BHDNX - ENAMEL, INTERIOR, S.G. GREEN 24491 ID752456

  • MSDS: BHDNX
  • Manufacturer: PRATT AND LAMBERT INC
  • Product Name: ENAMEL, INTERIOR, S.G. GREEN 24491 ID752456
  • National Stock Number: 8010-00-579-9197
Product Identification

Product ID:ENAMEL, INTERIOR, S.G. GREEN 24491 ID752456
MSDS Date:08/22/1990
FSC:8010
NIIN:00-579-9197
MSDS Number: BHDNX

Responsible Party
PRATT & LAMBERT INC
WICHITA, KS 67201
US

Emergency Phone: 316-733-1361

Info Phone: 316-733-1361

Cage: PRATT

Contractor
PRATT AND LAMBERT INC
2153 CLEVELAND, OH 44101-1027 US

Telephone: 216-566-2902

Cage: 61196

Ingredients

MINERAL SPIRITS (VP 2 MM HG @ 20C)

CAS: 64742-88-7

Fraction By Weight: 25%

OSHA PEL 100 PPM/525 MG/CU.M.

ACGIH TLV: 100 PPM/525 MG/CU.M.


TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 20 - 25%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


VOC 3.03 LB/GAL LESS WATER & NEGLIGIBLY PHOTOCHEMICALLY

RTECS: 9999999VO

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SWALLOWING MAY CAUSE GASTROINTESTINAL
IRRIT & CHEMICAL PNEUMONITIS. INHALATION MAY CAUSE NOSE/THROAT
IRRITATION & ACUTE CENTRAL NERVOUS SYS DEPRESSION. EYE & SKIN
IRRITANT; MAY CAUSE SKIN TO DEFATT. M AY CAUSE PERMANENT BRAIN &
NERVOUS SYSTEM DAMAGE & DEATH.
Effects of Overexposure:HEADACHES, DIZZINESS, NAUSEA, VOMITING,
CONFUSION & SEVERE IRRITATION REACTION IF PRODUCT IS SWALLOWED,
INHALED, ABSORBED THROUGH SKIN, OR GETS INTO EYES.
Medical Cond Aggravated by Exposure:REPORTS HAVE ASSOCIATED PROLONGED
AND REPEATED OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT
BRAIN AND NERVOUS SYSTEM DAMAGE.

First Aid

First Aid:SWALLOWING: DO NOT INDUCE VOMITING. CALL POISON CONTROL
CENTER IMMEDIATELY. INHALATION: REMOVE TO FRESH AIR IMMEDIATELY.
IF BREATHING STOPPED, GIVE CPR & KEEP WARM & QUIET. EYE: FLUSH WITH
LARGE AMOU NTS OF WATER FOR 15 MIN LIFTING UPPER/LOWER LIDS
CONTINUOUSLY. SKIN: REMOVE CONTAMINATED CLOTHING & WASH AFFECTED
AREA WITH SOAP & WATER. GET MEDICAL ATTENTION IMMEDIATELY FOR ANY
OF THESE CONDITIONS.

Fire Fighting

Flash Point:> 102F/ > 39C
Lower Limits:SEE INGRED
Upper Limits:SEE INGRED
Extinguishing Media:USE CARBON DIOXIDE, FOAM, OR DRY CHEMICAL FOR
FLAMMABLE LIQUID FIRES. POLYMER FOAM IS PREFERRED FOR LARGE FIRES.
Fire Fighting Procedures:FF SHOULD WEAR SCBA EQUIPMENT. WATER MAY BE
USED TO COOL EXPOSED CONTAINERS & PREVENT PRESSURE BUILDUP &
POSSIBLE AUTO-IGNITE EXPLOS. USE FOG NOZZLES W/WATER.
Unusual Fire/Explosion Hazard:OVEREXPOSURE TO DECOMP PRODUCTS MAY CAUSE
HEALTH HAZ. SYMPTOMS MAY NOT BE IMMED SEEN. GET MED ATTN. KEEP
CONTAINERS AWAY FROM IGNITE SOURCES TO PREVENT EXPLOS.

Accidental Release

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIMINATE ALL IGNITE
SOURCES, CONTAIN SPILL WITH INERT MATERIAL, TRANSFER LIQUID TO
COVERED METAL CONTAINERS FOR DISPOSAL. USE ONLY NON-SPARK TOOLS.
PREVENT CONTAMINATION OF SEWE RS, STREAMS & GROUNDWATER.

Handling

Handling and Storage Precautions:DO NOT STORE ABOVE 95 DEGREES F.
STORE LARGE QUANTITIES IN COMPLIANCE WITH OSHA 29CFR1910.106.
Other Precautions:EMPTY CONTAINERS SHOULD NOT BE WASHED OR REUSED FOR
ANY PURPOSE AND SHOULD BE GROUNDED & BONDED TO RECEIVING CONTAINER.
DO NOT WELD, BRAZE OR CUT ON EMPTY CONTAINER. NEVER USE PRESSURE TO
EMPTY. DISPO SE AS HAZARDOUS WASTE, IGNITABLE, D001.

Exposure Controls

Respiratory Protection:IN WELL VENTILATED AREAS, RESPIRATORY PROTECTION
MAY NOT BE REQUIRED. IN RESTRICTED AREAS USE A NIOSH APPROVED
CHEMICAL CARTRIDGE RESPIRATOR. FOR SPRAYING USE MECH PREFILTER. IN
CONFINED AREAS USE NIO SH/MSHA APPR AIR SUPPLIED RESPIRATOR.
Ventilation:DILUTE & LOCAL EXHAUST RECOMMENDED TO CONTROL CONCENTRATE
OF HAZARDOUS INGREDIENTS.
Protective Gloves:WEAR SOLVENT IMPERMEABLE GLOVES.
Eye Protection:WEAR SAFETY SPECTACLES.
Work Hygienic Practices:DO NOT TAKE INTERNALLY. CLOSE CONTAINER AFTER
EACH USE.
Supplemental Safety and Health

Chemical Properties

Boiling Pt:B.P. Text:277 TO 388F
Vapor Density:> THAN AIR
Spec Gravity:1.4
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:46

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING, HEAT BY WELDING OR CUTTING,
WILL PRODUCE SMOKE, CARBON MONOXIDE AND CARBON DIOXIDE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT SPARKS AND
FLAME.

Disposal

Waste Disposal Methods:DISPOSE OF IN I/A/W FEDERAL, STATE & LOCAL LAWS.
INCINERATE ONLY IN EPA PERMITTED FACILITY. DO NOT INCINERATE CLOSED
CONTAINERS. OBSERVE PRECAUTIONS FOR DISP OF FLAMMABLE MATERIALS.
CONTAMINATED ABSOR BENT MAY BE DISPOSED IN A HAZARD WASTE LANDFILL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.