Product ID:YELLOW TRAFFIC SFTY PAINT 33598 ID 12Y-D118
MSDS Date:10/24/1985
FSC:8010
NIIN:00-900-3648
MSDS Number: BHDXW

DESANTIS COATINGS, INC.

WILLOUGHBY, OH 44094
US

Emergency Phone: (216) 946-0300

Cage: DESAN

DESANTIS COATINGS,INC

160 WILLOUGHBY, OH 44094-0160 US

Cage: DESAN

ALIPHATIC NAPHTHAS (RELATIVELY NONTOXIC) (LEL 1.1)

Fraction By Weight: 28.9%

OSHA PEL NKNE

ACGIH TLV: 500 PPM

LEAD CHROMATE

CAS: 7758-97-6

Fraction By Weight: 7.7%

ACGIH TLV: 1.0 MG/M3

METHYL ALCOHOL (METHANOL) (SARA III)

CAS: 67-56-1

RTECS: PC1400000

Fraction By Weight: .2%

OSHA PEL S,200PPM/250STEL

ACGIH TLV: S,200PPM/250STEL; 93

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Effects of Overexposure:EYES: MAY CAUSE SEVERE IRRITATION.
INHALATION: MAY CAUSE HEADACHES,DIZZINESS,AND/OR NAUSEA, ASTHMATIC
TYPE RESPIRATORY REACTIONS, AND POSSIBLE NERVE DAMAGE. SKIN:
DRYING AND DEFATTING OF SKIN TISS UE MAY OCCUR.

First Aid:EYES: FLUSH WITH WATER
SKIN: WASH WITH SOAP AND WARM WATER AND APPLY
SKIN CREAM. INHALATION: APPLY OXYGEN AND
REMOVE TO FRESH AIR.

Flash Point:50F/10C
Extinguishing Media:FOAM, CARBON DIOXIDE (CO2) DRY CHEMICAL, OR WATER
FOG SPRAY.
Fire Fighting Procedures:FLAMMABLE VAPORS MAY FORM EXPLOSIVE MIXTURES
WITH AIR.
Unusual Fire/Explosion Hazard:STREAMS OF WATER AREN'T ORDINRLY
EFFECTIVE. SOLID HOSE STRMS TEND TO SCATTER LIQAND SPREAD THE FIRE.
WTR SPRAYS/FOG NOZZLES COOL THE BURNING SURFACE/EXCLUDE AIR

Spill Release Procedures:COLLECT IN A RETAINING AREA OR CONTAINER.
THEN TRANSFER TO A CLOSED CONTAINER. AVOID EXPOSURE TOHEAT,
SPARKS, FIRE, OR OPEN FLAME. AVOID HOT METALSURFACES.

Handling and Storage Precautions:DO NOT STORE OUTSIDE OF BUILDINGS OR
IN WET AREAS INDOORS. KEEP AWAY FROM HEAT, SPARKS, FIRE, AND OPEN
FLAME. USE ONLY WITH ADEQUATE VENTILATION.
Other Precautions:AVOID PROLONGED OR REPEATED CNTC W/SKIN. CLEAN ALL
CNTNR OPENINGS AND KEEP TIGHTLY SEALED. STORE UPRIGHT. SECURE
IN COOL, DRY, APPROVED AREA. CAUTION: DRIED FILM CONTAINS LEAD.
DO NOT INGEST , AVOID INHALATION OF DRY OVERSPRAY.

Respiratory Protection:A SELF-CONTAINEDE BREATHING APPARATUS IS
REQUIRED, UNLESS PRIOR WORKER MONITOR- ING SPECIFICALLY FOR SOLVENT
CONCENTRATION LEVELS HAS INDICATED THAT SAFE EXPOSURE LEVELS
EXIST IN THE OPERATION.
Ventilation:EXHAUST WITH PROPER AIRFLOW IS ALWAYS RECOMMENDED.
Protective Gloves:RECOMMENDED
Eye Protection:CLOSE FITTING SAFETY GOGGLES
Other Protective Equipment:GLOVES, LONG SLEEVES, HATS, FACE SHIELDS ARE
RECOMMENDED. PROTECTIVE CREAMS ARE NOT AS EFFECTIVE AS GLOVES.
Supplemental Safety and Health
ADEQUATE VENTILATION IS NECESSARY WHEN SPRAYING OR MIXING. ALL
ELECTRICAL EQUIPMENT MUST BE EXPLOSION-PROOF. AVOID ANY
DIRECT INHALATION OF ATOMIZED OR SPRAY MIST.

HCC:F3
Boiling Pt:B.P. Text:230-290F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:46.0

Stability Indicator/Materials to Avoid:YES
NA
Stability Condition to Avoid:AVOID HEAT, SPARKS, FIRE, OR OPEN FLAME.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CARBON
MONOXIDE.

Waste Disposal Methods:INCINERATE UNDER SAFE CONDITIONS OR DISPOSE PER
APPLICABLE REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.