BQQGY - S-90 ADHESIVE

Product Identification

Product ID:S-90 ADHESIVE
MSDS Date:04/11/1989
FSC:8040
NIIN:01-046-5053
MSDS Number: BQQGY

Responsible Party
ARMSTRONG WORLD INDUSTRIES INC
W LIBERTY AND CHARLOTTE ST
LANCASTER, PA 17604
US

Emergency Phone: 717-397-0611

Info Phone: 717-397-0611 / FAX 717-396-4426

Preparer: CORP. EMPLOYM. PRACTICES

Cage: 03938

Contractor
ARMSTRONG WORLD INDUSTRIES, INC.
3209 LANCASTER, PA 17604 US

Telephone: 717-396-2328; 717-396-2935

Cage: 03938

Ingredients

VM&P NAPHTHA (LIGROINE)

CAS: 8032-32-4

RTECS: OI6180000

Fraction By Weight: 27% %

OSHA PEL 300 PPM/400 STEL

ACGIH TLV: 300 PPM; 9293


ASPHALT (PETROLEUM)

CAS: 8052-42-4

RTECS: CI9900000

Fraction By Weight: 72% %

ACGIH TLV: 5 MG/M3; (FUME);9192


POLYOLEFIN FIBER

Fraction By Weight: 1% %

Hazards

LD50 LC50 Mixture:NOT SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: IRRITATION TO THE
RESPIRATORY TRACT. EXCESSIVE SKIN CONTACT MAY CAUSE DRYING AND
CRACKING OF THE SKIN AND RESULT IN DERMATITIS. CONTACT WITH EYES
WILL CAUSE IRRITATION AND DEFATTING OF TIS SUE.
Explanation of Carcinogenicity:PRODUCT CONTAINS NO INGREDIENTS
CURRENTLY CLASSIFIED AS CARCINOGENIC BY NTP, IARC OR OSHA.
Effects of Overexposure:INHALATION: IRRITATION OF RESPIRATORY TRACT,
COUGHING, HEADACHE, DIZZINESS, DROWSINESS, NAUSEA, UNCOORDINATED
MOVEMENTS. SKIN AND EYE: EXCESSIVE SKIN CONTACT MAY CAUSE DRYING
AND CRACKING OF SKIN, AND RESULT IN DERMATITIS. CONTACT WITH EYES
WILL CAUSE IRRITATION AND DEFATTING OF TISSUE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHALATION: REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE
O2/ARTIFICIAL RESPIRATION). SEEK MEDICAL ATTENTION IF SYMPTOMS
PERSIST. SKIN: WASH WITH SOAP AND WATER. REFER TO PHYSICIAN IF
IRRITATION PERSIS TS. EYES: FLUSH IMMED WITH PLENTY OF WATER FOR AT
LEAST 15 MIN. REFER TO PHYSICIAN IF IRRITATION PERSISTS. INGESTION:
DO NOT INDUCE VOMITING. CALL POISON CONTROL CENTER.GET IMMEDIATE
MEDICAL ATTENTION

Fire Fighting

Flash Point:48F/8.89C
Lower Limits:1.0
Upper Limits:7.0
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, HALON
Fire Fighting Procedures:PROTECT FIRE FIGHTERS FROM TOXIC PRODUCTS OF
COMBUSTION BY WEARING SCBA.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS IN A FIRE MAY RUPTURE
DUE TO PRESSURE BUILD-UP; USE WATER TO COOL CONTAINERS TO PREVENT
THIS.

Accidental Release

Spill Release Procedures:REMOVE ALL SOURCE OF IGNITION. VENT AREA OF
SPILL OR LEAK; IF USING MECHANICAL VENT, MAKE SURE THAT IT IS
EXPLOSION-PROOF/DOES NOT PRESENT AN IGNITION SOURCE. USE ABSORBENT
TO ASSIST WITH PICK UP OF M ATERIAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN AREA SUITABLE FOR FLAMMABLE
MIXTURES. RECOMMENDED STORAGE TEMPERATURE IS BELOW 90F/32.2C
Other Precautions:VAPORS ARE FLAMMABLE & HEAVIER THAN AIR. PROHIBIT
SMOKING & ELIMINATE ALL OTHER SOURCES OF IGNITION, SUCH AS REGULAR
ELECTRICAL TOOLS AND APPLIANCES, MAKING SURE THAT PILOTS ON
GAS-FIRED WATER HEATERS ARE EXTINGUISHED.

Exposure Controls

Respiratory Protection:WITH ADEQUATE VENTILATION, RESPIRATORY EQUIPMENT
SHOULD NOT BE NEEDED. IF ADEQUATE VENT IS NOT AFFORDED, WEAR
NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN.
Ventilation:USE NATURAL CROSS-VENT, LOCAL PICK-UP, & GENERAL AREA(MECH)
VENT TO PREVENT ACCUMULATION OF SOLVENT VAPORS.
Protective Gloves:COTTON OR LOOP-PILE GLOVES
Eye Protection:CHEMICAL WORKER GOGGLES
Other Protective Equipment:DURING MANUFACTURING OF PRODUCT, IMPERVIOUS
GLOVES, EYE PROTECTION, AND EYE WASH FACILITIES MAY BE APPROPRIATE.
Work Hygienic Practices:WASH AFTER HANDLING. CAUTION AGAINST CONTACT
WITH THE MATERIAL.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

HCC:F2
Boiling Pt:B.P. Text:212-320F
Melt/Freeze Pt:M.P/F.P Text:N/K
Vapor Pres:10.45
Vapor Density:3.00
Spec Gravity:0.92
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK ASPHALT MASTIC WITH HYDROCARBON SOLVENT ODOR

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH TEMPERATURES, SPARKS, AND OPEN FLAMES
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE, AND
OTHER TOXIC VAPORS AND GASES THAT ARE COMMON TO THERMAL DEGRA OF
ORGANIC COMPOUNDS

Disposal

Waste Disposal Methods:INCINERATION OR OTHER METHOD APPROVED FOR
IGNITABLE WASTES IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.