Product ID:SATINHIDE NO LUSTER NEUTRAL BASE
MSDS Date:02/08/1994
FSC:8010
NIIN:01-316-6740
MSDS Number: BTKXQ

PPG INDUSTRIES INC

1 PPG PL
PITTSBURGH, PA 15272
US

Emergency Phone: 412-434-3131

Info Phone: 412-434-3131

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

ALUMINUM SILICATE

CAS: 1335-30-4

Fraction By Weight: 15-20% %

CALCIUM CARBONATE

CAS: 471-34-1

RTECS: FF9335000

Fraction By Weight: 15-20% %

OSHA PEL 10 MG/M3

ACGIH TLV: 10 MG/M3

HYDROTREATED HEAVY NAPHTHA

CAS: 64742-48-9

Fraction By Weight: 35-40% %

ADDITIVES INCLUDING FILM FORMERS AND RESINS

Fraction By Weight: 25-30% %

LD50 LC50 Mixture:NOT GIVEN
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:HARMFUL OR FATAL IF SWALLOWED. DRIED
FILM MAY BE HARMFULIF CHEWED OR SWALLOWED. EYE CONTACT CAUSES
IRRITATION. MAY CAUSE MODERATE SKIN IRRITATION, VAPOR AND SPRAY
MIST MAY BE HARMFUL IF INHALED. SANDI NG AND GRINDING DUSTS MAY BE
HARMFUL IFINHALED. AVOID LONG TERM AND REPEATED CONTACT.
Explanation of Carcinogenicity:THIS COMPOUND CONTAINS NO INGREDIENTS AT
CONCENTRATIONS OF 0.1% OR GREATER THAT ARE CARCINOGENS OR SUSPECT
CARCINOGENS.
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATION AND VISUAL
DISTURBANCES MAY INDICATE EXCESSIVE EYE CONTACT. DRYNESS, ITCHING,
CRACKING, BURNING, REDNESS AND SWELLING ARE CONDITIONS ASSOCIATED
WITH EXCESSIVE SKIN CONTACT.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHALATION: REMOVE FROM EXPOSURE. RESTORE BREATHING. KEEP
WARM AND QUIET. GET MEDICAL ATTENTION. SKIN: WASH AFFECTED AREA
THOROUGHLY WITH SOAP AND WATER. IF IRRITATION PERSISTS, GET MEDICAL
ATTENTION. EYES: FLUSH WITH LARGE AMOUNTS OF WATER FOR 15 MINUTES.
GET MEDICAL ATTENTION. INGESTION: DO NOT INDUCE VOMITING. GET
MEDICAL ATTENTION.

Flash Point Method:PMCC
Flash Point:120F,49C
Lower Limits:0.7 %
Upper Limits:NOT GIVEN
Extinguishing Media:CLASS B EXTINGUISHERS:CARBON DIOXIDE, DRY CHEMICAL,
FOAM
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER
SPRAY TO COOL NEARBY CONTAINERS EXPOSED TO FIRE.
Unusual Fire/Explosion Hazard:ISOLATE CONTAINERS FROM HEAT. CLOSED
CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT. DO NOT APPLY
TO HOT SURFACES. TOXIC GASES MAY FORM WHEN HEATED.

Spill Release Procedures:PROVIDE MAXIMUM VENTILATION. ONLY PERSONNEL
EQUIPPED WITH PROPER RESPIRATORY AND SKIN AND EYE PROTECTION SHOULD
BE ALLOWED IN AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED
MATERIAL WITH SAWDUS T, VERMICULITE OR OTHER ABSORBENT MATERIAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF NEPA
CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:CONTAINERS SHOULD BE GROUNDED WHEN POURING. AVOID
FREEFALL OF LIQUIDS IN EXCESS OF A FEW INCHES.

Respiratory Protection:IF VENTILATION DOES NOT MAINTAIN INHALATION
EXOSURES BELOW PEL (TLV), USE NIOSH/MSHA APPROVED RESPIRATOR AS PER
CURRENT 29 CFR 1910.134, INSTRUCTIONS/WARNINGS AND NIOSH RESPIRATOR
SELECTION.
Ventilation:LOCAL EXHAUST AND MECHANICAL (GENERAL) VENTILATION TO
MAINTAIN EXPOSURE LEVELS.
Protective Gloves:NITRILE RUBBER, NEOPRENE
Eye Protection:CHEMICAL SPLASH GOGGLES, FACE SHIELD
Other Protective Equipment:IMPERMEABLE APRON
Work Hygienic Practices:WASH WITH SOAP AND WATER AFTER HANDLING PRODUCT
AND BEFORE EATING DRINKING OR SMOKING.
Supplemental Safety and Health
IF THIS MATERIAL IS PART OF A MULTIPLE COMPONENT SYSTEM, READ THE
MATERIAL SAFETY DATA SHEETS FOR THE OTHER COMPONENTS BEFORE
BLENDING AS THE RESULTING MIXTURE MAY HAVE THE HAZARDS OF ALL ITS
PARTS.

HCC:F4
Boiling Pt:B.P. Text:100-242C
Melt/Freeze Pt:M.P/F.P Text:NOT GIVEN
Vapor Pres:0.6
Vapor Density:> 1
Spec Gravity:1.11
Evaporation Rate & Reference:12 (BUTYL ACETATE = 1)
Solubility in Water:INSOLUBLE
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF
SOLVENTS
Percent Volatiles by Volume:63 %

Stability Indicator/Materials to Avoid:YES
STRONG ALKALIS, STRONG MINERAL ACIDS, STRONG OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME TEMPERATURES, HEAT, SPARKS, OPEN
FLAMES
Hazardous Decomposition Products:CARBON MONOXIDE

Waste Disposal Methods:PREVENT WASTE FROM CONTAMINATING SURROUNDING
ENVIRONMENT. DISCARD ANY PRODUCT, RESIDUE, DISPOSAL CONTAINER OR
LINER IN ACCORDANCE WITH ALL FEDERAL, STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.