BTSGQ - MIL-P-24441/1 F-150B GREEN PRI, F-07P02A
- MSDS: BTSGQ
- Manufacturer: SEAGRAVE COATINGS CORP OF VA
- Product Name: MIL-P-24441/1 F-150B GREEN PRI, F-07P02A
- National Stock Number: 8010-00-922-1154
Product Identification
Product ID:MIL-P-24441/1 F-150B GREEN PRI, F-07P02A
MSDS Date:01/29/1992
FSC:8010
NIIN:00-922-1154
Kit Part:Y
MSDS Number: BTSGQ
Responsible Party
PORTSMOUTH, VA 23701
US
Emergency Phone: 804-488-4411/800-424-9300 CHERMTREC
Info Phone: 804-488-4411
Cage: 60163
Contractor
Telephone: 757-397-2223
Cage: 60163
Ingredients
TALC (CONTAINING ASBESTOS)
CAS: 14807-96-6
RTECS: MW2700000
Fraction By Weight: 10%
OSHA PEL 0.2 FIBERS/CC
ACGIH TLV: 0.2 FIBERS/CC; 9394
SILICONE DIOXIDE
CAS: 68855-54-9
Fraction By Weight: 15%
OSHA PEL 10 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
NAPHTHA, LIGHT AROMATIC
CAS: 64742-95-6
Fraction By Weight: 30%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM 9091
EPOXY RESIN
CAS: 25068-38-6
RTECS: KC2100000
Fraction By Weight: 50%
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN CONTACT-PRIMARY IRRITATION. EYE
CONTACT-PRIMARY IRRITATION.
Explanation of Carcinogenicity:NONE SPECIFIED BY MANUFACTURER.
Effects of Overexposure:INHALATION-IRRITATION TO THE RESPIRATORY TRACT,
HEADACHE, DIZZINESS AND NAUSEA.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.
First Aid
First Aid:INHALATION-REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT A
PHYSICIAN. SKIN CONTACT-FLUSH WITH WATER. EYE CONTACT-FLUSH
IMMEDIATELY WITH LARGE AMOUNTS OF WATER. CONSULT A PHYSICIAN.
Fire Fighting
Flash Point Method:TCC
Flash Point:114F,46C
Lower Limits:0.5
Upper Limits:6.0
Extinguishing Media:DRYC EHMICAL, CARBON DIOXIDE, FOAM.
Fire Fighting Procedures:WATER MAY BE USED TO COOL CONTAINERS TO
PREVENT PRESSURE BUILDUP AND POSSIBLE AUTOINGITION OR EXPLOSION
WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS, AND OPEN FLAMES. CLOSED CONTAINERS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:AVOID BREATHING SOLVENT VAPORS. ENSURE
ADEQUATE VENTILATION. AVOID SPARKS, FLAMES, AND ANYTHING WHICH
COULD CAUSE FIRE.
Handling
Handling and Storage Precautions:STORE IN A COLL DRT AREA WITH
VENTILATION SUITABLE FOR STORING MATERIALS SHOWN IN INGREDIENTS
SECTION.
Other Precautions:PROVIDE RESPIRATORY PROTECTION AGAINST FUMES GENERTED
DURING BURNING.
Exposure Controls
Respiratory Protection:NIOSH/OSHA APPROVED RESPIRATOR TYPES SUITABLE
FOR INGREDIENTS. APPROVED CHEMICAL/MECHANICAL FILTERS RECOMMENDED
WHEN VENTILATION IS RESTRICTED. APPROVED AIRLINE TYPE RESPIRATORS
OR HOODS RECOMMENDED I N CONFINED AREAS.
Ventilation:SUFFICIENT VENTILATION, IN VOLUME & PATTERN, SHOULD BE
PROVIDED TO KEEP AIR CONTAMINATION LEVELS BELOW TLV LIMITS.
Protective Gloves:RECOMMENDED FOR PROLONGED CONTACT.
Eye Protection:CHEMICAL GOGGLES WITH SIDE SHIELDS.
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
LIKELY. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREAS ONLY.
Supplemental Safety and Health
NSN CANCELLED ON 93244, REPLACEMENT NSN IS 8010-01-347-0916.
Chemical Properties
HCC:F3
Vapor Density:>AIR
Evaporation Rate & Reference:IS SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:PETROLEUM ODOR. TRANSLUCENT LIQUID.
Percent Volatiles by Volume:35.8
Stability
Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIALS CAN CAUSE A VIGOROUS REACTION.
Stability Condition to Avoid:THSI PRODUCT IS STABLE UNDER NORMAL
STORAGE CONDITIONS.
Hazardous Decomposition Products:AS WITH ANY OTHER ORGANIC MATERIAL,
COMBUSTION WILL PRODUCE CARBON DIOXIDE AND PROBABLY CARBON
MONOXIDE.
Conditions to Avoid Polymerization:COULD OCCUR UNDER NORMAL CONDITIONS.
CARE MUST BE EXERCISED.
Disposal
Waste Disposal Methods:SOAK LIQUIDS WITH SAWDUST OR RAGS AND REMOVE.
FLUSH WITH WATER IF POSSIBLE. AVOID SKIN CONTACT. DISPOSAL SHOULD
BE IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.