BJPGK - PARKER-O-LUBE

Product Identification

Product ID:PARKER-O-LUBE
MSDS Date:02/08/1988
FSC:9150
NIIN:01-081-8788
MSDS Number: BJPGK

Responsible Party
PARKER-HANNIFIN CORP SEAL GROUP O-RING DIVISION
2360 PALUMBO DRIVE
LEXINGTON, KY 40509
US

Emergency Phone: 606-269-2351

Info Phone: 606-269-2351

Cage: 02697

Contractor
PARKER-HANNIFIN CORP SEAL GROUP O-RING DIVISION
11751 LEXINGTON, KY 40509 US

Telephone: 606-269-2351

Cage: 02697

Ingredients

PETROLEUM OIL, ALAPHATIC

CAS: 68815-10-1

Fraction By Weight: 70-75%


BARIUM SOAP

Fraction By Weight: 25-30%

Hazards

LD50 LC50 Mixture:LD50 (ORAL RAT) IS NOT AVAILABLE
Routes of Entry: Inhalation:NO Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYE:MAY BE MILDLY IRRITATING.
SKIN: RELEASE DURING HIGH PRESSURE USAGE MAY RESULT IN INJECTION OF
OIL INTO THE SKIN CAUSING LOCAL NECROSIS. INHALATION:NOT EXPECTED
TO BE A RELEVANT ROUTE OF EXP OSURE; HIGH TEMPERATURE VAPORS
IRRITATERESPIRATORY TRACT. INGESTION: LOW LEVEL OF TOXICITY.
CHRONIC: SKIN DISORDERS.
Explanation of Carcinogenicity:NONE OF THE COMPOUNDS IN THIS PRODUCT IS
LISTED BY IARC, NTP, OR OSHA AS A CARCINOGEN.
Effects of Overexposure:MAY CAUSE EYE, SKIN & RESPIRATORY TRACT
IRRITATION. LOCAL NECROSIS IS EVIDENCED BY DELAYED ONSET OF PAIN
AND TISSUE DAMAGE A FEW HOURS FOLLOWING INJECTION. EXPOSURE CAN
RESULT IN REDNESS AND TEARING O F EYES. INGESTION CAN CAUSE
GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING, AND DIARRHEA.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN DISORDERS MAY BE
AGGRAVATED BY EXPOSURE TO THIS PRODUCT.

First Aid

First Aid:INHALATION: REMOVE TO FRESH AIR. GIVE OXYGEN IF BREATHING IS
DIFFICULT. GET MEDICAL ATTENTION. EYE: FLUSH WITH WATER FOR 15
MINUTES WHILE HOLDING EYELIDS OPEN. GET MEDICAL ATTENTION. SKIN:
WASH WITH S OAP & WATER/WATERLESS CLEANER. REMOVE CONTAMINATED
CLOTHING. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION. INGESTION:
DO NOT INDUCE VOMITING. GET MEDICAL ADVICE.

Fire Fighting

Flash Point Method:OC
Flash Point:435F,224C
Extinguishing Media:USE CARBON DIOXIDE, FOAM, OR DRY CHEMICAL. USE OF
WATER OR FOAM CAN CAUSE VIOLENT FROTHING.
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER
SPRAY TO COOL NEARBY CONTAINERS EXPOSED TO FIRE.
Unusual Fire/Explosion Hazard:FIRE OR EXCESSIVE HEAT MAY CAUSE
PRODUCTION OF HAZARDOUS DECOMPOSITION PRODUCTS. DO NOT WELD OR USE
CUTTING TORCHES NEAR FULL OR "EMPTY" DRUMS.

Accidental Release

Spill Release Procedures:SCOOP UP EXCESS GREASE. CLEAN AREA WITH
APPROPRIATE CLEANER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE WITH
ADEQUATE VENTILATION. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN
USE. KEEP AWAY FROM OPEN FLAMES & HIGH TEMPERATURES.
Other Precautions:MINIMIZE SKIN CONTACT. WASH WITH SOAP & WATER BEFORE
EATING, DRINKING, SMOKING OR USING TOILET FACILITIES. LAUNDER
CONTAMINATED CLOTHING BEFORE REUSE. PROPERLY DISPOSE OF
CONTAMINATED LEATHER ARTICLES (SHOES) THAT CAN NOT BE
DECONTAMINATED.

Exposure Controls

Respiratory Protection:IF VENTILATION DOES NOT MAINTAIN INHALATION
EXPOSURES BELOW PEL(TLV), USE NIOSH/MSHA APPROVED RESPIRATORS AS
PER CURRENT 29 CFR 1910.134, INSTRUCTIONS/WARNINGS. RESPIRATORY
PROTECTION NOT ORDINARILY R EQUIRED.
Ventilation:GENERAL MECHANICAL VENTILATION.
Protective Gloves:NEOPRENE RUBBER AS REQUIRED.
Eye Protection:SAFETY GLASSES RECOMMENDED.
Other Protective Equipment:EYE WASH STATION AND SAFETY SHOWER.
INDUSTRIAL-TYPE WORK CLOTHING AND APRON AS REQUIRED.
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. DO NOT WEAR CONTAMINATED CLOTHING OR
FOOTWEAR.
Supplemental Safety and Health
DO NOT GET IN EYES OR ON CLOTHING.

Chemical Properties

HCC:V6
Boiling Pt:B.P. Text:700F,371C
Spec Gravity:<1.0
Evaporation Rate & Reference:<1 (N-BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:SEMI-SOLID, AMBER COLOR, NO ODOR

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH TEMPERATURES (>600F), SPARKS, AND
OPEN FLAMES
Hazardous Decomposition Products:A MIXTURE OF AIRBORNE SOLID, LIQUID
PARTICULATES AND GASES (CO) WILL EVOLVE WHEN THIS MATERIAL
UNDERGOES COMBUSTION.

Disposal

Waste Disposal Methods:DISPOSE OF IN AN APPROPRIATE DISPOSAL FACILITY
IN COMPLIANCE WITH LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.