BTTDF - MIL-C-22750E B-COMPONENT, F-09P400
- MSDS: BTTDF
- Manufacturer: SEAGRAVE COATINGS CORP OF VA
- Product Name: MIL-C-22750E B-COMPONENT, F-09P400
- National Stock Number: 8010-01-350-2677
Product Identification
Product ID:MIL-C-22750E B-COMPONENT, F-09P400
MSDS Date:08/17/1993
FSC:8010
NIIN:01-350-2677
Kit Part:Y
MSDS Number: BTTDF
Responsible Party
PORTSMOUTH, VA 23701
US
Emergency Phone: 804-488-4411/800-424-9300 CHERMTREC
Info Phone: 804-488-4411
Cage: 60163
Contractor
Telephone: 757-397-2223
Cage: 60163
Ingredients
ISOPROPYL ALCOHOL (SARA III)
CAS: 67-63-0
RTECS: NT8050000
Fraction By Weight: 25%
OSHA PEL 400 PPM
ACGIH TLV: 400 PPM/500STEL;9394
VOLATILE ORGANIC CONTENT = 1.97 POUNDS/GALLON
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:BREATHING HIGH VAPOR CONCENTRATIONS
MAY PRODUCE NARCOSIS. LIQUID MAY CAUSE MINOR SKIN IRRITATION AND
DEFINITE EYE IRRITATION. CAUSES NOSE & THROAT IRRITATION.
PROLONGED/REPEATED OVEREXPOSURE TO SOLVEN TS COULD CAUSE PERMANENT
BRAIN & NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY INHALING VAPOR
MAY BE HARMFUL OR FATAL.
Explanation of Carcinogenicity:MFR LISTED NO INFORMATION ABOUT THE
CARCINOGENICITY OF THIS MATERIAL. HMIS DOES NOT EXPECT IT TO BE
CARCINOGENIC.
Medical Cond Aggravated by Exposure:NO INFORMATION GIVEN BY MFR ON
MSDS.
First Aid
First Aid:INHALED:REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT A
PHYSICIAN. SKIN:FLUSH W/WATER. EYE:FLUSH IMMEDIATELY W/LARGE
AMOUNTS OF WATER. CONSULT PHYSICIAN. INGESTED:GET IMMEDIATE MEDICAL
ATTENTION. - IF CONTACT,IMMEDIATELY FLUSH EYES/SKIN W/PLENTY OF
WATER FOR 15 MIN.WHILE REMOVING CONTAMINATED CLOTHING/SHOES. GET
IMMEDIATE MEDICAL ATTENTION. WASH CLOTHING BEFORE REUSE. DESTROY
SHOES.
Fire Fighting
Flash Point Method:SCC
Flash Point:63.0F,17.2C
Lower Limits:2%
Upper Limits:12%
Extinguishing Media:ALCOHOL(HMIS:!?), DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED GAS MASK FOR FIRE
FIGHTING PERSONNEL. WATER MAY BE USED TO COOL CONTAINERS. IF WATER
IS USED, FOG NOZZLES ARE PREFERRED.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. VAPORS
MAY MIGRATE TO IGNITION SOURCE & FLASH BACK. ISOLATE FROM
HEAT,SPARKS,ELECTRICAL EQUIPMENT, & ALL OTHER IGNITIION SOURCES
Accidental Release
Spill Release Procedures:ABSORB WITH INERT MATERIAL & DISPOSE OF IN
ACCORDANCE WITH APPLICABLE REGULATIONS OF E.P.A. AND OTHER LOCAL,
STATE & FEDERAL AUTHORITIES.
Neutralizing Agent:NO INFORMATION GIVEN BY MFR ON MSDS.
Handling
Handling and Storage Precautions:STORE AWAY FROM HEAT, SPARKS AND OPEN
FLAME. STORE IN A COOL DRY AREA W/VENTILATION SUITABLE FOR STORING
MATERIALS SHOWN IN INGREDIENTS SECTION.
Other Precautions:DO NOT BREATHE SPRAY MIST. AVOID PROLONGED SKIN
CONTACT. GROUND CONTAINERS WHILE POURING. AVOID SPONTANEOUS
COMBUSTION OF CONTAMINATED RAGS OR OTHER ORGANIC MATERIALS. EMPTY
CONTAINERS MAY RETAIN HAZA RDOUS PROPERTIES AND CAN BE DANGEROUS.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESP TYPES SUITABLE FOR
INGREDIENTS RECOMMENDED. APPROVED CHEMICAL/MECHANICAL FILTERS
RECOMMENDED WHEN VENTILATION IS RESTRICTED. WEAR APPROPRIATE
RESPIRATOR UNLESS AIR MONITORING RECORDS EXPOSURES BELOW
APPLICABLE LIMIT
Ventilation:PROVIDE SUFFICIENT VENTILATION, IN VOLUME & PATTERN, TO
KEEP AIR CONTAMINENTS BELOW CURRENT APPLICABLE PEL/TLV.
Protective Gloves:CHEMICAL RESISTANT OR RUBBER
Eye Protection:CHEMICAL GOGGLES OR FACE SHIELD
Other Protective Equipment:AS REQUIRED TO AVOID WETTING CLOTHING. USE
PROTECTIVE CREAMS WHERE SKIN CONTACT LIKELY. EYE WASH & SAFETY
SHOWER.
Work Hygienic Practices:AVOID CONTACT WITH SKIN, EYES, CLOTHING. WASH
THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health
NONE
Chemical Properties
HCC:F4
NRC/State Lic Num:NONE
Boiling Pt:B.P. Text:>180F,>82C
Vapor Density:HVR/AIR
Evaporation Rate & Reference:FASTER THAN ETHER
Solubility in Water:INSOLUBLE
Percent Volatiles by Volume:24.5
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:EXCESSIVE HEAT, SPARKS, OR OPEN FLAME
Hazardous Decomposition Products:NO INFORMATION GIVEN BY MFR ON MSDS.
Conditions to Avoid Polymerization:WILL NOT OCCUR UNDER NORMAL
CONDITIONS.
Disposal
Waste Disposal Methods:PLACE IN CLOSED CONTAINERS. DISPOSE OF PRODUCT
I/A/W FEDERAL, STATE, COUNTY & LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.