BPDQY - C1680, TF SOLVENT
- MSDS: BPDQY
- Manufacturer: CHEMTRONICS INC
- Product Name: C1680, TF SOLVENT
- National Stock Number: 6850-00N030125
Product Identification
Product ID:C1680, TF SOLVENT
MSDS Date:01/01/1987
FSC:6850
NIIN:00N030125
MSDS Number: BPDQY
Responsible Party
KENNESAW, GA 30144
US
Emergency Phone: 404-424-4888
Info Phone: 404-424-4888
Preparer: S. H. STEIN
Cage: 2M589
Contractor
Telephone: 770-424-4888/800-645-5244
Cage: 2M589
Ingredients
CARBON DIOXIDE; (CARBON DIOXIDE PROPELLANT)
CAS: 124-38-9
RTECS: FF6400000
Fraction By Weight: 3%
OSHA PEL 5000 PPM
ACGIH TLV: 5000PPM/30000STEL;93
EXPERIMENTAL ANIMALS, EXPOS TO APPROX 5000 PPM (V/V)
RTECS: 9999999ZZ
CHALLENGE, HAS INDUCED SERIOUS CARDIAC
RTECS: 9999999ZZ
RELEASED. MECHANICAL VENTILATION SHOULD BE USED IN LOW
RTECS: 9999999ZZ
IT TO PROGRESS THROUGH INTESTINAL TRACT.
RTECS: 9999999ZZ
CARDIAC DYSRYTHMIAS, CATECHOLAMINE DRUGS SUCH AS
RTECS: 9999999ZZ
IN LIFE THREATENING EMERGENCIES.
RTECS: 9999999ZZ
ETHANE, 1,1,2-TRICHLORO-1,2,2-TRIFLUORO-;
CAS: 76-13-1
RTECS: KJ4000000
Fraction By Weight: 97%
OSHA PEL 1000 PPM;1250 STEL
ACGIH TLV: 1000 PPM;1250 STEL
Hazards
LD50 LC50 Mixture:LD5O (ORAL, RAT):43,000 MG/KG
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHLOROFLUOROCARBON MATS HAVE PRODUCED
SENSIT OF MYOCARDIUM TO EPINEPHRINE IN LAB ANIMALS & COULD HAVE
SIMILAR EFT IN HUMANS. ADRENOMETICS (E.G., EPINEPHRINE) MAY BE
CONTRAINDICATED EXCEPT FOR LIFE-SUS TAINING USES IN HUMANS
ACUTELY/CHRONICALLY EXPOSED TO CFC'S . INHAL:VAP IS HVR (EFTS OF
OVEREXPOS)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:THAN AIR & CAN CAUSE SUFFOCATION BY
REDUCING O2 AVAIL FOR BRTHG. BRTHG HIGH CONC OF VAP MAY CAUSE LT
HEAD, GIDDINESS, SHORTNESS OF BRTH & MAY LEAD TO NARCOSIS, CARDIAC
IRREGULARITIES, UNCONSC IOUSNESS/DEATH. EYES:LIQ CONT CAN
CAUSEDISCOMFORT, USUALLY NO EXTENDED EFT. INGEST:ALTHOUGH ORAL TOX
IS LOW (SUPDAT)
Medical Cond Aggravated by Exposure:CARDIOVASCULAR DISEASE.
First Aid
First Aid:INHAL:REMOVE TO FRESH AIR. CALL MD. IF NOT BRTHG, GIVE ARTIF
RESP, PREFERABLY MOUTH-TO-MOUTH. IF BRTHG IS DFCLT, GIVE O2. DO NOT
GIVE EPINEPHRINE/SIMILAR DRUGS. EYES:IMMED FLUSH W/PLENTY OF WATER
FOR AT LEAST 15 MIN. CALL MD. SKIN:FLUSH W/WATER. GET MD ATTN IF
IRRIT IS PRESENT. INGEST:CONSULT MD IF NEC. DO NOT INDUCE VOMIT AS
HAZ OF ASPIRATING MATL INTO LUNGS IS GREATER HAZ THAN ALLOWING (ING
6)
Fire Fighting
Flash Point Method:TOC
Flash Point:NONE
Lower Limits:NON-FLAMM
Upper Limits:NON-FLAMM
Extinguishing Media:NON FLAMMABLE. USE MEDIA SUITABLE FOR SURROUNDING
FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED PRESSURE DEMAND SCBA
AND FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:THERM DECOMP PROD MAY INCLUDE CHLORIDES,
FLUORIDES & PHOSGENE . PRESS AEROSOL CONTRS AT ELEVATED TEMP MAY
VENT, RUPTURE/BURST & ADD TO FLYING & (SUPDAT)
Accidental Release
Spill Release Procedures:VENTILATE AREA. REMOVE OPEN FLAMES OR RED HOT
SURFACES. ALLOW TO EVAPORATE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE NEAR SOURCES OF HEAT, IN
DIRECT SUNLIGHT OR WHERE TEMPS EXCEED 120F. DO NOT PUNCTURE OR
DAMAGE CONTAINERS. ROTATE STOCK.
Other Precautions:NO SMOKING IN AREA OF USE. DO NOT USE IN GENERAL
VICINITY OF ARC WELDING, OPEN FLAMES OR HOT SURFACES. HEAT AND/OR
UV RADIATION MAY CAUSE FORMATION OF CHLORIDES, FLUORIDES AND/OR
PHOSGENE . DO N OT SPRAY LIQUID ON SKIN.
Exposure Controls
Respiratory Protection:UNDER NORMAL MANUFACTURING CONDITIONS, NO
RESPIRATORY PROTECTION IS REQUIRED WHEN USING THIS PRODUCT.
NIOSH/MSHA APPROVED SCBA IS REQUIRED IF A LARGE SPILL OCCURS.
Ventilation:NORMAL VENT FOR STANDARD MFG PROCEDURES IS GENERALLY ADEQ.
LOC EXHAUST SHOULD BE USED WHEN LRG AMTS ARE (SUPDAT)
Protective Gloves:BUTYL GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLOS HAZ:FALLING DEBRIS. DECOMP MAY OCCUR. DECOMP PROD:FORMING
HYDROCHLORIC/HYDROFLUORIC ACIDS. POSS CARBONYL HALIDES. EFTS OF
OVEREXP:INGEST OF TF SOLV IS TO BE AVOIDED. SKIN:RPTD LIQ CONT CAN
CAUS E DEFATTING OF SKIN RESULTING IN IRRIT.MATL IS POORLY ABSORBED
THROUGH SKIN. NOTE: IN SCREENING TESTS W/(ING 3)
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:118F,48C
Vapor Pres:334 @ 77F
Vapor Density:65 @ 77F
Spec Gravity:1.57 @ 77F
pH:NEUT
Evaporation Rate & Reference:1 (ETHER = 1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR COLORLESS LIQUID WITH FAINT SOLVENT ODOR.
Percent Volatiles by Volume:100
Stability
Stability Indicator/Materials to Avoid:YES
ALKALI OR ALKALINE EARTH METALS, POWDER ALUMINUM, ZINC, BERYLLIUM, ETC.
Stability Condition to Avoid:AVOID SPRAYING NEAR OPEN FLAME OR HOT
SURFACES. DO NOT HEAT AEROSOL CONTAINERS ABOVE 120F.
Hazardous Decomposition Products:CHLORIDES, FLUORIDES & PHOSGENE . CMPD
CAN BE DECOMP BY HIGH TEMP (OPEN FLAME, GLOWING METAL, SURF, ETC),
(SUPDAT
Disposal
Waste Disposal Methods:ALLOW TO EVAPORATE. DO NOT PUNCTURE OR
INCINERATE AEROSOL CANS. COMPLY WITH LOCAL, STATE AND FEDERAL
REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.