BLFVC - GALV-X ULTRA
- MSDS: BLFVC
- Manufacturer: W DAVID AND SONS LIMITED
- Product Name: GALV-X ULTRA
- National Stock Number: 8040-00N018626
Product Identification
Product ID:GALV-X ULTRA
MSDS Date:07/08/1991
FSC:8040
NIIN:00N018626
MSDS Number: BLFVC
Responsible Party
WELLINGBOROUGH
EN
Emergency Phone: 0933-224-201
Info Phone: 0933-224-201
Cage: K7427
Contractor
Telephone: 0933-224-201
Cage: K7427
Ingredients
STYRENE, MONOMER (SARA III)
CAS: 100-42-5
RTECS: WL3675000
Fraction By Weight: 12%
OSHA PEL 100 PPM
ACGIH TLV: S,50PPM/100STEL;9293
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:SKIN: MAY CAUSE IRRIT ON PRLNGD CONT.
EYE: MAY CAUSE IRRIT & SORENESS. INHAL: PRLNGD INHAL MAY CAUSE
DROW. INGEST: UNLIKELY. TOXICITY: FILLER PASTES CONTAINING STYRENE
CAUSE IRRIT OF EYES, SKIN & RESP TRACT. NO DETRIMENTAL EFTS TO
HLTH AREKNOWN WHERE PROD IS HNDL/USED PROPERLY & GOOD HYGIENE STD
ARE PRACTICED.
Explanation of Carcinogenicity:STYRENE:IARC - GROUP 2B.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:SKIN: WASH AFFECTED AREA W/WARM SOAPY WATER. EYE: IRRIGATE
W/COPIOUS QTYS OF CLEAN H2O & SEEK MED AID IMMED. INHAL: PATIENT
SHOULD SEEK FRESH AIR IMMED. IF CONDITION PERSISTS THEREAFTER
OBTAIN MED ADV ICE W/OUT DELAY. INGEST: MILK SHOULD BEDRUNK. DO NOT
INDUCE VOMIT, SEEK MED AID.
Fire Fighting
Flash Point:89.6F,32.0C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:DRY POWDER/CHEMICAL FOAM. WATER SPRAY ONLY TO KEEP
CONTAINERS COOL. DO NOT USE H2O JETS, AVOID INHAL OF BURNING PROD.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.
Accidental Release
Spill Release Procedures:NOT DANGEROUS-WIPE OR SCRAPE AWAY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:IN ORIGINAL CLOSED CONTAINERS IN COOL
AREA AND KEPT AWAY FROM ALL SOURCES OF IGNITION.
Other Precautions:NORMAL PRECAUTIONS FOR HANDLING CHEMICALS SHOULD BE
OBSERVED.
Exposure Controls
Respiratory Protection:(WHEN SANDING) NIOSH/MSHA APPROVED DUST PARTICLE
MASK.
Ventilation:GOOD WORKSHOP VENTILATION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:BARRIER CREAM RECOMMENDED. PERSONS WHO
SUFFER SKIN COMPLAINTS OR OTHER ALLERGIC EFFECTS SHOULD NOT WORK
WITH PRODUCT.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.
Chemical Properties
HCC:F4
Vapor Density:1.8-2.0
Solubility in Water:MINIMAL
Appearance and Odor:PUTTY LIKE CONSISTENCY.PALE GREY,PALE BLUE,METALLIC
GREY/BEIGE.CHARAC OF STYREN
Percent Volatiles by Volume:12(WT)
Stability
NONE (IF PRODUCT STORED AND HANDLED CORRECTLY).
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE (IF PRODUCT STORED AND HANDLED
CORRECTLY).
Disposal
Waste Disposal Methods:DISPOSE I/A/W FEDERAL, STATE AND LOCAL AUTHORITY
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.