BSTFY - WALNUT FLOOR & DECK ENAMEL, 3-23
- MSDS: BSTFY
- Manufacturer: PPG INDUSTRIES INC
- Product Name: WALNUT FLOOR & DECK ENAMEL, 3-23
- National Stock Number: 8010-00N042338
Product Identification
Product ID:WALNUT FLOOR & DECK ENAMEL, 3-23
MSDS Date:07/30/1992
FSC:8010
NIIN:00N042338
MSDS Number: BSTFY
Responsible Party
ALLISON PARK, PA 15101
US
Emergency Phone: 304-843-1300;800-441-9695
Info Phone: 216-572-6111;412-492-5555
Cage: 47695
Contractor
Telephone: 1-800-245-2974 (CAL HYPO)
Cage: 47695
Ingredients
MEDIUM ALIPHATIC SOLVENT NAPHTHA
CAS: 64742-88-7
Fraction By Weight: 35-40%
XYLENE; (XYLENES (O-,M-,P- ISOMERS)) (SARA III)
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: 1-2%
OSHA PEL 100 PPM;150 STEL
ACGIH TLV: 100 PPM;150 STEL
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
FILM FORMERS, RESINS, AND ADDITIVES
Fraction By Weight: 35-40%
TITANIUM DIOXIDE DUSTS FROM COATINGS IS VERY
RTECS: 9999999ZZ
SIGNIFICANT HAZ FOR MAN. EYE WATERING, HDCH, NAUS,
RTECS: 9999999ZZ
ARE TOO HIGH. REDNESS, ITCHING, BURNING SENSATION &
RTECS: 9999999ZZ
DRYNESS, ITCHING, CRACKING, BURNING, REDNESS, AND
RTECS: 9999999ZZ
CONTACT A POISON CONTROL CENTER, EMERGENCY ROOM
RTECS: 9999999ZZ
AVOID FREE FALL OF LIQUIDS IN EXCESS OF A FEW
RTECS: 9999999ZZ
TO DETERMINE TYPE OF AIRBORNE CONTAMINANTS
RTECS: 9999999ZZ
THE LOWEST SUGGESTED EXPOS LIMITS, THE LEL IN FIRE &
RTECS: 9999999ZZ
DECOMPOSITION PRODUCTS DURING WELDING OR FLAME
RTECS: 9999999ZZ
IRON OXIDE
CAS: 51274-00-1
RTECS: NO7400000
Fraction By Weight: 2-5%
OSHA PEL 10 MG/M3 (FE)
ACGIH TLV: 5 MG/M3(FE), B2
ALUMINUM SILICATE
CAS: 1335-30-4
Fraction By Weight: 10-15%
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST:HARMFUL/FATAL IF SWALLOWED.
EYE: CAUSES EYE IRRIT. SKIN:MAY CAUSE MOD SKIN IRRIT. INHAL:VAP &
SPRAY MIST MAY BE HARMFUL IF INHALED. VAP IRRIT EYES, NOSE, &
THROAT. RPTD EXPOS TO HIGH VAP CONC M AY CAUSE IRRIT OF RESP SYS &
PERM BRAIN& NERVOUS SYS DAM. INTENTIONAL MISUSE BY DELIB CONC &
INHALING (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:CONTENTS CAN BE HARMFUL OR FATAL.
CHRONIC:AVOID LONG TERM AND REPEATED CONTACT. STUDIES WITH HUMANS
INVOLVED IN THE MANUFACTURE OF THIS PIGMENT INDICATE NO INCREASED
RISK OF CANCER FROM EXPOS URE. POTENTIAL (SUPP DATA)
First Aid
First Aid:INGEST:DO NOT INDUCE VOM.EYE:FLUSH EYES IMMED W/PLENTY OF
WATER FOR AT LEAST 15 MIN. SKIN:FLUSH IMMED W/PLENTY OF WATER,
FOLLOWED BY WATERLESS HAND CLEANER & SOAP & WATER IF THE MATL
APPEARS TO ADHERE TO SKIN. INHAL:REMOVE TO FRESH AIR. APPLY ARTF
RESP & OTHER SUPPORTIVE MEASURES AS REQ. OTHER:IF INGEST, ANY TYPE
OF OVEREXP/ SYMPS OF OVEREXP OCCUR DURING/FOLLOWING THE USE OF THIS
PROD, (ING 10)
Fire Fighting
Flash Point Method:PMCC
Flash Point:102F,39C
Lower Limits:1.0
Extinguishing Media:USE NFPA CLASS B EXTING (CARBON DIOXIDE, DRY CHEM,
OR UNIVERSAL AQUEOUS FILM FORMING FOAM) DESIGNED TO EXTING(SUPP
DATA)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT
EQUIP.WATER SPRAY MAY BE INEFFECTIVE.WATER SPRAY MAY BE USED TO
COOL CLSD CNTNRS TO PRVNT PRESS BUILD- (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD.ISOLATE FROM
HEAT, ELEC EQUIP, SPARKS, & OPEN FLAMES.CLSD CNTNRS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT.DO NOT APPLY ON (SUPP DATA)
Accidental Release
Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED W/
PROPER RESP & SKIN AND EYE PROTECTION SHOULD BE PERMITTED IN THE
AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED MATL
W/SAWDUST, VERMICULITE, OR OTHER ABSORBENT MATERIAL AND PLACE INTO
CNTNR FOR DISP.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE ABOVE 120 DEGREES F.
STORE LARGE QTYS IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF
NFPA CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:IF THIS MATL IS PART OF MULTIPLE COMPONENT COATING
SYS, READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPONENT OR
COMPONENTS BEFORE BLENDING AS RESULTING MIXTURE MAY HAVE HAZ OF ALL
OF ITS PARTS. CNTNRS S HOULD BE GROUNDED WHEN POURING.(ING 11)
Exposure Controls
Respiratory Protection:OVEREXP TO VAPS MAY BE PREVENTED BY ENSURING
VENT CONTROLS, VAP EXHAUST/FRESH AIR ENTRY.NIOSH/MSHA APPRVD
(TC-23C) AIR PURIFYING/AIR SUPPLIED (TC-19C-) RESP MAY ALSO REDUCE
EXPOS.READ RESP MFR'S INSTR UCTIONS & LITERATURE CAREFULLY (ING 12)
Ventilation:PROVIDE GEN DILUTION/LOCAL EXHAUST VENT IN VOL & PATTERN TO
KEEP CONC OF INGRED LISTED IN ING SECTION BELOW (ING 13)
Protective Gloves:NITRILE RUBBER/NEOPRENE RUBBER GLOVES
Eye Protection:ANSI APPROVED CHEMICAL (OTHR PROT EQUIP)
Other Protective Equipment:IMPERMEABLE APRON. EYE PROTECTION: WORKER
GOGGLES AND FULL LENGTH FACESHIELD .
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXTING MEDIA:NFPA CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC:-UP &
POSS AUTOIGNIT/EXPLOS WHEN EXPOSED TO EXTREME HEAT. IF WATER IS
USED, FOG NOZZ ARE PREF. EXPLO HAZ:HOT SURF. TOX GASES MAY FORM
WHEN PROD IS CONTACTED BY FLAME OF HOT SURF. HAZ DECOMP:FUMES
INCL:CARBON MONOXIDE. EFTS OF OVEREXP:FOR INHAL OF (ING 6)
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:>280F,>138C
Vapor Pres:2.0
Vapor Density:HVR/AIR
Spec Gravity:1.04 (H2O=1)
Evaporation Rate & Reference:18 (BUTYL ACETATE=100)
Solubility in Water:0.2%
Appearance and Odor:VISCOUS LIQ W/AN ODOR CHARACTERISTIC OF THE
SOLVENTS LISTED IN ING SECTION.
Percent Volatiles by Volume:52.80
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZ DECOMP PROD WHEN
HEATED. WELDING, BRAZING/FLAME-CUTTING ON SURF COATED W/THIS PROD
MAY PRDCE (SUPP DATA)
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, AND
FEDERAL REGULATIONS .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.