BMRLX - GENERAL PURPOSE ALUMINUM PAINT, 6-230
- MSDS: BMRLX
- Manufacturer: PPG INDUSTRIES INC
- Product Name: GENERAL PURPOSE ALUMINUM PAINT, 6-230
- National Stock Number: 8010-00N026182
Product Identification
Product ID:GENERAL PURPOSE ALUMINUM PAINT, 6-230
MSDS Date:09/13/1989
FSC:8010
NIIN:00N026182
MSDS Number: BMRLX
Responsible Party
PITTSBURGH, PA 15238
US
Emergency Phone: 304-843-1300
Info Phone: 412-963-5822
Cage: 47695
Contractor
Telephone: 1-800-245-2974 (CAL HYPO)
Cage: 47695
Ingredients
ALUMINUM; (ALUMINUM PASTE)
CAS: 7429-90-5
RTECS: BD0330000
Fraction By Weight: 5-10%
OSHA PEL 15MG/M3 DUST;5 FUME
ACGIH TLV: 10MG/M3 DUST;5 FUME
SOLVENT NAPHTHA (PETROLEUM), MEDIUM ALIPHATIC; (MEDIUM
CAS: 64742-88-7
Fraction By Weight: 55-60%
FILM FORMERS, RESINS, AND ADDITIVIES
Fraction By Weight: 30-35%
AGAINST WHICH THE RESPIRATORS IS EFFECTIVE AND
RTECS: 9999999ZZ
LEL BELOW STATE LIMIT, AND TO REMOVE DECOMP PRODUCTS
RTECS: 9999999ZZ
NITRILE RUBBER, NEOPRENE RUBBER OR
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: INGEST:HARMFUL/FATAL.
EYE:CAUSES IRRIT. SKIN:MAY CAUSE MOD IRRIT. MAY BE ABSORBED THRU
SKIN. INHAL:VAP/SPRAY MIST MAY BE HARMFUL. VAP IRRIT
EYES/NOSE/THROAT. RPTD EXPOS TO HIGH VAP CONC MAY CAU SE IRRIT OF
RESP SYS/PERM BRAIN/NERVS SYS DMG. INTENTIONAL MISUSE BY DELIB
CONC/INHAL CONTENTS CAN BE HARMFUL/FATL.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:CHRONIC: AVOID LONG TERM/RPTD CONT. SIGNS/SYMP
OF OVEREXP: EYE WATERING/HDACH/NAUS/DIZZ/LOSS OF COORD ARE
INDICATIONS THAT SOLV LEVELS ARE TOO HIGH. RED/ITCH/BURNING
SENSATION/VISUAL DISTURB MAY INDIC ATE EXCESSIVE EYE CONT.
DRY/ITCH/CRACK/BURN/RED/SWELL ARE CNDTNS ASSOCIATED W/EXCESSIVE
SKIN CONTACT.
First Aid
First Aid:INGEST: DO NOT INDUCE VOMIT. EYES: FLUSH IMMED W/PLENTY OF
H*2O FOR AT LST 15 MIN. SKIN: FLUSH IMMED W/PLENTY OF H*2O FOLLOWED
BY WASHING W/SOAP/WATER. INHAL: REMOVE TO FRESH AIR. APPLY ARTF
RESP/OTHE R SUPPORTIVE MEASURES AS REQD. -- IF ANY OF FOLLOWING
OCCUR DURING OR FOLLOWING USE OF THIS PROD, CONT POIS CTL CTR/EMER
RM OR MD IMMED; HAVE MSDS INFO AVAIL: INGEST/EXCESSIVE EXPOS TO A
(SUPP DATA)
Fire Fighting
Flash Point Method:PMCC
Flash Point:102F,39C
Lower Limits:1%
Extinguishing Media:NFPA CLASS B EXTING (CO*2/DRY CHEM/UNIVERSAL
AQUEOUS FILM FORM FOAM) DESIGNED TO EXTING NFPA CLASS II COMBUST
LIQ FIRE.
Fire Fighting Procedures:WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY
BE USED TO COOL CLOSED CONTRS TO PVNT PRESS BUILD-UP/POSS
AUTOIGNIT/EXPLOS WHEN EXPOSED TO EXTREME HEAT.(SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CONTRS TIGHTLY CLOSED. ISOLATE FROM
HEAT/ELEC EQUIP/SPARKS/OPEN FLAMES. CLOSED CONTRS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DO NOT APPLY ON (SUPP DATA)
Accidental Release
Spill Release Procedures:PROVIDE MAXIMUM VENTILATION. ONLY PERS
EQUIPPED W/PROPER RESPIRATORY/SKIN/EYE PROT SHLD BE PERMITTED IN
THE AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED MATL
W/SAWDUST/VERMICULITE &/OR OTHER ABSORB MATL & PLACE INTO CONTRS
FOR DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QTYS IN BLDG DESIGNED/PROTECTED FOR STORAGE OF NFPA CLASS II
COMBUSTIBLE LIQUIDS.
Other Precautions:IF MATL IS PART OF MULTIPLE COMPONENT COATING SYS,
READ MSDS FOR OTHER COMPONENT(S) BEFORE BLENDING AS RSLTG MIX MAY
HAVE THE HAZ OF ALL OF ITS PARTS. CONTRS SHLD BE GROUNDED WHEN
POURING. AVOID FREE FALL OF LIQ IN EXCESS OF A FEW INCHES.
Exposure Controls
Respiratory Protection:OVEREXP TO VAPS MAY BE PVNTD BY ENSURING VENT
CTLS/VAP EXHST/FRESH AIR ENTRY. NIOSH/MSHA APPRVD (TC-23C-) PAINT
SPRAY/AIR SUPPLIED (TC-19C-) RESPIRATORS MAY ALSO REDUCE EXPOS.
READ RESP MFR'S INSTRUCT IONS/LITERATURE CAREFULLY TO (SUPP DATA)
Ventilation:PROVIDE GEN DILUTION/LOC EXHST VENT IN VOL/PATTERN TO KEEP
CONC OF INGREDS BELOW LOWEST SUGGESTED EXPOS LIMITS, (ING 5)
Protective Gloves:IMPERMEABLE GLOVES CONSTRUCTED (ING 6)
Eye Protection:CHEM WORK GOGG/FULL LENGTH FSHLD .
Other Protective Equipment:PROTECTIVE CLOTHING, INCLUDING IMPERMEABLE
APRON.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING/SHOES.
Supplemental Safety and Health
FIRE FIGHT PROC: IF H*2O IS USED, FOG NOZZ ARE PREF. WEAR NIOSH/MSHA
APPRVD SCBA/FULL PROT EQUIP . EXPLO HAZ: HOT SURF. TOX GASES MAY
FORM WHEN PROD IS CONTACTED BY FLAME/HOT SURF. FIRST AID PRO C:
CORR MATL. PERSISTENT SKIN/EYE IRRITOR BRTHG DFCLTS. RESP PROT:
DETERMINE THE TYPE OF AIRBORNE CONTAMINANTS (ING 4)
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:306F,152C
Vapor Pres:2
Vapor Density:HVR/AIR
Spec Gravity:0.91
Evaporation Rate & Reference:16 (BUTYL ACETATE=1)
Solubility in Water:0.0%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF THE
SOLVENTS.
Percent Volatiles by Volume:65.9
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT W/STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZ DECOMP PRODS WHEN
HEATED. WELD/ BRAZING/FLAME-CUT ON SURFACES COATED W/THIS PROD MAY
PRDCE FUMES INCL CO.
Disposal
Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF I/A/W
FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTRS SHLD BE RECYCLED OR DISPOSED OF THROUGH
AN APPROVED WASTE MANAGEMENT FACI LITY.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.