Product ID:N-5424 WHITE SI ALKYD
MSDS Date:02/25/1994
FSC:8010
NIIN:00-145-0164
MSDS Number: BTZVL

NILES CHEMICAL PAINT CO

225 FORT STREET
NILES, MI 49120
US

Emergency Phone: 219-236-5856

Info Phone: 616-683-3377

Preparer: MIKE LICHATOWICH

Cage: 02388

NILES CHEMICAL PAINT

307 NILES, MI 49120 US

Telephone: 616-683-3377/219-236-5856

Cage: 02388

MINERAL SPIRITS (VAPOR PRESSURE 0.0 MM @ 20C)

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 32%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

SILICONE ALKYD

Fraction By Weight: 27%

COBALT COMPOUNDS (AS CO) (SARA III)

CAS: 7440-48-4

RTECS: GF8750000

Fraction By Weight: <1%

OSHA PEL 0.1 MG/M3

ACGIH TLV: 2 MG/M3

MANGANESE COMPOUNDS (AS MN) (SARA III)

CAS: 7439-96-5

RTECS: OO9275000

Fraction By Weight: <1%

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3

3.48 LBS/GAL

RTECS: 9999999VO

PROPRIETARY INGREDIENTS (MFR STATES UNIDENTIFIED

Fraction By Weight: BALANCE

Routes of Entry: Inhalation:YES Skin:UNKNOWN Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: SEVERE
IRRITATION,TEARING,REDNESS,BLURRED VISION.
SKIN:REDNESS,IRRITATION,DEFATTING (DERMATITIS). INHAL: NASAL & RESP
IRRITATION, CNS DEPRESSION
(DIZZINESS,DROWSINESS,WEAKNESS,FATIGUE,CONFUSION)
NAUSEA,HEADACHE,VERTIGO,UNCONSCIOUSNESS,ASPHYXIATION. INGEST: GI
IRRITATION, ABDOMINAL PAIN, NAUSEA,VOMITING, DIARRHEA.
Effects of Overexposure:TARGET ORGANS: SKIN, EYES, RESPIRATORY SYSTEM,
CNS.
Medical Cond Aggravated by Exposure:NONE KN0WN

First Aid:GET IMMED MED AID. INHAL:MOVE TO FRESH AIR IMMED.IF NO
BREATH,GIVE ARTIF RESP. SKIN:IMMED FLUSH W/WATER.IF PENETRATES
CLOTHES,IMMED REMOVE CONTAM CLOTH & FLUSH SKIN W/WATER.WASH CLOTHES
& DECONTAM SHO ES BEFORE REUSE. EYE:IMMED FLUSH W/WATER 15 MIN,LIFT
EYELIDS.DON'T WEAR CONTACT WHEN WORKING W/MAT'L.INGEST:DRINK 1-2
GLASSES WATER.DON'T INDUCE VOMITING.SEE DR/POISON CNTRL CTR IMMED.
TREAT SYMPTOMS.

Flash Point Method:TCC
Flash Point:107F,42C
Lower Limits:0.0
Upper Limits:0.8
Extinguishing Media:DRY CHEMICAL, FOAM, CO2
Fire Fighting Procedures:WEAR SCBA W/FULL FACPIECE (POSITIVE PRESSURE
MODE) & FULL PROTECT CLOTH. USE WATER TO COOL CLOSED CNTNR TO
PREVENT PRESSURE BLDUP/AUTO IGNIT/EXPLOSION W/HEAT.
Unusual Fire/Explosion Hazard:KEEP CNTNR CLSD.VAPOR HEAVIER THAN
AIR,TRAVEL ON GRND TO IGNIT.NO HEAT/IGNIT.CLSD CNTNR EXPLODE
W/HEAT.APP TO HOT SRFC REQ SPCL PRECAUTION.DECOMP PROD--HLTH HZD

Spill Release Procedures:ELIMINATE IGNITION SOURCES. MINIMIZE BREATHING
OF VAPORS. AVOID SKIN CONTACT. SMALL SPILL: ABSORB W/INERT MAT'L.
SHOVEL RECLAIMED LIQ & ABSORBENT TO RECOVERY/SALVAGE DRUMS. LRG
SPILL:DIKE. RECLAIM TO RECOVERY/SALVAGE DRUMS/TANK TRUCK FOR
DISPOSAL.

Handling and Storage Precautions:AVOID STORAGE IN HIGH TEMPERATURE
AREAS OR NEAR FIRE OR OPEN FLAME. KEEP CONTAINERS CLOSED WHEN NOT
IN USE. AVOID ROUGH HANDLING.
Other Precautions:CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EMPTY. DO NOT WELD OR FLAME CUT ON EMPTY DRUMS.

Respiratory Protection:WEAR APPROPRIATE (5C-23C-75) FITTED 1/2 MASK OR
FULL FACEPIECE RSPRTR (NIOSH/MSHA) DURING & AFTER APPLICATION
UNLESS AIR MONITORING DEMONSTRATES VAPOR LEVELS ARE BELOW
APPLICABLE LIMITS. FOLLOW RESPIR ATOR MANUFACTURER'S DIRECTIONS FOR
USE.
Ventilation:TO KEEP AIR CONCENTRATION BELOW TLV/PEL. REMOVE DECOMP
PRODUCTS (WELDING,FLAME CUTTING).VENT VAPORS EMMITTED ON BAKING.
Protective Gloves:NITRILE OR VITON GLOVES AS NEEDED
Eye Protection:CHEM GOGGLES,SAFETY GLASSES,FACE SHIELD
Other Protective Equipment:WEAR CHEMICAL RESISTANT (NITRILE OR VITON)
GLOVES AND CLOTHING AS NEEDED TO PREVENT SKIN CONTACT.
Work Hygienic Practices:WASH PROMPTLY WHEN SKIN BECOMES CONTAMINATED
AND BEFORE EATING, SMOKING, OR USING RESTROOM.
Supplemental Safety and Health
REMOVE ANY CLOTHING THAT BECOMES WET (TO AVOID FLAMMABILITY HAZARD) AND
WASH BEFORE REUSE.

Boiling Pt:B.P. Text:278 TO 398F
Vapor Density:> AIR
Spec Gravity:1.259
Viscosity:67 - 77 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT
Appearance and Odor:LIQUID, ODOR OF SOLVENTS
Percent Volatiles by Volume:54.13
Corrosion Rate:MINIMAL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS
Hazardous Decomposition Products:CAN PRODUCE CARBON MONOXIDE AND/OR
CARBON DIOXIDE.
Conditions to Avoid Polymerization:HIGH TEMPERATURES, SHOCK FROM
DROPPING

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL,
STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.