BTWJM - MIL-C-22750E GRAY 36231 PRGANIC COATING, F-09P335

Product Identification

Product ID:MIL-C-22750E GRAY 36231 PRGANIC COATING, F-09P335
MSDS Date:08/23/1993
FSC:8010
NIIN:01-316-2551
Kit Part:Y
MSDS Number: BTWJM

Responsible Party
SEAGRAVE COATINGS CORP OF VIRGINIA
PORTSMOUTH, VA 23701
US

Emergency Phone: 804-488-4411

Info Phone: 804-488-4411

Cage: 60163

Contractor
SHERWIN-WILLIAMS, SEAGUARD
PORTSMOUTH, VA 23704 US

Telephone: 757-397-2223

Cage: 60163

Ingredients

TITANIUM DIOXIDE (VAPOR PRESSURE 0.0 MM HG @ 20C)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10%

ACGIH TLV: 10 MG/M3


MAGNESIUM ALUMINUM SILICATE (VAPOR PRESSURE 0.0 MM HG @

CAS: 1318-59-8

Fraction By Weight: 30%

ACGIH TLV: 10 MG/M3


SILICON DIOXIDE (VAPOR PRESSURE 0.0 MM HG @ 20C)

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 20%

ACGIH TLV: 0.1 MG/M3


DIATOMACEOUS EARTH (VAPOR PRESSURE 0.0 MM HG @ 20C)

CAS: 68855-54-9

Fraction By Weight: 5%

ACGIH TLV: 10 MG/M3


AROMATIC 150 (VAPOR PRESSURE 1.0 MM HG @ 20C)

CAS: 64742-94-5

RTECS: SE7546500

Fraction By Weight: 5%

ACGIH TLV: 10 PPM; STEL 15 PPM


METHYL ETHYL KETONE (SARA III) (VAPOR PRESSURE 70.0 MM HG @

CAS: 878-93-3

RTECS: EL6475000

Fraction By Weight: 10%

ACGIH TLV: 200 PPM;STEL 300 PPM


METHYL N-AMYL KETONE (2-HEPTANONE) (VAPOR PRESSURE 2.4 MM

CAS: 110-43-0

RTECS: MJ5075000

Fraction By Weight: 10%

ACGIH TLV: 50 PPM


2.58 LB/GAL; 309 GR/LTR

RTECS: 9999999VO

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:BREATHING OF HIGH VAPOR CONCENTRATIONS
MAY PRODUCE NARCOSIS. LIQUID MAY CAUSE MINOR SKIN IRRITATION & EYE
IRRITATION. CAUSES EYE IRRTATION. CAUSE SKIN IRRITATION. REPEATED &
PROLONGED OVEREXPOSURE TO SOLVENTS COULD CAUSE PERMANENT BRAIN &
NERVOUS SYSTEM DAMAGE. CONCENTRATING & INHALING CONTENTS MAY BE
HARMFUL/FATAL.
Explanation of Carcinogenicity:CONTAINS SILICA WHICH CAN CAUSE CANCER
(RISK OF CANCER DEPENDS ON DURATION AND LEVEL OF EXPOSURE).
Medical Cond Aggravated by Exposure:UNPROTECTED EXPOSURE TO DUST LEVELS
IN EXCESS OF THE PEL MAY CAUSE LUNG DISEASE (SILICOSIS).

First Aid

First Aid:INHALATION:REMOVE TO FRESH AIR,RESTORE BREATHING. CONSULT
PHYSICIAN. SKIN CONTACT:FLUSH WITH WATER. EYE CONTACT:FLUSH
IMMEDIATELY WITH LARGE AMOUNTS OF WATER. CONSULT PHYSICIAN. FIRST
AID:IN CASE OF E YE CONTACT, FLUSH IMMEDIATELY WITH PLENTY OF WATER
FOR AT LEAST 15 MINS & GET IMMEDIATE MEDICAL ATTENTION; FOR SKIN
WASH THOROUGHLY WITH SOAP & WATER. IF SWALLOWED, GET MEDICAL
ATTENTION IMMEDIATELY.

Fire Fighting

Flash Point Method:SCC
Flash Point:24.0F,-4.4C
Lower Limits:1.1
Upper Limits:17.8
Extinguishing Media:WATER FOG, DRY CHEMICAL, ALCOHOL FOAM, CARBON
DIOXIDE
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED GAS MASK FOR FIRE
FIGHTING PERSONNEL. WATER MAY BE USED TO COOL CONTAINERS. IF WATER
IS USED FOG NOZZLES ARE PREFERRED.
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. VAPORS
MAY MIGRATE TO IGNITION SOURCES AND CAUSE FLASH FIRE. ISOLATE FROM
HEAT & IGNITION SOURCES. FLAMMABLE LIQUID & VAPOR.

Accidental Release

Spill Release Procedures:IN CASE OF SPILLAGE ABSORB WITH INERT MATERIAL
AND DISPOSE OF IN ACCORDANCE WITH REGULATIONS OF EPA AND OTHER
LOCAL, STATE, AND FEDERAL AUTHORITIES.

Handling

Handling and Storage Precautions:STORE AWAY FROM HEAT, SPARKS, OPEN
FLAME. AVOID PROLONGED SKIN CONTACT. DON'T BREATHE SPRAY MIST.
GROUND CONTAINERS WHILE POURING.
Other Precautions:STORE IN COOL DRY AREA WITH VENTILATION SUITABLE FOR
STORING MATERIALS SHOWN IN INGREDIENTS. AVOID SPONTANEOUS
COMBUSTION OF CONTAMINATED RAGS OR OTHER ORGANIC MATERIALS. EMPTY
CONTAINERS MAY RETAIN H AZARDOUS PROPERTIES & CAN BE DANGEROUS.

Exposure Controls

Respiratory Protection:NIOSH/OSHA RESPIRATOR SUITABLE FOR MATERIALS IN
INGREDIENTS.APPROVED CHEMICAL/MECHANICAL FILTERS RECOMMENDED WHEN
VENT RESTRICTED.DON'T BREATH (DUST,VAPOR).WEAR RSPRTR DURING/AFTER
APPLICATION UNLESS BELOW TLV.FOLLOW MFR DIRECTIONS FOR USE.
Ventilation:PROVIDE SUFFICIENT VENTILATION, IN VOLUME & PATTERN, TO
KEEP AIR CONTAM BELOW PEL/TLV. FOLLOW RESPIRATOR MFR DIRECTIONS.
Protective Gloves:CHEM RESISTANT PLASTIC OR RUBBER
Eye Protection:CHEMICAL GOGGLES W/SIDE SHIELD/FACE SHLD
Other Protective Equipment:AS REQUIRED TO AVOID WETTING CLOTHES. USE
PROTECTIVE CREAMS WHERE SKIN CONTACT LIKELY. EYE BATH AND SAFETY
SHOWER.
Work Hygienic Practices:AVOID CONTACT WITH EYES, SKIN, AND CLOTHING.
WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health

Chemical Properties

Boiling Pt:B.P. Text:175 TO 401F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:LIQUID, SOLVENT ODOR
Percent Volatiles by Volume:38.0

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:EXCESSIVE HEAT, SPARKS, OR OPEN FLAME

Disposal

Waste Disposal Methods:PLACE IN CLOSED CONTAINERS. DISPOSE OF PRODUCT
IN ACCORDANCE WITH LOCAL, COUNTY, STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.