BMTVX - METHYLENE CHLORIDE,TECHNICAL
- MSDS: BMTVX
- Manufacturer: OCTAGON PROCESS INC
- Product Name: METHYLENE CHLORIDE,TECHNICAL
- National Stock Number: 6810-00-223-2737
Product Identification
Product ID:METHYLENE CHLORIDE,TECHNICAL
MSDS Date:03/02/1990
FSC:6810
NIIN:00-223-2737
MSDS Number: BMTVX
Responsible Party
EDGEWATER, NJ 07020-1105
US
Emergency Phone: 201-945-9400/FAX 72-1 -1203
Info Phone: 201-945-9400/FAX 201-945-1203
Cage: 82925
Contractor
Telephone: 201-945-9400
Cage: 82925
Ingredients
METHYLENE CHLORIDE (SARA III)
CAS: 75-09-2
RTECS: PA8050000
Fraction By Weight: 99.9%
OSHA PEL 500 PPM/C,1000; Z2
ACGIH TLV: 50 PPM, A2; 9192
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
Hazards
LD50 LC50 Mixture:LD50 (ORAL, RAT) IS 1500-2500 MG/KG
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE-EYE:MAY CAUSE PAIN,IRRITATION &
SLIGHT CORNEAL INJURY.SKIN:PROLONGED/REPEATED CONTACT MAY CAUSE
IRRITATION,BURN,DRYING/FLAKING.INHALE:MAY CAUSE
DIZZINESS,DRUNKENNESS,UNCONSCIOUSNESS & DEATH.ORAL :LOW TOXICITY.IF
ASPIRATED,MAY BE ABSORBED & RESULT IN INJURY TO OTHER
ORGANS.CHRONIC-MAY CAUSE SKIN DISORDERS.
Explanation of Carcinogenicity:LISTED AS A POTENTIAL CARCINOGEN BY IARC
(PER MSDS).
Effects of Overexposure:MAY CAUSE EYE PAIN, IRRITATION & SLIGHT CORNEAL
INJURY. PROLONGED/REPEATED SKIN CONTACT MAY CAUSE IRRITATION, BURN,
DRYING/FLAKING. INHALATION MAY CAUSE DIZZINESS, DRUNKENNESS,
UNCONSCIOUSNESS & DEATH . ORALLY HAS LOW TOXICITY. IF ASPIRATED,
MAY BE ABSORBED & RESULT IN INJURY TO OTHER ORGANS.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN DISORDERS MAY BE
MORE SUSCEPTIBLE TO THIS MATERIAL.
First Aid
First Aid:GET MEDICAL ATTENTION IF SYMPTOMS PERSIST.SKIN:WASH WITH SOAP
& WATER.EYE:FLUSH WITH WATER FOR 15 MINUTES,HOLDING EYELIDS
OPEN.INHALED:REMOVE TO FRESH AIR & PROVIDE OXYGEN/CPR IF
NEEDED.ORAL:DO NOT IN DUCE VOMITING.IF VOMITING OCCURS,KEEP HEAD
BELOW HIPS DUE TO ASPIRATION HAZARD.TREAT SYMPTOMATICALLY AND
SUPPORTIVELY.CALL PHYSICIAN.
Fire Fighting
Flash Point:NONE
Lower Limits:14
Upper Limits:22
Extinguishing Media:WATER FOG
Fire Fighting Procedures:WEAR FULL PROTECTIVE CLOTHING AND
NIOSH-APPROVED SELF-CONTAINED BREATHING APPARATUS WITH FULL
FACEPIECE OPERATED IN THE POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:FORMS FLAMMABLE VAPOR-AIR MIXTURES. LOWER
TEMPERATURES INCREASE THE DIFFICULTY OF GETTING IT TO IGNITE.
Accidental Release
Spill Release Procedures:WEAR PROTECTIVE EQUIPMENT.ELIMINATE SOURCES OF
IGNITION.VENTILATE THE AREA.STOP LEAK IF POSSIBLE.CONTAIN THE
SPILL.PICK UP LARGE SPILL WITH NON-SPARKING TOOLS;SMALL
SPILLS/RESIDUE WITH ABSORBENT MATER IAL.PLACE IN NON-LEAK
CONTAINERS.CONTAIN RUN-OFF.
Handling
Handling and Storage Precautions:STORAGE-STORE IN COOL,DRY WELL
VENTILATED AREA AWAY FROM INCOMPATIBLE MATERIALS.
Other Precautions:AVOID BREATHING VAPORS. DO NOT GET IN EYES, ON SKIN
OR ON CLOTHING. WASH THOROUGHLY AFTER HANDLING. REMOVE CONTAMINATED
CLOTHING PROMPTLY.
Exposure Controls
Respiratory Protection:IF ENGINEERING CONTROLS ARE INADEQUATE TO
CONTROL VAPOR CONCENTRATIONS TO AN ACCEPTABLE LEVEL, A
NIOSH-APPROVED ORGANIC VAPOR RESPIRATOR SHOULD BE WORN. A PROGRAM
SHOULD BE INSTITUTED TO ASSURE COMPLI ANCE WITH OSHA STANDARD 29
CFR 1910.134.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY GOGGLES & FACE SHIELD
Other Protective Equipment:EYE WASH STATION, QUICK DRENCH SHOWER AND
IMPERVIOUS CLOTHING
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. DO NOT WEAR CONTAMINATED CLOTHING OR
FOOTWEAR.
Supplemental Safety and Health
Chemical Properties
HCC:T4
Boiling Pt:B.P. Text:104F,40C
Vapor Pres:355 @ 20 C
Vapor Density:2.93
Spec Gravity:1.320
Solubility in Water:2% @ 25 C
Appearance and Odor:COLORLESS LIQUID-PENETRATING ETHER-LIKE ODOR.
IRRITATING AT HIGH CONCENTRATIONS
Stability
Stability Indicator/Materials to Avoid:YES
AMINES, ALUMINUM, POSSIBLY SODIUM, POTASSIUM AND MAGNESIUM
Stability Condition to Avoid:EXCESSIVE HEAT, FIRE
Hazardous Decomposition Products:OPEN FLAMES AND WELDING ARCS CAN CAUSE
THERMAL DEGRADATION WITH THE EVOLUTION OF HCL & TRACES OF PHOSGENE
AND CHLORINE.
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH ALL LOCAL, STATE
AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.