BHDLP - PIGMENTED POLY,F151 ACOM 26270,ID F09P01

Product Identification

Product ID:PIGMENTED POLY,F151 ACOM 26270,ID F09P01
MSDS Date:08/04/1988
FSC:8010
NIIN:00-410-8460
Kit Part:Y
MSDS Number: BHDLP

Responsible Party
SEAGRAVE COATINGS CORP OF VA. SEAGUARD DIVISION
4030 SEAGUARD AVENUE
PORTSMOUTH, VA 23701
US

Emergency Phone: 1-800-424-9300

Info Phone: (804) 488-4411

Cage: 60163

Contractor
SHERWIN-WILLIAMS, SEAGUARD
PORTSMOUTH, VA 23704 US

Telephone: 757-397-2223

Cage: 60163

Ingredients

N-BUTYL ALCOHOL (SARA III)

CAS: 71-36-3

RTECS: EO1400000

Fraction By Weight: 52.90%

OSHA PEL 100 PPM

ACGIH TLV: S, C 50 PPM; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Effects of Overexposure:SKIN: IRRITATION, DERMATITIS, AND SEVERE BURNS
EYE: IRRITATE AND SEVERELY DAMAGE
BY SHORT CONTACT. INHALATION: IRRITATE
TISSUE OF THE ENTIR E RESPIRATORY TRACT.

First Aid

First Aid:SKIN: FLUSH AREA THOROUGHLY W/WATER; REMOVE CONTAMINATED
CLOTHING UNDER SAFETY SHOWER FOR GROSS CONTAMINATION. GET MEDICAL
HELP IF LARGE SKIN AREA CONTACTED ORIRRITATION PRESISTS.INGESTION:
GIVE DILU TED VINEGAR OR CITRUS JUICE TO DRINK. DO NOT INDUCE
VOMITINGFOLLOW WITH MILK OR OLIVE OIL, OR EGG WHITES AND WATER. GET
MEDICAL ATTENTION.

Fire Fighting

Flash Point Method:SCC
Flash Point:100F/37.78C
Upper Limits:1.4
Extinguishing Media:CO2, WATER FOG, STEAM, FOAM, DRY CHEMICAL. COOL
FIRE EXPOSEDMETAL CONTAINERS WITH A WATER SPRAY.
Fire Fighting Procedures:FIREFIGHTERS MUST WEAR S.C.B.A. TO PROTECT
AGAINST SOLVENT VAPORS AND NITROGEN CONTAINING DECOMPOSITION
PRODUCTS.
Unusual Fire/Explosion Hazard:WHEN THIS MATERIAL IS INVOLVED IN A FIRE,
TOXIC DEGRADATION PRODUCTS CAN BE PRODUCED, INCLUDING CO2, CO,
HCHO, AND SIO2.

Accidental Release

Spill Release Procedures:SCOOP OR SWEEP UP SOLID SPILLS FOR DISPOSAL OR
RECOVERY. PICK UP LIQ SPILLS W/SAND OR ABSORBENT SOLID FOR
LANDFILL DISPOSAL. FLUSH TRACES WITH WATER.

Handling

Handling and Storage Precautions:KEEP AWAY FROM SOURCES OF HEAT.
PROTECT CONTAINERSAGAINST PHYSICAL DAMAGE. PROPERLY VENT LIQUID
STORAGE.
Other Precautions:STORE APPROVED LIQUID CONTAINERS IN A WELL VENTILATED
LOW FIRE RISK AREA AWAY FROM COMBUSTIBLE AND CORROSIVE CHEMICALS.
PREVENT SKIN CONTACT WITH PAINT.

Exposure Controls

Respiratory Protection:CHEMICAL CARTRIDGE RESPIRATOR OR AIR SUPPLIED OR
SELF CONTAINED RESPIRATOR. A FULL FACE MASK IS NEEDED TO PREVENT
EYE IRRITATION FROM VAPORS.
Ventilation:GENERAL/LOCAL EXHAUST TO KEEP WORK PLACE VAPORS AT A
MINIMUM
Protective Gloves:RUBBER
Eye Protection:SAFETY GLASSES/GOGGLES W/FACE SHIELD
Other Protective Equipment:LONG SLEEVE W/BUTTONED COLLAR; APRON;
PROTECTIVE CREAM ON AREAS OF SKIN EXPOSED TO DUST.
Supplemental Safety and Health
NK

Chemical Properties

Boiling Pt:B.P. Text:244F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NONE
Appearance and Odor:GRAY LIQUID, ALCOHOL ODOR
Percent Volatiles by Volume:53

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH TEMPERATURES

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.