNESS, DIZZINESS,
HYPERACTIVITY AND COLIC.
Effects of Overexposure:SWALLOWING:GASTROINTESTINAL IRRITATION,
NAUSEA,VOMITING. ASPIRATION INTO LUNG CAN BE FATAL. INHAL: MAY
CAUSE NOSE/THROAT IRRITATION. HIGH CONCENTRATIONS MAY CAUSE ACUTE
CENTRAL NERVOUS SYS DEPRESSION CHARACTERIZED BY HEADACHES,
DIZZINESS, NAUSEA AND CONFUSION. EYE:IRRITATION SKIN: DEFATTING AND
IRRITATION OF THE SKIN.
Medical Cond Aggravated by Exposure:PREXISTING KIDNEY CONDITIONS MAY BE
AGGRAVATED BY EXPOSURES TO LEAD. INTENTIONAL MISUSE BY DELIVERATELY
CONCENTRATING AND INHALING THE CONTENTS MAYBE HARMFUL OR FATAL.

First Aid

First Aid:SWALLOWING: DO NOT INDUCE VOMITING. GET MED ATTN: INHALATION:
REMOVE TO FRESH AIR IMMED. IF BREATHING HAS STOPPED GIVE CPR. GET
MED ATTN: EYE: FLUSH WITH LARGE AMOUNTS OF WATER LIFTING UPPER AND
LOW ER LIDS FOR 15 MIN. SKIN: REMOVE CONTAMINATED CLOTHING. WASH
AFFECTED AREA W/SOAP AND WATER. OBTAIN MEDICAL ATTENTION
IFIRRITATION PERSISTS. TREATMENT SHOULD BE DIRECTED AT CONTROL OF
SYMPTOMS.

Fire Fighting

Flash Point Method:SCC
Flash Point:>104F/40.56C
Extinguishing Media:NFPA CL B FIRE EXT. POLYMER FOAM FOR LARGE FIRES
Fire Fighting Procedures:WEAR SELF CONTAINED BREATHING APPARATUS. WATER
MAY BE INNEFECTIVE, BUT MAY BE USED TO PREVENT PRESSURE BUILD-UP.
IF WATER IS USED, FOG NOZZLES ARE PREFERABLE.
Unusual Fire/Explosion Hazard:DURING EMERG CONDITIONS, OVEREXPOSURE TO
DECOMP PRODUCTS MAY CAUSE A HEALTH HAZ.GET MED ATTN.KEEP CONTNR
TIGHTLY CLOSD. MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT

Accidental Release

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIMINATE ALL IGNITION
SOURCES. DIKE AND CONTAIN SPILL W/INERT MATERIAL. TRANSFER LIQUIDS
TO COVERED METAL CONTAINERS FOR RECOVERY OR DISPOSAL. USE ONLY
NON-SPARKING TOOLS. DO NO T CONTAMINATE WATER SOURCES.

Handling

Handling and Storage Precautions:DO NOT STORE ABOVE 95F. STORE LARGE
QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
Other Precautions:DO NOT TAKE INTERNALLY. CLOSE AFTER USE. DO NOT
RE-USE FOR ANY PURPOSE. CONTAINERS S/BE GROUNDED AND BONDED TO THE
RECEIVING CONTAINER. DO NOT WELD/BRAZE/CUT ONEMPTY CONTAINER. NEVER
USE PRESSURE TO E MPTY. DRUM NOT A PRESSURE VESSEL.

Exposure Controls

Respiratory Protection:GENERAL EXPOSURE MAY NOT REQUIRE THE USE OF
RESPIRATORY PROTECTION. RESTRICTED VENTILATION AREAS A NIOSH
APPROVED CHEMICAL CARTRIDGE RESPIRATOR MAY BE REQUIRED. CONDITIONS
SUCH AS SPRAYING A A MECHAN ICAL PREFILTER MAY BE REQUIRED.
CONFINED
Ventilation:GENERAL DILUTION AND LOCAL EXHAUSE VENTILATION TO MAINTAIN
HAZ SUBSTANCES BELOW LOWEST EXPOSURE LIMITS.
Protective Gloves:SOLVENT IMPERMEABLE GLOVES
Eye Protection:SAFETY SPECTACLES
Other Protective Equipment:AS REQUIRED TO PREVENT SKIN CONTACT. SEE
OSHA STANDARD FOR LEAD.
Supplemental Safety and Health
RESPIRATION PROTECTION CONTINUED: AREAS USE A NIOSH/MSHA APPROVED AIR
SUPPLIED RESPIRATOR.

Chemical Properties

Boiling Pt:B.P. Text:281 TO 388F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:48

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING, HEATED BY WELDING OR CUTTING,
WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON DIOXIDE, OXIDES OF
LEAD GENERATED.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT SPARKS AND
FLAME.

Disposal

Waste Disposal Methods:DISPOSE IAW FED/ST/LO LAWS. INCINERATE ONLY IN
EPAFACILITY. DO NOT INCINERATE CLOSED CONTAINERS. OBSERVE
PRECAUTIONS FOR DISPOSAL OF FLAMMABLE MATERIAL. RCRA CLASSIFICATION
D001. HAZARDOUS WASTE NUMBER WOULD BE D008.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.