BHFCN - MIL-C-22750 MO-062 COMP II

  • MSDS: BHFCN
  • Manufacturer: CRAWFORD LABORATORIES INC
  • Product Name: MIL-C-22750 MO-062 COMP II
  • National Stock Number: 8010-01-030-7254
Product Identification

Product ID:MIL-C-22750 MO-062 COMP II
MSDS Date:03/14/1989
FSC:8010
NIIN:01-030-7254
Kit Part:Y
MSDS Number: BHFCN

Responsible Party
CRAWFORD LABORATORIES, INC.
4165 SOUTH EMERALD AVENUE
CHICAGO, IL 60609
US

Emergency Phone: 312-433-1307

Info Phone: 312-376-7132

Cage: DO165

Contractor
CRAWFORD LABORATORIES, INC
CHICAGO, IL 60609 US

Telephone: 312-376-7132

Cage: 5V430

Ingredients

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 5-20%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


ETHYL ACETATE (SARA III)

CAS: 141-78-6

RTECS: AH5425000

Fraction By Weight: 20-50%

OSHA PEL 400 PPM

ACGIH TLV: 400 PPM; 9192

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


N-BUTYL ACETATE (SARA III)

CAS: 123-86-4

RTECS: AF7350000

Fraction By Weight: 5-20%

OSHA PEL 150 PPM/200 STEL

ACGIH TLV: 150 PPM/200STEL;9192

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


PROPYLENE GLYCOL MONOMETHYL ETHER

CAS: 107-98-2

RTECS: UB7700000

Fraction By Weight: 5-20%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:WARNING! CARE MUST BE TAKEN NOT TO
EXCEED THE EXPOSURE LIMIT FOR THE LOWEST TLV SHOWN. WHEN IN DOUBT
WEAR AN APPROVED RESPIRATOR AND ORDER AIR SAMPLING TESTS.
Effects of Overexposure:OVEREXP EFFECTS: 1-ACUTE TOXICITY RESULTING IN
HEADACHE, DIZZINESS, NAUSEA, AND LOSS OF CONSCIOUSNESS. 2-EYE
IRRITATION. 3-IRRITATED MUCOUS MEMBRANES. 4-VOMI- TING DUE TO
INGESTION. 5-DEFATTING AND D RYING OF THE SKIN WHICH MAY RESULT
INIRRITATION AND DERMATITIS.

First Aid

First Aid:EYE: FLUSH W/CLEAN/LUKEWARM/LOW PRESS WATER FOR 15 MIN
LIFTING EYELIDS. GET MED ATTN. INHALATION: REMOVE TO FRESH AIR/PROV
OXY IF BREATHING DIF/GIVE CPR IF NEC-ESSARY/KEEP VICTOM QUITE/DO
NOT GIVE LIQ UIDS. INGESTION: DO NOT INDUCE VOMIT. IFVOMIT OCCURES
KEEP HEAD BELOW HIPS TO PREV ASPIR OF LIQ INTO LUNGS/GET MED
ATTN.SKIN: FLUSH W/WATER/REMOVE CONTAM CLOTH/WASH/DO NOT REUSE
CLOTHING UNTIL CLEAN.

Fire Fighting

Flash Point Method:SCC
Flash Point:43F 6.11C
Upper Limits:1.2%
Extinguishing Media:FOAM, CO2, OR DRY CHEMICAL.
Fire Fighting Procedures:WATER USED TO KEEP EXPOSED CONT'S
COOL/FLAMMABLE STRUCTURES WET. DO NOT ENTER FIRE AREA WITHOUT
PROPER PROTECTION BECAUSE HAZ DECOMP PRODUCTS MAY BE PRESENT.
Unusual Fire/Explosion Hazard:WATER PRESSURE MAY SPREAD A FLAMMABLE
LIQUID FIRE. SEALED CONTAINERS MAY EXPLODE IF OVERHEATED.

Accidental Release

Spill Release Procedures:WARNING-FLAMMABLE. ELIMINATE ALL IGNITION
SOURCES.HANDLING EQUIPMENT MUST BE GROUNDED TO PREVENT SPARKING.
SOAK UP WITH AN ABSORBENT AND PLACE IN NON-LEAKING CONTAINERS.
SEAL TIGHTLY FOR PROPER DISPOSAL.

Handling

Handling and Storage Precautions:TREAT AS A HAZARDOUS-FLAMMABLE
MATERIAL. KNOW APPLICABLE D.O.T. REGULATIONS BEFORE ATTEMPTING
TOTRANSPORT THIS MATERIAL.

Exposure Controls

Respiratory Protection:IMPORTANT-MUST PROVIDE ADEQUATE VENTILATION TO
MAINTAIN VAPOR CONCENTRATIONS BE-LOW THE ESTABLISHED TLV LIMIT AS
GIVEN BY OSHA. IN MORE CONFINED AREAS A NIOSH- MSHA RESPIRATOR
EQUIPPED WITH ORGANIC VA POR CARTRIDGE SHOULD BE WORN.
Ventilation:MUST PROVIDE ADEQUATE VENTILATION. SEE PARAGRAPH ABOVE.
Protective Gloves:USE RUBBER GLOVES.
Eye Protection:APPROVED SAFETY GOG'S AND/OR FACE SHIELD
Other Protective Equipment:HAVE EYE BATH AVAILABLE.
Work Hygienic Practices:WASH WITH SOAP AND WATER TO REMOVE
CONTAMINATION OF SKIN, CLOTHING AND SHOES.
Supplemental Safety and Health
NK

Chemical Properties

Boiling Pt:B.P. Text:124F 243F
Vapor Density:>AIR
Evaporation Rate & Reference:3.13 X N-BUTYL ACETATE
Appearance and Odor:CLEAR LIQUID
Percent Volatiles by Volume:68.8

Stability

Stability Indicator/Materials to Avoid:YES
MAY BE INCOMPATIBLE WITH OXIDIZING AGENTS AND STRONG ALKALIES.
Stability Condition to Avoid:AVOID HEAT, SPARKS, OPEN FLAMES, AND
INCOMPATIBILITIES BELOW.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION FOR PRODUCTS
LIKE THIS MAY GENERATE HIGHLY POISONOUS CARBON MONOXIDE AND OTHER
TOXIC GASES.

Disposal

Waste Disposal Methods:DISP0SAL MUST BE IN ACCORDANCE WITH CURRENT
LOCAL,STATE AND FEDERAL REGULATION. CONTACT AN APPROVED DISPOSAL
FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.