BPNQK - 9612, ALIPHATIC POLY ISOCYANATE RESIN SOLUT
- MSDS: BPNQK
- Manufacturer: SEAGRAVE COATINGS CORP
- Product Name: 9612, ALIPHATIC POLY ISOCYANATE RESIN SOLUT
- National Stock Number: 8010-00N033111
Product Identification
Product ID:9612, ALIPHATIC POLY ISOCYANATE RESIN SOLUT
MSDS Date:01/18/1986
FSC:8010
NIIN:00N033111
MSDS Number: BPNQK
Responsible Party
CARLSTADT, NJ 07072
US
Emergency Phone: 201-933-1000
Info Phone: 201-933-1000
Cage: DO631
Contractor
Telephone: 1-800-424-9300
Cage: 78767
Ingredients
6@20C
CAS: 1330-20-7
RTECS: ZE2100000
OSHA PEL 100 PPM;150 PPM STEL
ACGIH TLV: 100 PPM;150 PPM STEL
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
8@20C
CAS: 123-86-4
RTECS: AF7350000
OSHA PEL 150 PPM;200 PPM STEL
ACGIH TLV: 150 PPM;200 PPM STEL
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
HEXANE,1,6-DIISOCYANATO-; (HEXAMETHYLENE DIISOCYANATE)
CAS: 822-06-0
RTECS: MO1740000
ACGIH TLV: 0.005 PPM
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
ISOCYANIC ACID, HEXAMETHYLENE ESTER, POLYMERS; (HOMOPOLYMER
CAS: 28182-81-2
RTECS: NQ9170000
MATL IN OPEN CONTRS & ADD MORE DECONTAM MATL.
RTECS: 9999999ZZ
AREA W/LIQ DECONTAM & FLUSH SPILL AREA W/H*2O. NOTIFY
RTECS: 9999999ZZ
(0.10%), DETERGENT (2-5%) AND BALANCE WATER.
RTECS: 9999999ZZ
7.5X10-5@20
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: VAP/MIST MAY CAUSE IRRITATION
TO EYES, NOSE, THROAT, LUNGS. CHRONIC: NOT KNOWN.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:EYES WATERING, DRY THROAT, COUGHING, HEADACHE,
TIGHTNESS IN CHEST OR BURNING SENSATION, RASH, ITCHING, HIVES IN
ALLERGIC DERMATITIS.
Medical Cond Aggravated by Exposure:ALLERGIC SKIN OR RESPIRATORY
REACTION MAY OCCUR IN SOME INDIVIDUALS GIVING ASTHMA LIKE SYMPTOMS.
First Aid
First Aid:INHAL: MOVE TO AREA FREE OF FURTHER EXPOS- TREAT
SYMPTOMATICALLY. CONSULT MD. MOVE TO AN EXPOS FREE AREA, O2/ARTF
RESP IF NEEDED, GET MED ATTN. EYES: FLUSH W/LOW PRESS CLEAN WATER
FOR AT LEAST 15 MIN. OCCAS LIFT LIDS. GET MED ATTN. SKIN: REMOVE
CONTAMD CLTHG, WASH WITH SOAP AND WATER. WASH CONTAMD CLOTHING
BEFORE REUSE. INGEST: DO NOT INDUCE VOMITING-GET MEDICAL ATTENTION.
Fire Fighting
Flash Point Method:TCC
Flash Point:91.0F,32.8C
Lower Limits:1%
Upper Limits:7.6%
Extinguishing Media:FOAM, DRY CHEMICAL, CO2.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:DURING A FIRE IRRITATING & HIGHLY TOX
GASES & SMOKE ARE PRESENT FROM DECOMP/COMBUSTION. ISOLATE FROM
HEAT/ELEC EQUIP/ SPARKS & OPEN FLAME. CLSD CONTRS(SUPP DATA
Accidental Release
Spill Release Procedures:SPILLAGE: EVACUATE NON-ESSENTIAL PERS. REMOVE
ALL SOURCES OF IGNIT. VENT AREA. CLEAN-UP CREW WEAR APPROP PROT
EQUIP & RESP. DIKE SPILLED MATL & TRY TO CTL FURTHER SPILLAGE.
COVER SPILL W/SAWDUST/OTHER ABSORB MATL; POUR LIQ DECONTAM OVER
(SUPP DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN RED LABEL AREA IN ORIGINAL
CONTAINERS. DO NOT WEAR CONTACT LENSES.
Other Precautions:TOTAL MONOMER CONTENT LESS THAN 0.7% BASED ON RESIN
SOLIDS @ TIME OF MFR. MAY RISE AFTER 3-6 MONTHS STORAGE TO MAX
1.6%.
Exposure Controls
Respiratory Protection:USE A NIOSH/MSHA APPROVED RESPIRATOR RECOMMENDED
FOR USE IN ISOCYANATE CONTAINING ENVIRONMENTS OR FILTERS TO REDUCE
ENVIRONMENTAL CONTAMINATION.
Ventilation:LOCAL EXHAUST REQUIRED. MECH(GEN) EXHAUST AIR MAY NEED TO
BE CLEANED BY SCRUBBERS.
Protective Gloves:SOLVENT RESISTANT.
Eye Protection:CHEM WORK GOG & FULL LENGTH FSHLD.
Other Protective Equipment:APRON AND BOOTS RECOMMENDED. IF SKIN CONTACT
IS LIKELY USE PROTECTIVE SKIN CREAM.
Work Hygienic Practices:EYE BATH AND SAFETY SHOWER.
Supplemental Safety and Health
EXPLO HAZ: MAY EXPLODE WHEN EXPOS TO EXTREME HEAT/BURST WHEN CONTAMD
W/H2O (CO2 EVOLVED). SOLV VAPS MAY BE HVR/AIR. UNDER CNDTNS OF
STAGNANT AIR, VAPS MAY BUILD UP & TRAVEL ALONG GROUND TO AN IGNIT
SO UCE WHICH MAY RSLT IN FLASH BACK TO SOURCE OF VAPS. SPILL PROC:
SPILLAGE, ALLOW TO REACT @ LST 10 MIN., COLLECT (ING 5
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:>259F,>126C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:1.06(H2O=1)
Solubility in Water:INSOL(REACTS)
Appearance and Odor:PALE YELLOW LIQUID-MILD
Stability
Stability Indicator/Materials to Avoid:YES
WATER, ALCOHOLS, AMINES, STRONG BASES, METAL COMPOUNDS OR SURFACE
ACTIVE MATERIALS.
Stability Condition to Avoid:TEMP ABOVE MAX STOR CNDTNS (122F).
MOISTURE & OTHER MATLS WHICH REACT W/ISOCYANATES.
Hazardous Decomposition Products:BY FIRE: CO2, CO, NOX, TRACES OF HCN,
TDI, HDI.
Disposal
Waste Disposal Methods:THIS PRODUCT MAY BE INCINERATED. HANDLE EMPTY
CONTAINERS WITH CARE DUE TO PRODUCT RESIDUE AND VAPORS. DISPOSE OF
IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL REGULATIONS .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.