BHFCY - MIL-C-22750 WHITE EPOXY A COMP

  • MSDS: BHFCY
  • Manufacturer: CHEMRAY COATINGS CORP
  • Product Name: MIL-C-22750 WHITE EPOXY A COMP
  • National Stock Number: 8010-01-053-2647
Product Identification

Product ID:MIL-C-22750 WHITE EPOXY A COMP
MSDS Date:08/04/1988
FSC:8010
NIIN:01-053-2647
Kit Part:Y
MSDS Number: BHFCY

Responsible Party
CHEMRAY COATINGS, CORP.
209 N. MICHIGAN AVE.
KENILWORTH, NJ 07033
US

Emergency Phone: 1-800-424-9300

Info Phone: 201-245-1111

Cage: OBRN9

Contractor
CHEMRAY COATINGS CORP.
NA KENILWORTH, NJ 07033 US

Telephone: 800-924-9300

Cage: OBRN9

Ingredients

METHYL ETHYL KETONE (2-BUTANONE) (MEK) (SARA III)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 19.95%

OSHA PEL 200 PPM/300 STEL

ACGIH TLV: 200 PPM/300STEL 9192

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


PROPYLENE GLYCOL MONOMETHYL ETHER

CAS: 107-98-2

RTECS: UB7700000

Fraction By Weight: 13.99%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192


TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 16-31%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THIS MATERIAL ON REPEATED/PROLONGED
CONTACT WITH SKIN CAN CAUSE IRRITATION, DERMATITS, AND SEVERE
BURNS. EYES CAN BE IRRITATED & SEVERELY DAMAGED BY SHORT CONT-ACT.
INHALED MIST CAN IRRITATE TISSUE OF THE ENTIRE RESPIRATORY TRACT
Effects of Overexposure:SKIN: IRRITATION, DERMATITIS, & SEVERE BURNS.
EYES: CAN BE IRRITATED & SEVERELY DAMAGED BY SHORT CONTACT. INHALED
MIST CAN IRRITATE TISSUE OF THE ENTIRE RESPIRATORY TRACT

First Aid

First Aid:SKIN: FLUSH THOROUGHLY WITH WATER; REMOVE CONTAMINATED
CLOTHING, UNDER SAFETY SHOWER FOR GROSS CONTAMINATION. GET MEDICAL
HELP IF LARGE SKIN AREA CONTACTED OR IF IRRITATION PERSISTS.
INGESTION: GIVE DILUTED VINEGAR OR CITRUS JUICE TO DRINKGET
MEDICAL HELP. DO NOT INDUCE VOMITING. FOLLOW WITH MILK OR OLIVE
OIL, OR EGG WHITES AND WATER

Fire Fighting

Flash Point Method:SCC
Flash Point:21F/-6.11C
Upper Limits:1.2
Extinguishing Media:CO2, WATER (FOG), STEAM, FOAM, DRY CHEMICAL. COOL
FIRE-EXPOSED METAL CONTAINERS WITH A WATER SPRAY
Fire Fighting Procedures:MUST WEAR SELF-CONTAINED BREATHING APPARATUS
TO PROTECT AGAINST SOLVENT VAPORS AND NITROGE-CONTAINING
DECOMPOSITION PRODUCTS
Unusual Fire/Explosion Hazard:TOXIC DEGRADATION PRODUCTS CAN BE
PRODUCED, INCLUDING, CO2, CO, HCHO. AND SI02; FIREFIGHTERS SHOULD
USE SELF-CONTAINED BREATHING APPARATUS

Accidental Release

Spill Release Procedures:SWEEP/SCOOP SOLID SPILLS FOR DISPOSAL OR
RECOVERY,AVOIDING DUSTY CONDITIONS & SKIN CONTACT. PICK UP LIQUID
SPILLS WITH SAND OR ABSORBANT SOLID FOR LANDFILL DISPOSL OR CONDUCT
TO HOLDING FACILITY. FLUS H TRACES WITH WATER

Handling

Handling and Storage Precautions:STORE WELL-VENTILATED, LOW FIRE-RISK
AREA AWAY FROM COMBUSTIBLES/CORROSIVE CHEMICALS. PROTECT FROM
PHYSICAL DAMAGE. PROPERLY VENT LIQUID STORAGE.
Other Precautions:PREVENT SKIN CONTACT WITH (PAINT). PROVIDE FOR
ADEQUATE EXHAUST VENTIATION OR APPROVED RESPIRATOR WHERE USED OR
STORED

Exposure Controls

Respiratory Protection:APPROVED CHEMICAL CARTIRIDGE RESPIRATOR OR AIR
SUPPLIED OR SELF-CONTAINED RESPIRATOR FOR NONROUTINE OR EMERGENCY
EXPOSURES ABOVE THE TLV. A FULL FACE MASK IS NEEDED TO PREVENT
EYE IRRITATION FROM VA PORS
Ventilation:ADEQUATE GENERAL & LOCAL EXHAUST VENTILATION (EXPLOSION
PROOF EQUIPMENT) TO KEEP WORKPLACE VAPORS AT MINIMUM
Protective Gloves:RUBBER GLOVES
Eye Protection:SAFETY GLASSES OR GOGGLES
Other Protective Equipment:PROTECTIVE CLOTHING, LONG SLEEVE SHIRT WITH
BUTTONED COLLAR,APPRON, FACE SHIELD, ETC. PROTECTIVE CREAMS
Supplemental Safety and Health
USE DUST-TIGHT CONVEYORS AND HANDLING EQUIPMENT. (UNDER EXCESSIVELY
DUSTY COND. USE AN APPROVED DUST RESPIRATOR) USE DUST-TIGHT SAFETY
GOGGLES TO PROTECT THE EYES & GLOVES & PROTECTIVE CLOTHING AS N
EEDED TO MINIMIZE SKIN CONTACT. CONSIDERUSE OF BARRIER CREAMS FOR
ADDITIONAL SKIN PROTECTION

Chemical Properties

Boiling Pt:B.P. Text:175F
Vapor Density:>1 AIR
Evaporation Rate & Reference:<1
Solubility in Water:NONE
Appearance and Odor:WHITE LIQUID, ALCOHOL SOLVENT ODOR
Percent Volatiles by Volume:44

Stability

Stability Indicator/Materials to Avoid:YES
EXCESIVELY HIGH TEMPERATURES. INCOMPATIBILITY: STRONG OXIDIZING AGENTS

Disposal

Waste Disposal Methods:FOLLOW FEDERAL, STATE, AND LOCAL ENVIRONMENTAL
REGULATIONS

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.